1. In open channels of constant slope and constant cross section, the liquid accelerates until the head loss due to frictional effects equals the elevation drop.

Q: . A mixture of 14.7 psia and 68°F that is 30% by weight CO₂ and 70% by weight N₂ has a partial…

A:

Q: Q.3] Find the reactions at A and B for the structure shown in the figure. 2 kN/m 20kN 2m fo lem 2m P…

A:

Q: the equivalent spring constant for below if the constant spring is 80 ?N/m //// 12 ////

A: Given   Spring constant, k = 80 N/m Find  Equivalent spring constant, keq

Q: Ms Png works on a piston-cylinder system which contains 0.05 m3 of nitrogen gas initially at 200…

A:

Q: 6. (5) A packaged product is dropped from 28 inches, impacts the floor, and rebounds to a height of…

A:

Q: A 45° Water B C TIT A curved wall ABC in a basin, with a width of 5 m into the plane of the paper,…

A: Solution is attached below:

Q: (f) s+2 85-384 +2s³

A: f(s)= s+2s5-3s4+2s3

Q: 15.14 Figure (a) shows a boat that is sailing in the y-direction at 5 km/h with the wind vane…

A:

Q: Dodecane is burned at constant pressure with 120% excess air. What is the actual air fuel ratio for…

A: In an engine when combustion process takes place, then the ratio between the mass ratio of the air…

Q: A flashed steam geothermal powerplant is located where underground hot water is available as…

A:

Q: Following data relates to cam and follower mechanism, find out speed of cam in rpm and max. Usable…

A: We have the following information about the cam and follower system, and we need to calculate the…

Q: Question: A particle moves in the x-y plane with an x-component of velocity in meter per second…

A: Given data  Vx = 4√t ay= 4e^t When t = 4, y=10, x=4 and Vx = 10. Find the equation of path of the…

Q: Looking at the x direction, provide the front view, top view, and right-side view using the meter…

A: According to the details provided in the question, we need to draw three projection views.

Q: Convert the [100] and [111] directions into the four-index Miller-Bravais scheme for hexagonal unit…

A:

Q: physics students have measured the kinetic friction coefficient between Block C and the ground to be…

A:

Q: Draw the sectional view.

A: According the given view we need to draw the isometric view. i am using solid works to draw…

Q: Discuss briefly the fuel injection system and carburetor system for SI-internal combustion engine.

A:

Q: Find discharge Area=2 m2 Flow velocity=0.1 m/s

A: Given data : Area is denoted by A Flow velocity is denoted by V   Find : Discharge

Q: Calculate the power delivered by the oil to the fluid motor shown in the following figure if the…

A:

Q: . A uniform rod AB has length of 60m and mass of 12kg. A weight of mass 8kg is attached at A and a…

A:

Q: Looking at the x direction, provide the front view, top view, and right-side view using the meter…

A: Find Front view, top view, and right side view with dimensions.

Q: Complete the table of values below. Then, sketch the graph of r = 2-3 cos in polar coordinate system…

A: Given r=2-3cosθ To find Plot the value of r with angle

Q: No. Load P(KN) 1 0 2 38 3 76.2 4 92.7 5 107 6 149 7 160.6 8 102 9 100.7 10 98.33 11 155 12 142 13…

A: The table is made in excel. Engineering Stress = σengg=LoadArea Engineering Strain = εengg=δLL0

Q: Which of the following gives the location of its centroid with respect to the x-axis?

A: Schematic diagram of the given figure is The figure is consists of three figure:- a) Part 1:- A…

Q: Rd in the figure shown below

A: we will use equilibrium equation

Q: 5. During the flight, the air speed of a turbojet engine is 250 m/s. The ambient air temperature is…

A:

Q: a 6 meter long rope segment contains 8 complete waves (8 ridges and 8 valleys) has a mass of 350g.…

A:

Q: A cap screw, ¾ in.-10-UNC-2, with a hexagonal head that is 9/16 in. thick, carries a tensile load of…

A:

Q: 3) Hot forming temperature zone is limited to only 75% of the work piece absolute temperature and…

A: Ans. 3) The excess temperature may cause the extra grain growth in the material which will alter the…

Q: Attempt all questions. A simple frame structure is simply supported by a roller at A and a pin at B…

A:

Q: A gaseous mixture of methane, ethane and propane has their percent volume of 38%, 42% and 20%…

A: The mass percentage of methane in the mixture: 22.125 %

Q: Calculate the thermal efficiency of an air standard limited pressure cycle with a compression ratio…

A: Given:r=22P1=100 KPaT1=27° =300 KP2=P3=13 MPaQi=1800 KJ/Kg

Q: Q.2] Find the reactions at point A for the structure shown in the figure. zkN/m A M 10m 5m 20 KN

A:

Q: A projectile is fired with an initial velocity of vo (m/sec) upward at an angle (0) with the…

A: It is very basic derivations of projectile motion range and maximum height.

Q: Determine the work of the force F = (6s² ), where s is the displacement in meter, of the figure…

A:

Q: The equation of a wave in the international system SI, which propagates by a string is given by the…

A: Given    Equation of wave, y(x,t)=0.08cos[2π(2x-4t)] Find   Velocity at x = 2 m  and t = 5 s

Q: 15 A specific fluid is kept in a cubic container. The container weighs 10 N when it is empty. When…

A: Given data Weight of container when it is empty = 10 N Weight of container when completely filled by…

Q: Thermal conductivities and viscosities of saturated refrigerant liquid and vapor: R12 t (°C)…

A: Given data: The outside diameter of the tubes is d=19 mm=0.019 m. The condensing temperature for…

Q: 12 1 Ti Pi P3 V₁ V₂ The graph to the right shows a thermodynamic process where a gas is heated at…

A:

Q: A pipe 12 mmm diameter with a velocity of 0.50 m/s is attached by a nozzle at the end having a…

A: Equating the volumetric flow rate

Q: ompute the heat conducted in KW through a sheet of plate glass, k = 0.025 Cal/s-cm-ºC, which is 3.5…

A: Given   Thermal conductivity, k = 0.025 Cal/s-cm-ºC                                         = 10.46…

Q: A bicycle and rider is mass 125 kg are travelling at a speed of 10 km/hr. The rider applies a break…

A: Given: Mass of the bicycle and rider→m=125 Kg Speed of the bicycle→U=10 Km/hr=2.77 m/s Diameter of…

Q: at point a in pipeline carrying water, the diameter is 1m, the pressure is 98kPa and the velocity is…

A: Given:d1=1 mP1=98 kPav1=1 m/sz1=0 md2=0.5 mP2=20 KPa

Q: A) Find the internal forces and moments acting at a-a. 300 mm 300 mm 600 mm B D A a a 200 mm -400 mm…

A: find  the internal forces and moments at section a-a.

Q: 152 x 152 x 23 UC Frame Beam Diagram 28.2KN Self Load 805N 28.2KN 2.0m Ra 75 3.5m Pulley and Shaft…

A: find the reactions at the supports.

Q: The aircraft is flying at a velocity of 50 m/s, at an altitude of 4500 m. Determine the lift/span…

A: Given data Velocity = 50m/sec Altitude =4500m Chord=3m Span=13 m Angle of attack = 4 deg, Find the…

Q: Dodecane is burned at constant pressure with 120% excess air. What is the actual air fuel ratio for…

A:

Q: 3-Determine the maximum vertical force P that can be applied to the bell crank so that the average…

A:

Q: The diver has a mass of 75 kg and is standing motionless at the end of a diving board shown in…

A: Given data, Mass of the driver, m = 75 kg So, weight of the driver is W=mgW=75×9.81W=735.75 N Young…

Q: Calculate the thermal efficiency of an air standard limited pressure cycle with a compression ratio…

A: Given    Compression ratio, r = 22               Heat input, Q = 1800 kJ/kg Find    Thermal…