1.1-5 K30va. what is tue T CTime constant) ?b. How longwill it take for the capacutor TOrtach s0% op charge?C. What is tne voltage of capa citor apter1 seconds?d. How many tíme constants will it take for thesoltage to reach 23 v?C. Gweng that the capacitor is fully changed, howwill it take por it to be 20% ?long120v+ BFwhat is the. T ?b. what is the voltage capacitor apter 10 sec?a.C. How many time constants will it take for TueVo Itage to reach 80 v.?d. Given that the capaator is Fully charged, howtime constants will it be to reaumanyGOV!

“Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Answered: 1. S 1-5 KA 30v a. what is , the T…

1. S 1-5 KA 30v a. what is , the T CTime constant) ? b. How long will it take for the capacutor TO reach 50% op charge? C. W hat is the voltage of capacitor apter 1seconds?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 2PA: You are an electrician working in an industrial plant. You discover that the problem with a certain...

See similar textbooks

Related questions

Q: 2. Find the Total Inductance in the Circuit. 2 mH 4 mH 5 mH 2 mH 6 mH L7 12 mH 4 mH QB 2 mH 3 mH 2 m...

Q: Three point charges are located at the corners of a square of side L equal to 30 cm. The charge Q1 o...

A: The solution is given below.

Q: R1 has a 0.5A current through it. R1=1 E1=2 R2=5 E2=4 R3=2 E3=2 R4=1 Find the current through R2, R3...

Q: 9. An electric field of 3.6 x 10° N/C passes through an area of 4.1 cm? perpendicular to the surface...

A: In this question, If electric field is 3.6× 10-3 N/C Area = 4.1cm2 Find the electric flux =?

Q: 3. Refer to the graphics appendix. What current is most near the current through R1? .200 A .046 A ....

Q: Given the circuit below. i, (t) = v210 cos(377t). Give your answer in four decimal places if it is n...

A: In this question, What is type of the system? What is impedance? And value of X? What is rms curr...

Q: Question # 03: Apply the knowledge gained from the DC biasing of E-MOSFET to select appropriate valu...

A: Here, we have given a circuit, for which we have to determine the values of VDD and RD. We will cons...

Q: R1 R2 R3 10 V1 10 V2 2.

A: Solution:- from the above figure Apply KCL on Node , V1-V2R1 +0-V2R2=I10-43+0-42 =II=0

Q: State the frequency of the 7th harmonic of a 2KHZ sine wave? O i) 14Khz O i) 9KHZ O i) 5KHZ O iv) 2K...

Q: 10V 3V 50 20 |

Q: T (s) = s+2 s2+9

A: "As per our guidelines, we are supposed to answer only three subparts. Kindly repost the other subpa...

Q: What is the speed of a 100 Kw, 230 Volts , 3 phase , 4 pole , 60 Hz , alternator 1800 RPM 1700 RPM 1...

A: Consider the formula for the speed is, N=120fp Here, f is the frequency and p is pole.

Q: An uncharged 10 microF capacitor is charged by a constantcurrent of 1 mA. Find the voltage across th...

Q: 2 A signal consists of a fundamental frequency of 500 Hz, and the lowest five harmonics: 1000 Hz, 15...

Q: What is the value of a C103 ceramic disk capacitor? (circle all that apply) 10 nF O 10 mF 10,000 pF ...

A: Here, the number of the capacitor is C103

Q: A hydroelectric power station is supplied from a reservoir having an area of 50 km2 and a head of 5...

A: Here, we have provided some information about the hydroelectric power station, The area, head and t...

Q: V3 A R1 R3 R5 10 V1 12 R2 R4 V2 20 Reference Node 12

A: The given circuit diagram is shown below:

Q: 1. In your circuit generators, measure: I, Vi, V2, V3, I1, I2, I3 2. Theoretically, calculate: I, Vi...

Q: (a) As shown in Figure 1(a), a power transmission line carries current 180 A from a 6000 V generator...

Q: CE amplifier uses a BJT with B = 100 biased at IC = 0.5 mA and has a collector resistance RC = 15 kN...

Q: Vs f = 150 Hz C 0.1 μF

Q: What is the expected voltage measurement across C4 if VDc = 9V? C, C2 C3 Vpc H

Q: A person draws 3 balls in succession from a box containing 5 red balls, 6 yellow balls and 7 green b...

A: The solution is given below

Q: Find the total Capacitance in the circuit. A 4 µF 6 pF 5 µF * 8 uF :2 pF Ст — *6 µF B 3 uF 10 uF 6uF

Q: a) Recommend a wireless technology for the case where you need to provide seamless highspeed connect...

Q: Given vectors A = 2a, + 4a, + 10a, and B — 5а, + ag — 3а,, find The angle between A and B at P Р(), ...

A: This problem comes under electrostatics . It is based on the basic laws of vector . With the help of...

Q: Problev 4. System Properties State whether the following systems are linear or nonlinear, time invar...

Q: Q1/(b) Calculate cutoff frequency high for the cct. below at R1=R2= 10K2 and C1=C2=0.002 µF

A: CUT OFF FREQUENCY:- fH = 12πR2C2R2 = 10 Kohm =10X 103ohmC2 = 0.002 μF = 0.002X10-6F

Q: What are the main differences between a capacitor and an inductor? Discuss FIVE of them.

A: The voltage current relationship of an inductor is vL = L diLdt The voltage current relationship of ...

Q: 40Ω 20Ω 50Ω 20V 30Ω 10Ω

Q: A bacterial population Y is known to have a rate of growth proportional to Y itself. If between 11am...

Q: Magnetic fields are characterized by the existence of a detectable magnetic force at every point in ...

A: According to the question, Magnetic fields are characterized by the existence of a detectable magnet...

Q: 1. Refer to the graphics appendix. What resistance is most near the total resistance of the circuit?

A: This question belongs to circuit theory . It is based on the concept of calculation of total resista...

Q: The hysteresis loop of the core material of a transformer should have (a) a large area (b) a small a...

A: When a transformer is in use, its core is taken up by many complete magnetization cycles. During eac...

Q: A coil that is wound around an iron bar with 5 m length, and are of 2.5 m², creates a field intensit...

Q: For the combination resistor shown below, calculate the equivalent resistance for the entire circuit...

Q: The input current to a 220v, compound motor at no load is 6 A. The shunt field circuit resistance is...

Q: A 4-pole, 500 V d.c. shunt motor has 720 wave-connected conductors on its armature. The full-load ar...

A: We are authorized to answer one question at a time since you have not mentioned which question you a...

Q: A 6.6 kV, 6 MVA, Y-connected, 3φ alternator has an effective ac resistance of 0.436Ω between termina...

Q: Give/Enumerate other semiconductor materials except Silicon and Germanium? Explain why they are not ...

A: There are different types of semiconductors. The semiconductor materials are used to construct the e...

Q: A single phase circuit is supplied from a 220 volts 60 Hz source draws 2000 watts of power and 10 am...

A: Power drawn by single phase circuit = voltage ×current ×power factor. Given power drawn from the so...

Q: 13 A R1 R3 1k 2k2 V1 V2 R2 V 12 +, 2k2 12V 24V 1) +1

Q: Question 1 R1 R2 What is the equivalent resistance of the circuit shown above if R, = 9.0 Q and R2 =...

Q: 5. For the given circuit below, determine (a) the voltage across each capacitor and (b) the energy s...

Q: In a step-down converter, consider all components to be ideal. Let v, V, be held constant at 5 by co...

Q: Show the schematic of a LUT (using a multiplexer0 which implements the logic for a 3-input AND gate.

Q: A CE amplifier uses a BJT with B = 100 biased IC = 0.5 mA and has a collector resistance RC = 15 kN ...

A: Please refer the attached images for the complete answer..

Q: A receiver consists of an antenna with a noise temperature equal to 120 K that feeds an attenuator w...

A: The temperature of a resistance that would produce the same noise power at the output of an ideal (n...

Q: Deep-sea exploration is a challenging task in a petroleum industry. High pressure, huge area and une...

Q: There is a cylindrical capacitor that is constructed from inner and outer copper shells and a tough ...

A: Voltage rating of Capacitor A maximum operating voltage or working voltage. The capacitor is meant t...

Question

1.
1-5 K
30v
a. what is tue T CTime constant) ?
b. How long
will it take for the capacutor TO
rtach s0% op charge?
C. What is tne voltage of capa citor apter
1 seconds?
d. How many tíme constants will it take for the
soltage to reach 23 v?
C. Gweng that the capacitor is fully changed, how
will it take por it to be 20% ?
long
120v
+ BF
what is the. T ?
b. what is the voltage capacitor apter 10 sec?
a.
C. How many time constants will it take for Tue
Vo Itage to reach 80 v.?
d. Given that the capaator is Fully charged, how
time constants will it be to reau
many
GOV!

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
For residential water heaters, the Consumer Product Safety Commission suggests a maximum temperature setting of ___________ F (_____________ C). Some states have laws stating a maximum temperature setting of ____________ F (________________ C).
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
Can current flow through a capacitor?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?