1. Some geophysical (dynamic) tests were performed in the field on a rock layer, and the velocity of primary and shear waves were measured (as shown in following table): Velocity of shear wave Velocity of primary wave 1000 m/s 1850 m/s If the density of the rock is 2600 kg/m³, calculate the Young modulus and Poisson's

1. Some geophysical (dynamic) tests were performed in the field on a rock layer, and the velocity of primary and shear waves were measured (as shown in following table): Velocity of shear wave Velocity of primary wave 1000 m/s 1850 m/s If the density of the rock is 2600 kg/m³, calculate the Young modulus and Poisson's

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter3: Natural Soil Deposits And Subsoil Exploration

Section: Chapter Questions

Problem 3.22P

See similar textbooks

Similar questions

The P-wave velocity in a soil is 105 m/s. AssumingPoisson’s ratio to be 0.32, calculate the modulus of elasticityof the soil. Assume that the unit weight of soil is 18 kN/m3.
Determine the magnitude (Mw) of an earthquake resulting from a fault having a rapture length of 175km and width of 12km .The slip was found to be 2m .Take shear modulus of the rock is 3*10^10N/m^2 .Also compute its energy with a magnitude : 6 event
In the recent earthquake, the velocity of P-waves is 3.12km/s while it traveled on the soil whose Poisson's ratio of the medium was 0.42 and the shear modulus is 1.6GPa. Determine the density of the soil and time lag if the focal distance is 250km.
A reservoir-rock sample has a porosity of 0. 18 measured at 14.7 psis. The rock compressibility is0.77 X 10 5psi *.What would the rock porosity be at 2,000 and at 3,000 psis? Plot the relationship be tween ¢ and p in a pressure range of 14.7 to 5,000 psis
There is a scour in front a vertical wall due to wave erosion. Assuming perfect reflection and shallow water conditions, determine the water depth under the node nearest the wall, if wave height and period are known at the wall. Assume an equilibrium scour depth such that maximum horizontal water particle velocity at the bottom is ≤ 3 m/s.
What is the intensity of active earth pressure at a depth of 10.0 m in dry sand with an angle of shearing resistance of 30 degrees and unit weight of 18kN /m ^ 3 ?
A moment magnitude of 4.8 produced a rupture length of 1550km and rupture width of 320km. Determine the slip distance in meters.
reservior rock and fluid properties
A moist rock mass is characterized by the following parameters: joint water pressure is nil; the point load index 3 MPa; the joint spacing = 0.5 m; and = RQD 55%. Prepare a table of rock mass rating versus joint condition = using the terminology of Table 2.16 for the former and Table 2.13 for the latter. ( you can find the tables in goodman book about rock mechanics)
At a given site 10m clay layer of shear wave velocity(Vs) = 450 m/s and density 1600 kg/m3 is lying over a deep weathered rock layer shear wave velocity(Vs) = 750 m/s and density is 2240 kg/m3. A harmonic shear wave which causes displacement of the form Ae^(iwt - kx) is propagating vertically from the rock layer to the clay layer. If the stress amplitude of the incident wave is 200 kPa and frequency is 2 Hz, determine the stress and displacement amplitudes of the reflected and transmitted waves at the boundary. 2
Two vanes A and B, with length-to-diameter ratios of 3 and 1 respectively, are each used to make a test at the depth in a clay layer. Both vanes have a diameter of 50 mm and the torque values measured were 95 N-m for A and 45 N-m for B. Find the values of undrained shear strength on the horizontal and vertical planes at this depth. Explain why undrained strength in clays may vary with direction.
The upstream pressure on a rock sample is 0.113MPa and the downstream pressure is 0.1MPa. Under this pressure difference, a gas with the viscosity of 0.018 mPa·s flows through the rock sample. The diameter of this sample is 2.5cm, its length is 2.8cm. The volumetric flow rate at the outlet face is 0.514cm3/s. Calculate the gas permeability of this rock sample.