1. Take a look at the phasor diagram. The table shows the resistance R. capacitive reactanceXC, and inductive reactance XL values for three circuits.Circuit R (K2) Xc (k) X₁ (k)I551II458III337• Matching type. Which of the circuits matches the phasor diagram?A. I and III onlyB. II and III onlyC. I and II onlyD. III only• What is the impedance of circuit II?A. 3[kQ2]B. 5[k]C. 7[k]D. 9[12]

Determine the impedance of circuit I. Determine the impedance of circuit II. Determine the…

1. Take a look at the phasor diagram. The table shows the resistance R. capacitive reactance XC, and inductive reactance XL values for three circuits. 1 Circuit R (k) Xc (k) X₁ (k) I 5 1 II 4 8 III 3 5 5 3 B. 5[k2] C. 7[k] D. 9[kS2] • Matching type. Which of the circuits matches the phasor diagram? A. I and III only B. II and III only C. I and II only D. III only • What is the impedance of circuit II? A. 3[k] 7

1. Take a look at the phasor diagram. The table shows the resistance R. capacitive reactance XC, and inductive reactance XL values for three circuits. 1 Circuit R (k) Xc (k) X₁ (k) I 5 1 II 4 8 III 3 5 5 3 B. 5[k2] C. 7[k] D. 9[kS2] • Matching type. Which of the circuits matches the phasor diagram? A. I and III only B. II and III only C. I and II only D. III only • What is the impedance of circuit II? A. 3[k] 7

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter32: Alternating-current Circuits

Section: Chapter Questions

Problem 15P: In addition to phasor diagrams showing voltages such as in Figure 32.15, we can draw phasor diagrams...

See similar textbooks

Similar questions

Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
An RLC circuit consists of a 150- resistor, a 21.0-F capacitor, and a 466-mH inductor connected in series with a 120-V, 60.0-Hz power supply. (a) What is the phase angle between the current and the applied voltage? (b) Which reaches its maximum earlier, the current or the voltage?
In addition to phasor diagrams showing voltages such as in Figure 32.15, we can draw phasor diagrams with resistance and reactances. The resultant of adding the phasors is the impedance. Draw to scale a phasor diagram showing Z, XL, XC, and for an AC series circuit for which R = 300 , C = 11.0 F, L = 0.200 H, and f = 500/ Hz.
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
(a) Does the phase angle in an RLC series circuit depend on frequency? (b) What is the phase angle for the circuit when the inductive reactance equals the capacitive reactance?
The lowest frequency in the FM radio band is 88.0 MHz. (a) What inductance is needed to produce this resonant frequency if it is connected to a 2.50 pF capacitor? (b) The capacitor is variable, to allow the resonant frequency to be adjusted to as high as 108 MHz. What must the capacitance be at this frequency?
To receive AM radio, you want an RLC circuit that can be made to resonate at any frequency between 500 and 1650 kHz. This is accomplished with a fixed 1.00 μH inductor connected to a variable capacitor. What would be the minimum capacitance, in nanofarads, that would be required? Cmin = Part (b) What would be the maximum capacitance, in nanofarads, that would be required? Cmax=
Q5: An inductor is one of important device in electrical circuits. To study response of it in pure form,inductor 240 mH is connected to AC source of maximum voltage 280 V, with a frequency of 120 Hz.Predict the rms current passing through the circuit. Can you predict the change in rms current if thefrequency is increased to 5 kHz? Are there any similar properties for a transformer compared withinductor? Is it possible to operate inductor with DC source? Justify your answer.
Q14 - In an A.C circuit, if the phase difference (φ) is positive, then it shows that inductor is connected in the circuit. Select one: True False
For a certain RLC Circuit the maximum generator emf is 125V and the maximum current is 3.20A. (PHYS1801 CLO5) If the current leads the generator emf by 45 degrees, then (a) What is the impedance of the circuit? (b) What is the resistance of the circuit? (c) Is the circuit predominantly capacitive or inductive? Why?
The figure on the right shows an RLC parallel circuit connected to a battery. Assume that the inductor and capacitor are initially uncharged and are ideal. Which branch will have the most current after “a long time”? Explain
Does the phase angle in an RLC series circuit depends on frequency? What is the phase angle for the circuit when the inductive reactance equals the capacitive reactance? Explain your answer thorougly.