1. The following data are given for a three – branch parallel circuit: V = 12 V , R = 82 kN, L = 15 mH, and C = 390 pF. Determine the values specified at the resonant frequency. а. fr b. Xµ g. IT h. Zт i. Q j. fi k. f2 I. 0 %3D %3D %3D %3D С. Хс d. IL %3D %3D %3D e. Ic f. IR %3D %3D II || || I| || ||

Q: Vaり Frequency frequency (MHz) YeV) (MHz) 1.1 3.24 2.2 13.8 1.2 3.52 2.3 13 1.3 3.84 2.4 10.8 1.4…

A:

Q: a) For the Circuit shown calculate the value of C if the resonant frequency. is 5000 vad /sec

A:

Q: C2 HH C1 n Fig. 3. R1 R2 Vout Vin Figure 3 d)Plot the frequency response, and indicate the gain…

A:

Q: Q5- If an AM signal is represented by, V = (10 + 2 Sin ( 2π × 5 × 103 t) ) Sin ( 2π × 0.5 × 106 t)…

A:

Q: 36. (a) Obtain an expression for the equivalent impedance Zeq of a 1 2 resistor in series with a 10…

A:

Q: 3.1 Find in From the circuit in Figure 3. 3.2 Find Q b ww Σ10 Ω ข้อที่ 3 รูปที่ 3 10 mH 3.3 If a…

A:

Q: Q1. From the UJT data sheet: +20V n= 0.63, Vs 2.5Vv, Ip 7.4µA, R2 Is 1.75mA, Ran 5k2 & Vemin -…

A: The Unijunction Transistor, or UJT for short, is another solid-state three-terminal device that may…

Q: Consider a linear time invariant channel with amplitude response 0.2 VL.64–1.6 cos(2r/) S(f) Suppose…

A: Given a LTI with amplitude response of the system in frequency domain as:  S(f)=0.21.64-1.6cos(2πf)…

Q: of the FM signal. 3.32 The carrier c(t) = A cos 27 10t is angle modulated (PM or FM) by the sinusoid…

A: Angle modulation

Q: Q1) For the network of Fig.1 a) Find the resonant frequency fb. b) Calculate the magnitude of Ve at…

A: Resonance: Resonance is the frequency response of a circuit when it’s operating at its natural…

Q: If the resonant frequency is 1 MHz and Q = 50, then f1 = ________ and f2 = _______ A) 0.98 MHz,…

A: Given:  Resonant frequency fr=1 MHz, Quality-factor Q=50.

Q: 10 In the parallel resonance circuit, R = 250 W, L = 2 mH, and C = 20 mF. The circuit is driven by a…

A:

Q: a). Calculate the frequency response H(f) in tems of f Ĥ(f) = b). Calculate the magnitude and phase…

A:

Q: Q3) Referring to the Figure 3 below, given the value of R = 20 92, L= 1000 µH, and C = 400 nF.…

A: In this question,  We need to determine the resonant frequency, power frequency and quality factor.…

Q: For the series R-L-C AC Circuit shown below with R = 20 ohms, L = 10 mH, and C = 100 µF: a.)…

A: To find the resonating frequency of a series RLC AC circuit  And also determine the amplitude of…

Q: Q1) For the network of Fig.1 a) Find the resonant frequency fb- b) Calculate the magnitude of Ve at…

A:

Q: 12.10 Draw the Bode plot for the nelwork function H(ja) = (jo + 1)(0.1jw + 1)

A: In this question,  We need to plot the bode plot.i.e magnitude plot and phase plot.

Q: From the given circuit, find: the upper cutoff frequency of the system. a) 8.6 MHz, b) 10.77 MHz,…

A: The upper cutoff frequency of the amplifier is due to the presence of internal capacitance and the…

Q: 3- How many dB's of attenuation does this attenuator provide? Po Pi attenuator 1/2 W 1W Loss

A: In this question,  Find the attenuation in dB.  We know attenuation = Po/Pi

Q: Compute the impedance Z of a series R-L-C circuit at angular frequencies ω = (a) 1001 rad/s Assume…

A: We need to find out current and impedance for given series RLC circuit

Q: Question 2 A multimode graded index fiber exhibits a total pulse broadening of 0.25µs over a…

A: Given, T = 0.25 μs D = 50km a) We know that,                             Bandwidth B ≤ 12T =…

Q: In a series RLC circuit that is operating above the resonant frequency, the current leads the…

A: For a series RLC circuit, the impedance diagram is as below.

Q: An input power of P = 3 W is fed to a 75 km conductor. A repeater is present at 40 km from…

A: In this question, Find the The power received at receiver side is? If An input power of P = 3 W is…

Q: The input impedance of antenna A is given as Z =120 + j120 2. Antenna B is complementary to the…

A:

Q: Question 1: Working in the frequency domain, write the equation for mesh 3. V2 2.5 2 0.5 F 2 H 1H 79…

A: For the above given figure there are four meshes so to to find all current we need 4 equations. Let…

Q: 016: The bandwidth of the two angle modulated transmitting systems are compared, using the…

A:

Q: öealg äbäi Find the cutoff frequency for نقطة واحدة * the circuit shown below C, 0.1µF c, 0.1µF R…

A: The cut-off frequency of the above circuit is,

Q: 1) a) For the circuit shown , let R= 1kohm, L1 = 10mH, C1= 5nF. Calculate the values of Z, Phase…

A: The solution is given

Q: Consider the network shown in the figure below: Z3 (30 + X)n Z2 If the impedances Z = (20 + /10) Q…

A: Given circuit is - Given values are - Z1=20+j10Z2=10-j30Z3=30+jX

Q: II. Problem Solving 1. Solve for the thermal noise voltage if the bandwidth is 150MHZ and the load…

A: We need to calculate noise voltage for given resistor .

Q: 3. Consider the systems shown in the following figure. Suppose that H(ej") is fixed and known. Find…

A:

Q: Fig. 1 R1 C1 V1 L1

A: Since you have asked multiple subpart I will answer first three subparts for you. The given circuit…

Q: Structural Engineers in an iron manufacturing company describe the results of deformation on the…

A: Given  Structural Engineers in an iron manufacturing company describe the results of deformation on…

Q: Q.1: For the parallel R-L-C resonant circuit as shown in fig. below, Rs = 50KN, R₁ = 10KN, calculate…

A: Given data, Rs=50 kΩ, R1=10 kΩ, L= 1 mH, C=10 μF,f=50 kHz

Q: Q5. Calculate the resonance frequency (w,) for the circuit shown. R3=500 0 L=0.1 H R2=1 0 C=0.1F*…

A: Consider the given circuit,

Q: Q1: Find the frequency response of the system shown in figure below and sketch its characteristics…

A:

Q: Q1. From the UJT data sheet: +20V n = 0.63, Vs = 2.5V, Ip = 7.4µA, Is = 1.75mA, RBB = 5kN & V, gmin…

A: Unijunction Transistor (UJT): The Unijunction Transistor (UJT) is a semiconductor switching device…

Q: For the network of Fig.4 a) Find the resonant frequency f. b) Calculate the magnitude of V, at…

A:

Q: The EIRP of a transmitting station is specified as 33.2 W in a given direction. Calculate its ERP in…

A: We need to convert given power in dBm .

Q: In this homework, you are supposed to design a WBFM generator using Armstrong method. The required…

A: According to the question,

Q: 684. See Fig 684. C=13 uFd, L=17 Hen, R=102 Ohms, Vm=15 Volts, w=67.3673 rad/sec. Determine the…

A: Here, first circuit is given in time domain and second Circuit in jw domain.

Q: 10 μΗ Consider Zeg Calculate the resonant frequency wq. 50 Ω a. b. Plot |Ze by first evaluating it…

A: The circuit diagram is: a). It is a series RLC circuit.

Q: An RLC Series circuit is connected to a 20V variable frequency supply. If R=20ohms, L=20mH and…

A:

Q: Based on the following block diagram answer the following questions. M -20kHz 20kHz a(1) 4cos(10"rt)…

A: Solution (a)  from fig : a(t) = m2(f)+4cos(60000πt) ......(i)b(t) =…

Q: wRC RV = V(1- W²LC)² + (wRC)² where w is the frequency of the input voltage. If C = 8µF , L= 11mH ,…

A: RV=ωRC1-ω2LC2+ωRC2and, RV ≥0.87ωRC1-ω2LC2+ωRC2≥0.87 ωRC=ω×1000×8×10-6         =8×10-3ω…

Q: x1(t) = 1.2 + 3sin(5tt) +2 sin(25at + ;). Denote x2(t) = x1(t – 0.1) and r3(t) = x1(t) +2r2(t). What…

A:

Q: For the following Series Resonant curve: a. Find the Bandwidth, and the quality factor. b. Find the…

A: Given series resonant circuit shown L=2 mH

Q: In this circuit, one power amplifier A1=18.9 dB feeds into an attenuator circuit, which then feeds…

A:

Q: Ex. 7.2 for Wilkinson power divider: Design an equal-split Wilkinson power divider for a 50 Ohm…

A: Wilkinson Power divider: The Wilkinson Power Divider is a type of power divider circuit used in…

Q: In an RLC series circuit shown in Fig.1 determine (i) the necessary value of capacitor (ii) the…

A:

Uplink and Downlink Segment

The uplink and the downlink are the terminologies that are used in the satellite communications. The data when sent from the ground to the satellite is called the uplink and data when sent from satellite to ground is called downlink. The uplink and the downlink process goes in parallel and this is also a two way communication.