1. The Outback Steakhouse main office has purchased a $100,000 online document imaging system with an estimated useful life of 8 years and a tax depreciation recovery period of 5 years. Compare the present worth of total depreciation for (a) the SL method, (b) the DDB method, and (c) DDB-to-SL switching (d) Perform the DDB-to-SL switch and plot the book values. Use a rate of i=10% per year.
Q: for step 5, what calculations led to 93%?
A:
Q: Considering a horizontal flow sedimentation tank characterized by a flow velocity of precisely 0.32…
A:
Q: For a catchment isohyets are drawn and area is calculated using planimeter as shown in figure. The…
A: as per given isohyets for a catchment area,To the average precipitation over the catchment area
Q: A long, slender structural aluminum[E=69GPa] flanged shape is used as a L=8.0-m-long column. the…
A:
Q: for you, will you hit the lead vehicle? If so at what speed will you be going?
A: V = 70 mph L = 20 ft t = 1.5 secf=0.28one car length spacing for each 10 mphNeed to find
Q: Can you please show me the full solution of Rah and RAV in the reactions and the PAB, PAC, PBD, AND…
A: The actual representation of the values are ;Consider sum of horizontal reactions = 0 From Provided…
Q: Determine the following: A) Axial stress in 1/4" dia B.) Lengthening of the 1/4" Rod due to the…
A:
Q: A given sludge with 98% moisture content is X times more bulky than with 95% moisture content. The…
A:
Q: At full draw, an anchor applies a pull of 130 N to the bowstring of the bow as shown in the figure.…
A: Ans1)Pull=130KnThe diagram is given below-
Q: Assume framing elements are equally spaced between column grids. The roof framing supports a metal…
A: A framing plan is given we need to find out the tributory width, reactions and maximum moment
Q: A waste water is to be disinfected with chlorine to kill 90% of microorganisms. The number of…
A: As Per question,
Q: An electrostatic precipitator (ESP) is installed to remove dust from the smoke with an efficiency of…
A: The given data is:1. Efficiency of the electrostatic precipitator (ESP): 95%2. Migration velocity of…
Q: 0.4m 0.4m 0.6 m For the above diagram, there are smooth journal bearings at supports A, B and C.…
A:
Q: versus n for each of the five variables. What do the results suggest about the importance of the…
A:
Q: Determine the average normal strain along the side AB?in micro rad And answer in right and clear way…
A: The plate is deformed into the dashed shape shown in the figurea = 39 in,b = 33 in, and Need to…
Q: Please provide solution for this question and explain
A: For the given retaining wall with backfill,To find the active earth pressure at base of wall
Q: Route the following upstream inflow hydrograph through a downstream flood control channel using the…
A:
Q: In Figure (a), a constant horizontal force F is applied to block A, which pushes against block B…
A:
Q: Spot speed study was carried out redesign the stretch of major district road. The data collected…
A:
Q: please help me where did you get the Rah and Rav in reactions and then the Pab and Pac , Pcd and Pbd…
A: Dear, Rah and Rav are the two reactions which the hinge support generates. The hinge support will…
Q: Since the industrial revolution (~1750), humans have released over 1.5 trillion tons of CO2 into the…
A:
Q: Determine the increase in vertical stress (kPa) 6 m below the corner of a rectangular foundation 4 m…
A: The increase in vertical stress due to UDL below the corner of rectangular foundation can be…
Q: Problem No. 1 (b) the For the built-up shape shown, determine (a) the elastic section modulus and…
A: Fy = 248 MPaDeterminea. The elastic section modulus and the yield moment. b. The plastic section…
Q: Calculate the wind velocity pressure (q) on the following windward wall only (no sides or leeward)…
A: There are 2 shear walls at ends, and the system has a uniform stiffness. Building is a clinic…
Q: How does an organization collaborate with any new partners as a result of the grant they received…
A: The objective of the question is to understand the process of collaboration between an organization…
Q: Estimate the velocity and head loss per 1000 feet
A: Given:- Diameter of the pipe = 12 inches =1 ft Rate of flow = Friction…
Q: What you done during your time at the university to develop enough of a specialization in…
A: Currently, I am pursuing my master's degree in civil engineering, specialisation in geotechnical…
Q: Average headway of 8 seconds and density is 65 vechicles per hour. Calculate the space mean speed at…
A: Headway (h) = 8 secDensity (k)= 65 vph
Q: What are the two primary instruments used to accomplish the work in procurement stage and when may…
A: The objective of the question is to identify the two main instruments used during the procurement…
Q: P5.8 A steel [E = 200 GPa] bar (1) supports beam AB, as shown in Figure P5.8. The cross-sectional…
A:
Q: A 6 m 4 kN -2 m 30°
A:
Q: Considering a horizontal flow sedimentation tank characterized by a flow velocity of precisely 0.32…
A:
Q: A freeway traffic stream was observed to have a density of 22.0 veh/mi/ln when the mean speed was…
A: The objective of the question is to calculate the flow rate of traffic at a given mean speed and…
Q: A 5 cm x 2.5 cm venturimeter with a coefficient of discharge of 0.98 is to be replaced by an orifice…
A: Venturimeter dimensions: 5 cm × 2.5 cm2. Venturimeter coefficient of discharge: 0.983. Orifice meter…
Q: Consider the given retaining wall with backfill. The active earth pressure at base of wall is kN/m2.…
A: For the given retaining wall with backfill,To find the active earth pressure at base of wall
Q: Determine the reactions of the following frames, then draw N.F., S.F. and B.M.Ds 3.0. +813.0 2 6 tj…
A: Determine the support reaction and draw the axial force, shear force and bending moment diagrams.…
Q: For a two hour rainfall, the hyetograph superimposed with infiltration curve is as shown below. The…
A: For a two hour rainfall,The hyetograph superimposed with infiltration curve is as shownbelowto find…
Q: A 1 : 100 scale model of river is to be tested in a laboratory. The highest flood in river is 1000…
A: The given data for the river model testing is:Highest flood in the actual river = 1000 m³/sScale of…
Q: 2.22 A consolidated-undrained normally consolidated test results: triaxial test was conducted on a…
A: Consolidated saturated clay test results σ3 = 90 kN/m²σ1 = 220 kN/m² u = 38 kN/m²
Q: 3-33 The plug has a diameter of 30 mm and fits within a rigid sleeve having an inner diameter of 32…
A: The objective of the question is to determine the axial pressure that must be applied to the top of…
Q: The section shown below is subjected to a shear force of 20 kN. What will be the shear stress for…
A: For Given section,Shear force, V = 20 kNTo find the shearstress for this section at neutral axis
Q: 1. Did internal or external factors (e.g. new staff/volunteers, unanticipated delays, increased…
A: The objective of the question is to understand the impact of internal and external factors on the…
Q: A vertical U-tube, with both ends open, contains mercury to & depth of 10 in. in each tube above the…
A:
Q: A r 2m + d 300N B B 3m 307 M-1500Nm For the above diagram, given that F₁ = 800 N, w = 400 N/m and d…
A: Determine the magnitude of the reaction force.
Q: A four-lane northbound section of interstate has rigid pavement and was designed with a 8-inch slab,…
A:
Q: The magnitudes of the two force vectors are |FA| =80 lb and |FB| =40 lb (Figure 1). Figure 60° 30°…
A:
Q: A fluid of specific gravity 0.8 is flowing in a pipe. The pressure drop across a flow secti between…
A: Given:- Reading of manometer=X=0.5 m Specific gravity of flowing fluid=S= 0.8 Specific gravity of…
Q: about 0.8 mm. Estimate the variation of the relative density with depth for sand. Use Eq. (3.23).
A: water table located 12 m below surfacedry unit weight of sand (soil) depth upto 12 m = 17.6…
Q: The static and stagnation pressures of a fluid in a pipe are measured by a Piezometer and a Pitot…
A:
Q: If the reservoir and flow control valve represent a water treatment facility and the operators want…
A: A statement is given asIf the reservoir and flow control valve represent a water treatment facility…
Step by step
Solved in 6 steps with 16 images
- Subject: Engineerings Economics Topics:1. Declining Balance Method (DBM) Please help me to solve this in step by step manner. Make sure to analyze the question well.BOX your final answer Question: A machine cost P160,000 and is estimated to have a life of 6 years. If the rate of depreciation is 25%, find the salvage value using the declining balance method.Please use the following sources below: Blank, L. & Tarquin, A. (2018). EngineeringEconomy (8th Ed.). McGraw-Hill Education.Sullivan, W., Wicks, E. & Koelling, C. P. (2014).Engineering Economy (16th Ed.). PearsonEducation South Asia Pte Ltd.Sta. Maria, H. (2000). Engineering Economy(3rd Ed.). National Book Store.Arreola, M. (1993). Engineering Economy(3rd Ed.). Ken Incorporated.Sinking Fund MethodGiven:FC = 2,000,000.00 pesosSV = 300,000.00 pesosi = 12.00%n = 9 yearsa. Annual depreciation = ?b. Total depreciation after 6 years= ?c. Book value at year 7 = ?The “Big-Deal” Company has purchased new furniture for their offices at a retail price of $125,000. An additional $20,000 has been charged for insurance, shipping, and handling. The company expects to use the furniture for 10 years (useful life = 10 years) and then sell it at a salvage (market) value of $15,000. Use the SL method of depreciation to answer these questions. a. What is the depreciation during the second year? b. Whatisthe BVoftheasset at the end of the first year? c. What is the BV of the asset after 10 years?
- A): Calculate the total cost, total depreciation, and annual depreciation (in $) for the following assets by using the straight-line method. (Round your answers to the nearest cent.) *chart attached* B): Mason Industries purchased a drilling rig for $75,900. Delivery costs totaled $2,831. The useful life is 7 years and the salvage value is $12,938. Prepare a depreciation schedule using the straight-line method. *CHART ATTACHED*Compute the declining-balance depreciation schedule for an asset with thefollowing data:Cost of the asset. I $90.000Useful life. N 7 yearsSalvage value, S $ 10,000An asset costs $150,000 and has a salvage value of $15,000 after 10 years.What is the depreciation charge for the 4th year, and what is the book value atthe end of the 8th year with(a)Straight-line depreciation?(b)Double declining balance depreciation?
- PLEASE ANSWER LETTER (d.) The Alpha Drug Company has just purchased a capsulating machine for ₱2,000,000. The plant engineer estimates that the machine has a useful lifeof five years and a salvage value of ₱ 25,000 at the end of its useful life.Compute the depreciation schedule for the machine by each of thefollowing depreciation methods: d. double declining balance method of depreciationUsing the double declining balance depreciation method for an asset purchased at the start of 1019 w/an annual cost of $85,000, a salvage value of $2,500, and a depreciable life of 12 years, the book value at the end of 2023 is most nearly waht amount? a. $40,990 b. $36,238 c. $34,160 d. 28,500 e. $23,720 Please use excel and show formulas.Solve correctly in excel Six years ago, a company purchased $30,000 of equipment. The equipment has just been sold for $5000. The equipment was depreciated using 50% bonus depreciation / 50% MACRS (using a 5-year recovery period). The actual savings due to the purchase of the equipment is shown below. The firm's MARR is 12% and it's tax rate is 25%. What is the after-tax present worth of the investment? Year 1 2 3 4 5 6 Savings 5000 6000 7000 7000 4000 3000
- Thank you A drilling machine was acquired by Western Harverster Co at a cost (B) = $50,000 with a 5-year recovery period and salvage value S =$10,000. What is the depreciation in year 3 using MACRS? Using MACRS, what fraction of the initial $50,000 will be cumulatively depreciated by the end of year 3? If MACRS depreciation is used, what is the Book Value at the end of year 2?You have started a business and purchased a new truck (asset class 00.22). The cost basis for depreciation purposes is $175,000. Salvage value at year six is $20,000. ***Assume it will be depreciated under the GDS: a. What is the MACRS depreciation in the third year? b. What is the cumulative depreciation through the end of year three? C.What is the BV at the end of third year if the equipment is disposed of at that time? d. What will be the gain(loss) for tax if you sell the equipment for $40,000 at the end of year three?A digitally controlled plane for manufacturing furniture is purchased on April 1 by a calandar -year taxpayer for 66,000. It is expected to last 12 years and have a salvage value of 5,000. Calculate the deprexiation deduction during years 1,4 and 8. A) Use straight line depreciation B) Use declining balance depreciation, with a rate that encures the book value equals the salvage title c) Use double declining balance depreciatin D) Use declining balance depreciation, switching to straight line depreciation. please show all steps and use an excell sheet..