Say if it is true or falls 1. The source encoder is responsible for decompression.2. The output of the channel decoder is the estimate of the original message.3. Analog systems are more susceptible to noise than digital systems.4. Digital receivers can receive both analog and digital signals.5. If the power of a signal is finite, the energy is assumed to be zero.6. An odd function multiplied by even function will produce an odd function.7. The channel code word contains redundancy bits.

Note: Since the question is multiple one we are advised to do only first three question. Kindly post…

Answered: 1. The source encoder is responsible…

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Q2(b) A signal travels from point A to point B. At point A, the signal power is 300 W. At point B, the power is 280 W. What is the attenuation in decibels?
Make three problems regarding calculations of bit rate, baud or M-ary encoding.
The information in an analog waveform, with maximum frequency f = 3 kHz, is to be transmitted over an M-ary PAM system, where the number of pulse levels is M = 16. The quantization distortion is specified not to exceed t 1% of the peak-to-peak analog signal. (a) What is the minimum number of bits / sample, or bits / PCM word that should be used in digitizing the analog waveform? (b) What is the minimum required sampling rate., and what is the resulting bit trans-mission rate? (c) What is the PAM pulse or symbol transmission rate? (d) If the transmission bandwidth (including filtering) cquals 12 kHz, determine the bandwidth efficiency for this system.
Q3] A discrete memoryless source emits the following alphabet symbols: M1 -M2 M3 -M4 -M5 -M60.3 -0.25 -0.2 -0.15 -0.07 -x(a) Find the value of x, and the code length of fixed length codes (no source coding).(b) Compute the Huffman codes for this source. Compare between the two results.
2.Consider the bit stream 01101101. Draw the waveforms for following line codes.(i)(ii)Biphase Manchester codingBiphase Differential Manchester codingPolar PSEUDOTERNARY(iii)(iv)Multilevel -8B6T(v)Multilevel-2B1Q Assume that the signal level for the most recent preceding 0 bit (pseudoternary) has a negative voltage.
The transmission impairment that refers to a signal with high energy in a very short time is Impulse Noise why?
Consider this 1-bit ALU design, as shown in class (note that the rounded rectangles controlled by Ainvert, Binvert, and Operation represent multiplexers): If I want Result to be the result of a - b, then what value do each of these other inputs need to be? Ainvert : 0 or 1 Binvert : 1 or 0 CarryIn: 1 or 0 Operation : 00 , 01, 10, 11 which one ?
17. An analog signal carries 4 bits in each signal unit. If 1000 signal units are sent per second, then baud rate and bit rate of the signal are ________ and ____________ a. 4000 bauds \ sec & 1000 bps b. 2000 bauds \ sec & 1000 bps c. 1000 bauds \ sec & 500 bps d. 1000 bauds \ sec & 4000 bps
In _______ encoding, the duration of the bit is divided into two halves. The voltage remains at one level during the first half and moves to the other level in the second half. The transition at the middle of the bit provides synchronization. a. Manchester b. differential Manchester c. both (a) and (b) d. neither (a) nor (b)
Objective The objective of this homework is to help students to understand and employ Nyquist’s and Shannon’s maximum channel capacity theorems
given me solution in computer science, . A movie was shot in 150 fps. The movie lasted for 30mins. The movie was played in a vertical and horizontal pixel of 720 × 720 respectively. The bit depth for the video was 16 bit. This same video was shot having an audio sampling rate of 44100 Mhz with an audio bit depth of 32bit. The producer of the video decided to test the quality of the audio for the movie with a surround 5.1 channel audio systemi) Calculate the audio file size in bits and explain its effect on the video file.ii) Calculate the file size of the video in Megabytes (Mb) iii) Calculate the bit rate of the video file and explain the effect of the value on processing of the fil
9. The process of converting analog signals into digital signals so they can be processed by a receiving computer is referred to as a. modulation b. demodulation c. synchronizing d. digitising

Recommended textbooks for you

Database System Concepts

Computer Science

ISBN:

9780078022159

Author:

Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:

McGraw-Hill Education

Starting Out with Python (4th Edition)

Computer Science

ISBN:

9780134444321

Author:

Tony Gaddis

Publisher:

PEARSON

Digital Fundamentals (11th Edition)

Computer Science

ISBN:

9780132737968

Author:

Thomas L. Floyd

Publisher:

PEARSON

Database System Concepts

Computer Science

ISBN:

9780078022159

Author:

Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:

McGraw-Hill Education

Starting Out with Python (4th Edition)

Computer Science

ISBN:

9780134444321

Author:

Tony Gaddis

Publisher:

PEARSON

Digital Fundamentals (11th Edition)

Computer Science

ISBN:

9780132737968

Author:

Thomas L. Floyd

Publisher:

PEARSON

C How to Program (8th Edition)

Computer Science

ISBN:

9780133976892

Author:

Paul J. Deitel, Harvey Deitel

Publisher:

PEARSON

Database Systems: Design, Implementation, & Manag…

Computer Science

ISBN:

9781337627900

Author:

Carlos Coronel, Steven Morris

Publisher:

Cengage Learning

Programmable Logic Controllers

Computer Science

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

SEE MORE TEXTBOOKS