1. Two batteries with 0.1 ohm and 0.1 ohm Internal resistances supply power to a 100 ohm load at 11.8 volts, what is the current of each batteries? Use Kirchhoff's Law A B R1 R2 R3 100 Q 100 Q 100 Q IR VR =11.8 V 12 I1 V V D

1. Two batteries with 0.1 ohm and 0.1 ohm Internal resistances supply power to a 100 ohm load at 11.8 volts, what is the current of each batteries? Use Kirchhoff's Law A B R1 R2 R3 100 Q 100 Q 100 Q IR VR =11.8 V 12 I1 V V D

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter16: Installation Of Heating, Cooling, And Refrigeration Systems

Section: Chapter Questions

Problem 28RQ

See similar textbooks

Related questions

Q: Write the impedance equation for the circuit shown. Follow the format used in the manual

A: In this question, We need to determine the Write the impedance equation for the circuit shown?

Q: For a voltage divider JFET circuit with the circuit components shown below, Determine ID in mA…

A: The value of drain current can be calculated by using the graphical approach by using the DC…

Q: A 741 op amp has an open-loop voltage gain of 2×10$, input resistance of 2 MN, and output resistance…

A: given open-loop gain of 741 op amp is 2×105 input resistance is 2 M ohms output resistance is 50…

Q: 5Ω V1 50 V 10 Ω ί 40 Ω 3 A Nodal Analysis equations for the above analysis are given as: B – V, A +…

Q: Point charges 48 nC, -39 nC, and 118 nC are located at (-1,0, 2), (0,0, 0), and (1,5, –1),…

A: We need to find out flux leaving the surface .

Q: WL Fland IL wsing Nortoi's treikem. Sou DIA

Q: Given a G zoh -(0.05)s /s in cascade with G(s)-1/s, the sampled data transfer function G(2) at…

Q: Find the fourier transorm for the following Signdis a) f(t) = 5 cos20t b) v(t) = e'u(-t) + u(t) f()…

Q: 1 Please summarize at least two logic families, including a comparison between the two as if you…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: To solve the circuits using Laplace Transform we follow the following pro Simplify the circuit,…

A: In this question we will solve problems related to Laplace transform.....

Q: 4052 Finad IL whing S Son Souvee Tranlyrmation 25

Q: Select the right answer of the following: 1- The 66 Ky lines use (pin insulators/suspension…

Q: 1. Two batteries with 0.1 ohm and 0.1 ohm Internal resistances supply power to a 100 ohm load at…

Q: Q3: Find the h-parameters for the two-port network shown in Figure 2. ,30 0.5 V, 412 V, 31

Q: The current through the inductor is 5 amps. R Ci0.1μF LL1mH R13 kn 300 V 1 kHz O A. True O B. False

Q: 10 SL Fud IL wsing Norton's teikem IA

A: In this question we will find load current using norton the form....

Q: The magnetic field phasor of a uniform plane wave traveling in a non-magnetic medium with intrinsic…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: alculate a series RC value that will produce a V = 7.59 V output at f = 87 Hz when V 20 V at f = 87…

Q: QUESTION 8: A Widlar current source has the configuration shown in the following figure. Assume the…

Q: 2.) In Free space, let Q=lonc be at Pi (0, -4,0) and Qz=20nc P2 C0,0,4). Find the Force acting by…

A: In a system of charged particles present in free space, The magnitude of force between two charges…

Q: In a DSB-LC system, the message signal is 15 cos (87T*10*t) and the modulation index is 0.8. The…

A: We need to find losses and signal to noise ratio for given system

Q: Find IL whing Souvce tranlyrmatiom

Q: What is the phase angle? R14 kn C1수0.04 μF L 497 V 4 H 750 Hz O A. 61.4° B. 28.5° C.-28.5° O D.…

Q: b. (3 + 4i)² c. (3+ 4i)³ С.

A: The solution is given below

Q: RL VEB VCB common emitter common collector common base

A: Solve the problem

Q: Find IL whilg Souvce Trandlyrimation

Q: Perform the following operations: 1. (3+j2)(4+j5) / (2 + j3)²

A: We need to simplify the given complex number.

Q: an [n] ċ Sin won u

A: Solve the problem

Q: For the circuit shown below calculate IE in mA when IDSS=12mA VP=-6V and B=120

Q: R4 V2 R3 1. Derive Vout of the op-amp circuit above. 2. If you put resistor R, between the output…

Q: In spherical coordinate system, r = 1, ø = defines a; Select one: O Point O Surface O Vector O None…

A: We need to answer the correct option for the above given question.

Q: 3. Refer to the diagram below. Compute the total capacitance, voltage and charge across each…

A: Capacitance are C1 =2 μF ;C2 =3 μF ; C3 =4 μF ;C4 =5 μF ;C5 =6 μF ;C6 =7 μF ;C7 =8 μF ;C8 =9 μF ;C9…

Q: Calculate a series RC value that will produce a V = 7.59 V output at f = 87 Hz when = 20 V at f = 87…

Q: (cos 20+ jsin 20)5(cos 60+ jsin 60)10 (cos 30+ jsin 30)°(cjs 1000)

Q: RB RC 330k 1.2k R1 Q1 100k NPN VDD 20V J1 NJFET R2 RS 20k 2k

A: We need to find out base current for given circuit.

Q: Calculate a series RC value that will produce a V = 7.59 V output at f = 87 Hz when = 20 V at f = 87…

Q: In the circuit below R=800Q, L=0.4H, C=2.5 µF and Vs=10OV. The type of the transient is 1 = 0 R L.…

Q: A Wheatstone bridge has a 10 V supply, all four resistors are 5 k2, and the 2u galvanometer has a 25…

Q: Consider the finite-duration sequence a[n] = {-2,0, 4,0, 2} %3D where the highlighted and underlined…

Q: QUESTION 6: Refer to the ideal non-inverting op-amp Figure P9.45. Find v2 and vo for v71 = 0.97 V…

A: In this question we will find output voltage.....

Q: Evaluate div D at R(1.5, 30°, 50°) of the given vector field: D = 2pz² sin?o a, - pz? sin 20 ag +…

A: The solution is given below

Q: QUESTION 6: Design a pnp version of a the basic three-transistor current source using a resistor to…

A: Given,The parameters of the transistors are,Io=0.18mAV+=5 VV- =-5 Vβ=98VBE(on)=0.7 VVA=∞

Q: use the node-voltage method to Find Vo ad Io the Cir Cait below

Q: Ic R VEB VCB Fundamentals of BJT (ELECTRONICS) 1. What is the configuration of the amplifier? O…

A: Brief description : For the given amplifier circuit we need to identify its configuration and they…

Q: e sh ted 180' 10 8 4 > t.s ー2 -4

A: The solution is given below

Q: Q5: The peak value of the input to a full-wave bridge rectifier is 10 V. The approximate average…

A: In this question we need to find a average value of output voltage of the given rectifier

Q: In Figure Q2 (b), given that the voltage source, V, is a step function. The current flow through the…

Q: What is the phase angle? R14 kn G+ :0.04 µF L14 H 497 V 750 Hz O A. 61.4° B. 28.5° O C.-28.5° O D.…

Q: e^-at (1)n C Ot^2 For the Photoflash unit, Vs= 9V, R1=5KQ, C=D1500 uf , R2= 120. The average power…

Q: DD Rp Vo VGS Rs Ra (c) Figure 7.50 BiasingT ueing

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

1. Two batteries with 0.1 ohm and 0.1 ohm Internal resistances supply power to a 100 ohm
load at 11.8 volts, what is the current of each batteries? Use Kirchhoff's Law
A
B
R1
R2
R3
100 Q
100 Q
100 Q
IR
VR =11.8 V
12
I1
V
V
F
D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two 25-volt batteries having an internal resistance of 0.2 ohm and 0.4 ohm repesctively supply power to a 2-ohm load. How much current is delivered by each battery? Use counterclockwise
Determine current Vo1 in volts, when E=18V, R1=1417 ohms, R2 = 2940 ohms.
Calculate the total DC resistance in milliohms of a 100 meter roll of 2.5mm2 copper wire if the resistivity of copper at 20oC is 1.72 x 10-8 Ωm.
Determine the drop voltage in the resistance R1, when BT1 = 13.6 V and resistance R1 = 4.6 kΩ.
An element in an electric heating unit is applied to a 232v power supply. The current flow through the element is 19 amperes. What is the resistance of the elements?
The efficiency for incandescent light bulbs is typically about 14 lumens per watt (lm/W) and that for LED bulbs is typically about 90 lm/W. Use Ohm’s law to calculate the total light output in lumens of each type of bulb if the incandescent bulb has resistance of 10 Ω and the LED bulb has resistance of 2 Ω and each are supplied with a current of 2 A. Question 1 options: Incandescent: 230 lm. LED: 360 lm. Incandescent: 7840 lm. LED: 64800 lm. Incandescent: 112 lm. LED: 3600 lm. Incandescent: 560 lm. LED: 720 lm.
What will be the value of thermal voltage for Ge at 400 K? Show detailed calculation please.
Determine the voltage Vo in volts, when E1=11 V, E2=11 V, R1=1459 ohms, and R2=3493 ohms
A. If the change in the input voltage of a power supply is around 2V and the change in the output voltage is 50% of that, what is percent regulation of the power supply? Choices: 200 100 50 25 B. What type of regulation is depicted in the question? Choices: line load power voltage
a) Does 12 V(ε1) battery supply or absorb energy? Explain the reason b) What is energy transfer rate of battery with emf ε1? c)Does battery 4 V(ɛ2) supply or absorb energy? Explain the reason d)What is its energy transfer rate of the battery with emf ε2
8. The resistance of a copper at 30°C is 50 ohms. If the temperature coefficient of copper at 0°C is 0.00427. What is the resistance at 100°C? 9. A wire has a resistance R are cut into 2 pieces and the small pieces are connect in parallel resulting to a total resistance of 2 ohms. What is the value of R?
(a) Determine the currents I1, I2, and I3 in the figure shown below. Assume the internal resistance of each battery is r = 1 ?. (b) What is the terminal voltage of the 6V battery?