1. Two solutions, A and B, are separated by a semipermeable membrane. Which of the followingstatements regarding their tonicities is NOT correct? Assume the same van ’t Hoff factor for eachsolution.a. If A and B are of equal molarities, they are isotonic.b. If the molarity of A is lower than that of B, solvent will flow from B to A.c. If the molarity of B is lower than that of A, B is hypotonic relative to A.d. If the molarity of A is lower than that of B, the osmotic pressure of B is higher than that of A.

Q: If the lead can be extracted with 92.5%% efficiency, what mass of ore is required to make a lead sph...

A:

Q: You placed 6.35 g of a mixture containing unknown amounts of BaO(s) and MgO(s) in a 3.50-L flask con...

A: The conversion of temperature into Kelvin units and pressures into at units can be done as,

Q: When chromium metal is added to nitric acid, the following reaction takes place Cr (s) + 6 HNO₃ (aq)...

A: The balanced chemical reaction is shown as follows:

Q: What are the common units for expressing solution concentration?

A: Common units:The expression for concentration of solution given by common units are Molarity, molali...

Q: Which of the following statements concerning equilibrium is not true?  a The equilibrium co...

A:

Q: Which one of the following substances would you predict to have the highest vapor pressure at a give...

A: Boiling point of a compound and vapor pressure will be inversely proportional. If boiling point is l...

Q: In normal blood, there are about 5.4×109 red blood cells per milliliter. The volume of a red blood c...

A:

Q: What is the pH of a 0.22M NaH2PO4 solution?

A: NaH2PO4 is a weak.Ka for NaH2PO4 is 6.23×10-8.Calculate concentration of H3O+:

Q: add the following masses: 465 mg, 0.000364 kg, 389 cg, and 3.40 dg. what is the total mass in grams?

A: The given values are converted into grams using appropriate conversion factors as follows:

Q: Lipitor, a pharmaceutical drug that has been shown to lower "bad" cholesterol levels while raising "...

A: Given,2.0g pill contains 7.5% of the active ingredient by mass.Then,25 pills contains = ?

Q: Nuclear power plants use nuclear fission reactions to generate steam to run steam-turbine generators...

A: Nuclear power stations required heat to produce steam to drive turbines and generators.

Q: According to the label on a bottle of concentrated hydrochloric acid, the contents are 36.0% HCl by ...

A: By considering the total mass of the solution be 100 g. The amount (m) of HCl present is 36.0 g. The...

Q: how can I find the molarity for this problem 5.15 gg Mn(NO3)2⋅2H2OMn(NO3)2⋅2H2O in 175 mLmL of solut...

A: Molarity of a compound can be calculated using the below given equation:

Q: Instant hot packs contain a solid and a pouch of water. When the pack is squeezed, the pouch breaks ...

A: The reaction is given below.LiCl (s)  -->  Li+(aq) + Cl−(aq)         ΔH=  −36.9kJHeat of reaction...

Q: Phosphorus-32 is a radioisotope used to detect certain types of tumors. P-32 has an effective half-l...

A: Phosphorus-32 is a radioisotope used to detect certain types of tumours. P-32 has an effective half-...

Q: How do I solve number 11?

A: The density of the substance can be described as the mass of the substance per unit volume. The chan...

Q: Which compound below will have the strongest dipole-dipole interaction between its molecules? cf4 ch...

A: Among the given molecules, the dipole moment of CF4 and CO2 will be zero due to their geometry. So t...

Q: A sample consisting of various gases contains 3.1×10−63.1×10−6 molemole fraction of radon. This gas ...

A: The pressure of radon gas is calculated as,

Q: How do you predict properties and name compounds

A: To predict properties and name of compound:The reaction of hydrogen with metals produces ionic metal...

Q: Describe the effects of the following conditions for TLC Samples are spotted to low on the plate Elu...

A: Samples are spotted too low on the TLC plate:It is recommended that samples should be spotted on the...

Q: 15. The pka for o-fluorophenol is 8.81. Draw the predominant form in solution at the given pH values...

A: Given information:pKa for o-fluorophenol = 8.81

Q: Record the number of signifcant figures in each one of the following numbers. e. 2.670 x 10^3

A: Given,

Q: What are isotopes?

A: The atoms of the same chemical elements with same atomic numbers but different mass numbers are know...

Q: assume that a milliliter of water contains 20.5 mL of water. What is the new water level after 41.3 ...

A: Volume of water = 20.5 mL

Q: Balance the following reaction with the states of matter. __Cu(NO3)2(--) + __Na2CrO4(--) ------> ...

A: According to solubility rules of inorganic salts, the salts of group I cations are always soluble. T...

Q: How much heat (in kJ) is required to convert 426 g of liquid H2O at 22.0°C into steam at 145°C? (Ass...

A:

Q: Propane can be turned into hydrogen by the two-step reforming process. In the first step, propane an...

A: The balanced equation can be defined as the chemical equation in which the number of atoms is presen...

Q: A carbon dioxide laser produces radiation with a wavelength of 1.06 x 104 nm.  What is the frequency...

A:

Q: Which of the following compounds is capable of hydrogen bonding? (only 1 correct) Select one: a. ...

A: Option (a):The CH3CH2CH3 compound has the ability for hydrogen bonding. 

Q: You have a 3.00-liter container filled with N₂ at 25°C and 2.85 atm pressure connected to a 2.00-lit...

A:

Q: Explain how the relative strengths of solute–solute interactions, solvent–solvent interactions, and ...

A: Salvation is the process of interaction of solvent particle with solute particle which assist the st...

Q: Conversions involving Density and Geometrical Relationships: How would I go about solving this quest...

A: Given,

Q: 0.78 L of nitrogen gas is collected over water on a day when the total atmospheric pressure is 1.02 ...

A: Given information:Total atmospheric pressure is 1.02 atm.Vapor pressure of water is 0.028 atm.Temper...

Q: The gap between valence and conduction bands in silicon is 1.12 eV. A nickel nucleus in an excited s...

A: Given, the energy gap between the valence and conduction band is 1.12eV and the wavelength of the ga...

Q: Since different isotopes of the same element have the same chemical behavior, how can they be separa...

A:

Q: Explain the organic compound in the body

A:

Q: The reactant concentration in a first-order reaction was 9.00×10−2 MM after 15.0 ss and 9.20×10−3 MM...

A: The equation for first order reaction is:

Q: Carbon disulfide has a vapor pressure of 363 torr at 25 °C and a normal boiling point of 46.3 °C. Fi...

A: Convert the values of temperatures T1 and T2 into Kelvin units by using the above relation.

Q: solve and put answer in scientific notation, rounding to the appropiate number of significant figure...

A: Given value is ( 9.381×108 ) – ( 6.009×105 )

Q: A chemist prepares a solution of copper(II) fluoride (CuF2) by measuring out 0.058g of copper(II) fl...

A: Given,Mass of CuF2 = 0.058 gVolume of solution = 300 mL = 0.3 L   (1 mL = 0.001 L)Moles of CuF2 can ...

Q: A chemist wants to determine the molar mass of a naturally occurring substance isolated from spearmi...

A: Given information:Mass of solute = 5.431 gMass of acetone = 25.00 gVapor pressure of solution (P) = ...

Q: How do I show my work for (4 x 103) / (2 x 106)?

A: Given,

Q: Which pair of compounds will form hydrogen bonds with one another? CH4 and H2O CH4 and NH3 HF ...

A: The pair of compounds that will form hydrogen bonds with one another is to be identified-CH4 and H2O...

Q: fill in the blank with the correct numerical value: decigram=   _____ grams millisecong=    ____ sec...

A: The given blanks are filled with appropriate values in step two.

Q: 19. From each pair, circle the stronger base. or or or or or CH,NH or CH,CH2

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,...

Q: The dissociation energy of the hydrogen molecule (i.e., the energy required to separate the two atom...

A: 1 eV = 1.6 x 10-19 JAverage kinetic energy is given by following equation.

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.