1. What is the difference between magnetic flux and mag-wise (b) yes, cournetic field?2. O Figure Q31.2 is a graph of the magnetic flux through acertain coil of wire as a function of time, during an intervalwhile the radius of the coil is increased, the coil is rotatedseparation occur in(b) yes, with the tothrough 1.5 revolutions, and the external source of themagnetic field is turned off, in that order. Rank the electro-motive force induced in the coil at the instants marked Athrough F from the largest positive value to the largest-magnitude negative value. In your ranking, note any casesof equality and also any instants when the emf is zero.Figure5. The bar in Figurvelocity v, anddirected out ofclockwise? If thebe the directionBDE FFigure Q31.23. O A flat coil of wire is placed in a uniform magnetic fieldthat is in the y direction. (i) The magnetic flux throughthe coil is a maximum if the coil is (a) in the xy plane(b) in either the xy or the y: plane (c) in the xz plane(d) in any orientation, because it is a constant (ii) Forwhat orientation is the flux zero? Choose the best answerfrom the same possibilities.Figat constant yelocity

Magnetic Flux over an area in a magnetic field is the total number of magnetic lines of force…

Answered: 1. What is the difference between…

Science

Physics

1. What is the difference between magnetic flux and mag- netic field? lux through

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter34: Maxwell’s Equations And Electromagnetic Waves

Section: Chapter Questions

Problem 13PQ

See similar textbooks

Similar questions

A 200-turn flat coil of wire 30.0 cm in diameter acts as an antenna for FM radio at a frequency of 100 MHz. The magnetic field of the incoming electromagnetic wave is perpendicular to the coil and has a maximum strength of 1.001012T . (a) What power is incident on the coil? (b) What average emf is induced in the coil over one-fourth of a cycle? (c) If the radio receiver has an inductance of 2.50H, what capacitance must it have to resonate at 100 MHz?
A particle of cosmic dust has a density =2.0g/cm3 , (a) Assuming the dust particles are spherical and light absorbing, and are at the same distance as Earth from the Sun, determine the particle size for which radiation pressure from sunlight is equal to the Sun's force of gravity on the dust particle, (b) Explain how the forces compare if the particle radius is smaller, (c) Explain what this implies about the sizes of dust particle likely to be present in the inner solar system compared with outside the Oort cloud.
A thin conducting bar (60.0 cm long) aligned in the positive y direction is moving with velocity v=(1.25m/s)i in a region with a spatially uniform 0.400-T magnetic field directed at an angle of 36.0 above the xy plane. a. What is the magnitude of the emf induced along the length of the moving bar? b. Which end of the bar is positively charged?
A uniform magnetic field B=5.44104iT passes through a closed surface with a slanted top as shown in Figure P31.59. a. Given the dimensions and orientation of the closed surface shown, what is the magnetic flux through the slanted top of the surface? b. What is the net magnetic flux through the entire closed surface?
You are working at NASA, in a division that is studying the possibility of rotating small spacecraft using radiation pressure from the Sun. You have built a scale model of a spacecraft as shown in Figure P33.47. The central body is a spherical shell with mass m = 0.500 kg and radius R = 15.0 cm. The thin rod extending from each side of the sphere is of mass mr = 50.0 g and of total length = 1.00 m. At each end of the rod arc circular plates of mass mp = 10.0 g and radius rp = 2.00 cm, with the center of each plate located at the end of the rod. One plate is perfectly reflecting and the other is perfectly absorbing. The initial configuration of this model is that it is at rest, mounted on a vertical axle with very low friction. To begin the simulation, you expose the model to sunlight of intensity Is = 1 000 W/m2, directed perpendicularly to the plates, for a time interval of t = 2.0 min. The sunlight is then removed from the model. Determine the angular velocity with which the model now rotates about the axle. Figure P33.47
Figure P32.21 shows a circular conducting loop with a 5.00-cm radius and a total resistance of 1.30 placed within a uniform magnetic field pointing into the page. a. What is the rate at which the magnetic field is changing if a counterclockwise current I = 4.60 102 A is induced in the loop? b. Is the induced current caused by an increase or a decrease in the magnetic field with time?
The potential difference V(t) between parallel plates shown above is instantaneously increasing at a rate of 107V/s. What is the displacement current between the plates if the separation of the plates is 1.00 cm and they have an area of 0.200m2?
Suppose a spherical particle of mass m and radius R in space absorbs light of intensity I for time t. (a) How much work does the radiation pressure do to accelerate the particle (mm rest In the given tine It absorbs the light? (b) How much energy canted by the electromagnetic waves is absorbed by the particle over this time based on the radiant energy incident on the particle?
A parallel-plate capacitor with plate separation d is connected to a source of emf that places a time-dependent voltage V(t) across its circular plates of radius r0and area (a) Write an expression for the time rate of change of energy inside the capacitor in terms of V(t) and dV(t)/ dt. (b) Assuming that V(t) is increasing with time, identify the directions of the elecuic field lines inside the capacitor and of the magnetic field lines at the edge of the region between the plates, and then the direction of the Poynting vector S at this location. (c) Obtain expressions for the time dependence of E(t), for B(t) from the displacement current, and for the magnitude of the Poynting vector at the edge of the region between the plates. (d) From S , obtain an expression In terms of ‘(t) and dV(t)/dt for the rate at which electromagnetic field energy the region between the plates. (e) Compare the results of pails (a) and (d) and explain the relationship between them.
A dish antenna with a diameter of 20.0 m receives (at normal incidence) a radio signal from a distant source, as shown in Figure P21.73. The radio signal is a continuous sinusoidal wave with amplitude Emax = 0.20 V/m. Assume the antenna absorbs all the radiation that falls on the dish. (a) What is the amplitude of the magnetic field in this Figure P21.73 wave? (b) What is the intensity of the radiation received by the antenna? (c) What is the power received by the antenna?
(a) What is the wavelength of a 1.00-eV photon? (b) Find its frequency in hertz. (c) Identify the type of EM radiation.
Figure P31.13 shows a uniform magnetic field. a. Can you find a (nonzero area) loop through which the magnetic flux is zero? If so, draw the loop and the field. If not, explain why not. b. Can you find a loop through which the magnetic flux is nonzero? If so, draw the loop and the field. If not, explain why not.