1.2.3 3. Use nodal analysis. please do complete kvl kcl solution solving thankyou

Q: The break operation of the I.M. at speed less than synchronous speed is: OWhen rotor rotates in the…

A: In this question,   We need to choose the correct options The break operation of the induction motor…

Q: The C-S MOSFET amplifier has three low break frequencies in low frequency band at fLI =1 Hz (caused…

A: The given circuit is as shown below,

Q: Show that the effective value cr (r.n.s) Sine wave Current w.th peak current Im in Im 2 d

A:

Q: a) An analogue system is shown in the block diagram of Figure Q3. Analogue x(t) y(t System Figure Q3…

A: An analogue system is one in which a physical value, such as voltage or current, is represented by…

Q: Q4) Explain briefly the principle of critical angle required for total internal reflection.

A:

Q: 10.) Find the r.m.s. value of the current if the voltage V3D210 sin (275t + Tt/2) is applied to a…

A:

Q: Design a MOD11 asynchronous counter from JK flip-flops

A:

Q: 26.) A voltage v = 220 sin (275t + Tt/2) is applied to a resistor of 12 ohms. Find the r.m.S. value…

A:

Q: The analysis of the voltage, V for the circuit given in Figure Q4 can be expressed in the following…

A: You have asked multiple independent questions. We are authorized to answer one question at a time.…

Q: Find the Laplace Transform of the following. Answers must be in a simplified form and solutions must…

A:

Q: Prefinall Tak 2 as -5S+3 の- (S+1) (S.2) (S+3)

A:

Q: Q4) Explain briefly the principle of critical angle required for total internal reflection.

A: We need to explain the concept of critical angle .

Q: A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of 158…

A:

Q: For The circuit shown below; find the currents of all Resistances using Kirchhoff's laws 28A 3 35 N…

A: In this question,   We need to determine the current in the each resistance using the KCL and KVL.…

Q: In an antenna array, the array factor depends on Tick all that apply. O Radiation pattern. O…

A:

Q: 4.1Two synchronous generators need to be connected in parallel to supply a load of 10 MW.  The first…

A: The solution is given below

Q: Table Q1(a) Location Load Nos. Estimated Power Demand Factor (W) 200 Chandelier lamp Fluorescent…

A: Note: As per the policy we can solve only 3-sub parts of a question, please re-upload the remaining…

Q: Draw the Thevenin and Norton equivalent circuits and reconnect the load resistor R, 2i, + I, 5002 )…

A:

Q: (b) Let x(t) be a real-valued signal with X (w) = 0 when |w| > 990n. Amplitude modulation is…

A: Brief description: Low pass filter is used to pass the frequencies which are within the higher cut…

Q: Why is it that the induction motor operate less than the synchronous speed?

A: The synchronous speed of an Induction motor can be explained as the speed of rotating magnetic field…

Q: (c) An angle-modulated signal is given by: x.(t) = 8 cos[2n(106)t + 0.3 sin(10³) nt]. (i)…

A:

Q: 17.Why the 1 ph IM is not self-starting ? 18.If there is 3 wires in the terminal box of 1 phase IM,…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: The balanced system below has a phase voltage of 120 V. It supplies a balanced load coil that is…

A: Given: V=120VR=3ΩL=.011HLet…

Q: Everyone in the middle east about the situation for decades.

A: In the given question, we have to select the correct tense for the situation. Since the sentence is…

Q: Adding resistance to the rotor circuit of :induction motor will Reduced the starting current and…

A:

Q: The PUT controlling is done through O Anode and gate OCathode and gate OGate

A: In this question we need to choose a correct option

Q: Give impacts of split phase induction motor on users

A: The  induction motor of split phase type is a single-phase induction motor having a starting or the…

Q: 10 Q j10 O j10 O ll ll 10 V [1] j5 V sine -j10 Q [12] sine

A:

Q: 37 -5 V Si Si 2.2 k2 6-5 V Figure 2 Determine the Voltage output Vo of the sketched circuit in…

A: We need to find out output voltage for given circuit

Q: A 1Φ alternator is rated at 15kVA, 460V. The armature resistance and reactance are 1.5Ω and 3Ω…

A:

Q: 22. A 7-segment decoder/driver drives the display in Figure 6-78. If the waveforms are applied as…

A: The BCD to 7 segment decoder will convert the input BCD number into 7 segment values.

Q: Given the discrete-time sequence z[n] = cos %3D Find two different continuous-time signals that…

A: It is given that : xn=cos2πn3fs=120Hz

Q: 440 Vac 400 Hz generator is connected to a series circuit with a 16 Q resistor, a 11.9-m inductor,…

A: In this question we will find power factor of given series circuit.....

Q: Given a Y-connected 12 MVA synchronous generator rated at 15 kV. The armature resistance is 0.08 2…

A: Given information about a Y-connected synchronous generator is written below. Rated output, S=12…

Q: Q3) State four features of Light Emitting Diode (LED).

A:

Q: In the circuit shown below, a three-phase star-connected unbalanced load is connected to a balanced…

A: The given circuit is  From the above circuit we can analyse that n and n' are at same potential…

Q: In your own idea using various types of single-phase induction motors, give 2 impacts to the…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Determine the output voltage for each circuit (a), (b), (c), and (d) below. 1 k2 10 k2 +12 V 8 k2…

A: We need to find out the output voltage for given opamp circuit

Q: In the circuit shown below, a three-phase star-connected unbalanced load is connected to a balanced…

A: In this question,   We need to determine the value of impedance Zc if voltage difference across the…

Q: 2. Identify what type of amplifier the circuit is, and solve for the output voltage. if 42 V1=2V Vo…

A:

Q: 17.) Calculate the force experienced by the conductor of 2 meters long, carrying 80 amperes, placed…

A: The solution is given below

Q: six poles three-phase squirrel-cage induction motor, connected to a 50 Hz three-phase  feeder,…

A: Induction motor is singly excited AC machine in which , AC supply given to the stator generates a…

Q: Pullout torque Slip at pull out torque Rotor speed at pull out torque

A: Given line voltage VL=460V Phase voltage Vph=4603=265.58V Synchronous speed Ns=120fp=120×604=1800rpm…

Q: 20.Under no load condition, the magnetizing current drawn from the supply is more than the real…

A: 20. Under no load condition, secondary is open circuited and hence there will be negligible real…

Q: For the circuit shown below, use the superposition theorem and solve for the following: a. The…

A:

Q: What is the  phase relationship    between    the  voltage    across     the resistor VR and the…

A: In this question we will write about series RC circuit voltage relationship...

Q: In power factor correction where a motor load is normally operating with 1000 inductive vars, a…

A: In this question,   We need to explain the why inductive VAR power is compensation by the capacitor?…

Q: Create the gray code representation of the following binary numbers. i) 11101 ii) 01101 iii) 10111…

A: Binary to Gray code conversion:

Q: -Determine: (a) the value of the current i for t 0, (b) the capacitor voltage at all times, and (c)…

A: In this question,   we need to determine the current i as shown in the circuit and voltage across…

Q: Draw the equivalent circuit if you are going to perform Short cuit Test(SCT)(at terminals a-b, with…

A:

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.