10  Another term for a capacitor is a/an ___________. Select one: a. capacitive resistor b. energy resistor c. condenser d. capacitive regulator

Q: Q2) The figure (b) represents the step response of a linear system. i) Find the order of the system....

A: Step response of 2nd order system is given by:  

Q: 1. Use NODAL ANALYSIS to determine the branch currents: 11, 12, 13, 14, 15. 50 V A 35 Ohm 25 Ohm 25 ...

A: The solution is given below 

Q: D: has been eaten

A: Answer According to given information

Q: 4. A cylindrical steel pressure vessel 250 mm radius with a thickness of 20 mm, is subjected to an i...

A:

Q: A Platinum RTD transducer has a resistance of 100 ohms at 0 degrees celsius, 149 ohms at 120 degrees...

A:

Q: consider the following diagram of impedances in per unit of a common base a) get the YBus admittance...

A:

Q: A solenoid 10 cm long is wound with 300 turns of wire. The solenoid needs a current of 1 A in order ...

A:

Q: z = tanh(4-j5)

A: The solution is given below 

Q: Find i and Vo in the circuit below:

A:

Q: How many lines are there in an NTSC signal? a) 1024 b) 1856 c) 625 d) 525

A: The NTSC stands for National Television system Committee and the NTSC Signal is used in television s...

Q: Example2: Given the schematic, with R1=50, R2=42 R3-42, and Vsource=28V, find the value voltage V1, ...

A:

Q: 3nu(-n) 0.1nu(-n) + 0.2nu(-n) Determine if stable system or not using infinite geometric series form...

A:

Q: Determine each statement if it is TRUE or FALSE. A1. The sum of the homogeneous and particular solu...

A: A1. Answer: True Explanation: The response of any LTI system is the sum of the homogeneous solution ...

Q: 6. A circular coil has a mean diameter of 100 cm having an electron density of 3.34 x 1024 e/m³ with...

A: The solution is given below

Q: Design an op-amp circuit to yield the relationship shown in each equation. Vo = V1 + 10V2 – 3...

A: a) Assuming, Rmin=Rf=6kΩ Inverting input V1 and V2 using inverting amplifier: Taking Rin=Rf, The ou...

Q: Discussion: 1) What is the effect of the inductive load on the circuit? 2) What is the advantage for...

A: The circuit shown above in the figure is a half wave rectifier having freewheeling diode connected t...

Q: A power transformer rated 8MVA, 34.5 kV/230 V is connected delta-delta.What is the current of the LV...

A: The solution is given below. 

Q: (i) Draw the load line for the diode circuit in figure 1. (ii) Calculate Ip, given VD is 0.65 V, and...

A:

Q: Q3: For the potentiometer in the below network: 1- What are the voltages Vab and Vbc with no load ap...

A: In this question We need to determine the voltage Vab and Vbc with no load applied and with potentia...

Q: The system is given by a block diagram: G3(s) R(s) Y(s) G1(s) G2(s) E(s) H2(s) H1(s) a) Simplify the...

A: The solution is given below

Q: Styles Find the poles and zeros for the systems with the following transfer function. Plot the zeros...

A:

Q: armature winding of a 200-V, 4-pole, series motor is lap-connected. There are 280 slots and each slo...

A: We need to find out speed for given motor   

Q: Q3:- The overshot of the step response of a second order feedback system is 30% and settling time is...

A:

Q: Convert 100 Hp into its equivalent Watts.

A: In this case, 100 Hp of power is to be converted into its equivalent power in watts. 

Q: 4. A copper wire has a length of 3500 ft and having an area of 144 cm squared. Find the resistance o...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Evaluate the following complex number (302 60° + 202-20') b. 302-30 + (4 - j3)(3 + j4)(4 - j5)* c. [...

A: The solution is given below

Q: Primary current in a current transformer is determined by Group of answer choices The load on its o...

A:

Q: 15. Use mesh analysis to find il, i2, and i3 in the circuit shown below: iz 8 Ω Vo 2Ω 3 A 12 V (+ iz...

A: Given

Q: 2. Use MESH METHOD to determine the (1) LOOP currents IA, IB, IC and ID (2) BRANCH currents Ix, ly a...

A: The solution is given below

Q: 4. Sketch the following functions a. u(t) the unit step function b. 8(t) the delta dirac function c....

A:

Q: 3nu(-n) 0.1nu(-n) + 2nu(-n) Determine if stable system or not using infinite geometric series formul...

A: If the GM series converge to a finite value then the system is stable otherwise Unstable.  

Q: Question No. 4: For the below circuit, assume that: V:(t) = 20 cos(wt+30°) V2(t) = 10 sin(wt+60°) V3...

A: In this question,  We need to write the polar representation.  Polar form is representation by rms v...

Q: Q5. For a PNP Bipolar Junction Transistor base-emitter voltage, VBE is 0.7 V at collector current, I...

A: We need to find out the base , emitter current and saturation current.

Q: + Vcc = 20 V R, = 18 kn Rc = 1 kl Cout Bac = 200 R= 1.5 k Vn = 25 mVpp RE = 240 N R = 2.7 kN CE

A:

Q: (m) A B t2 y(m) 6. 7

A: As per the guidelines of bartleyby I need to answer first three subparts only.

Q: a. When the number of poles in a squirrel-cage motor is changed from 4 to 8, the speed is

A:

Q: 4-5 Compute the following if Voltage supply is 143 Volts <3. A. total capacitance B. total charge 4....

A:

Q: 5. Make an exhaustive list of all the electronic communication products that you own, have access to...

A: Electronic communication products A communication system that uses electronic media to transmit info...

Q: please help me with this question

A:

Q: Determin R.

A:

Q: Example: If the analog signal to be quantized is a sinusoidal waveform, that is x(t) = Asin(2 x 103t...

A: Brief description : In pulse code modulation depending upon the message signal the formula of signal...

Q: Z1 V1 3PH 120V 60HZ

A:

Q: Q.2: Discretize the following continuous-time state space model (state equation) using the sampling ...

A:

Q: 2. A wire is 4 in x 0.5 in x 20 ft and a resistivity of 15.75 (2 - CM)/ ft at 12 °C. Calculate its r...

A:

Q: D Question 5 A dynamical is defined by the Frequency Response Function H(w) = a +2iw, with a=17.6. T...

A: The solution is given below 

Q: Question No. 1: Answer the following Questions: 1. Compute the polar coordinates of a) z1 = -1 - j b...

A: Cartesian and polar forms play an important role in Electrical engineering. especially in AC circuit...

Q: Solve the equation using Cramer's rule (10 + j20)I, -+ j10I, = 60/30° (13.3.1 For mesh 2, j101, + (j...

A:

Q: How many lines are there in an NTSC signal? a) 1024 b) 1856 c) 625 d) 525

A: The message signals have less frequency. With this less frequency, it is not possible for the messag...

Q: Given the graph of the cosine function f (x) = cos x, evaluate the following limits: 27 37 1. lim co...

A:

Q: A - B . C D.

A: The given question is a three level circuit in which input A,B and C are connected to NOT gate. The ...

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.