– 10 cm 10 cm 20 cm

Q: 1.17JThe centrifugal pump in Fig. P11.17 has r = 15 cm, r, 25 cm, b, = b2 = 6 cm, and rotates…

A: The given data is: ρ=998Kg/m3 β=150° α1=90° ω=600 rpm    =600×2π60    =62.8 rad/s

Q: Q-6: You have been assigned to check the stability of a pond constructed in stiff clay underlain by…

A:

Q: Q3 :An inverse conical tank with a diameter of (1 m) and height of (7 m) filled with water. A hole…

A: Given data :  Diameter of cone (d) = 1 m  height of Cone (h) = 7 m  radius of hole in centre (r) =…

Q: A Rectangular channel (n = 0:011) 18 m oide to carry wwater at The slope d the channel s 0.00078 (9)…

A:

Q: A sharp edge orifice 105-mm diameter, in the side of a tank having a horizontal cross-section 2m…

A: d=105mm H2=2m Cd=0.6

Q: Situation 14: A tall cylindrical tank 150mm in diameter contains water 200mm deep and oil (s = 0.80)…

A: A. Given: Weight of buoy=5 N Diameter of Buoy= 100 mm Height of buoy=120 mm Volume of…

Q: For the open tank, with 5 points piezometer attached on the side, contains three immiscible liquids…

A: As we know, At inlet of liquid into piezometer gauge pressure will be same from both side i.e.…

Q: Water flows into a large tank at a rate of 11 Ips (liters per second) as shown. The water leaves the…

A: Bernoulli theorem : Bernoulli's principle asserts that an increase in a fluid's speed occurs at the…

Q: The three-tube system consists of 0.5 m diameter tubes shown. The center of rotation is at the…

A:

Q: A discharge of 150 liters per second is to be measured by a V-notch of vertex angle 60°. What would…

A: Given- Discharge Q=150 l/s=0.15 m3/sVertex angle θ=60odH=1 mmCd=0.62Head over the vertex and error…

Q: Q3. A well pumping from a unconfined aquifer at steady rate of 293 m³/hr. Two observational wells…

A: The mathematical expression for discharge through two observation well at different radial…

Q: 3. A vertical storage tank with a hemispherical bottom and cylindrical shell of 4m internal diameter…

A:

Q: To what height mercury rises in the U-tube in the figure below? Elev 6 m Elev 5 m Air pressure-30 k…

A: To find value of h

Q: A wooden pole (sp.gr. = 0.55)550 mm. in diameter, has a concrete cylinder (sp.gr. = 2.5) 550 mm.…

A:

Q: 1. A reservoir has a sidewall, inclined backwards 30° from the vertical in which is an orifice…

A: h1 = 3m h2 = 2m Cv = .97 θ = 300

Q: From the 352 mm by 106 1.2 m mm venturi meter (C=1) compute the deflection of in the mercury…

A:

Q: A pipe carries an oil of specific gravity 0.8 with pressure 19.62 kPa. The pipe is 3.5 m above datum…

A:

Q: a 100mm height cylinder with specific weight of 5kn/m^3 is submerged ina a a fresh water with…

A:

Q: Determine the velocity inside the pipe 0.5-m-dlameter using the pitot tube installed. The difference…

A: Difference in head and pipe diameter have been given and it has been asked to determine velocity…

Q: A manometer with mercury (S-13.6) is connected to a pipe carrying water (S-1). If the manometer is…

A: Given data in question  Water as fluid in pipe  Manometric liquid is mercury Specific gravity of…

Q: of the large tank showed a discharge of 590 N of water collected in 81 seconds, when under a…

A:

Q: A sight is taken with an engineers level at rod held 100 m away, An initial reading of 1.83 m was…

A:

Q: Example 8.10 For a head of 25 cm on a 90° V-notch, what error in the measured heac produce the same…

A:

Q: P.7.5 Find the throat diameter of a Venturi meter when fitted to horizontal pipe 10 cm diameter…

A:

Q: exact answer. 2.43

A:

Q: Problem 1 - 29 A vertical cylindrical tank with a diameter of 12 m and a depth of 4 m is filled with…

A:

Q: A reservoir contains water has a vertical circular orifice 25.2mm diameter and is first plugged up…

A: Given : H = 2.785m QL = 141 lt/min = 2.35 × 10-3 m3/sec   Cc, Cv, and Cd are the hydraulic…

Q: 10. Calculate the maximum velocity of slider B if the system is released from rest with x=y. Motion…

A:

Q: Home Work P.3.1 Two pipes A andB carrying water are connected by a connecting tube as shown in…

A: The figure is as shown

Q: 2 When the pitot tube is moved vertically inside the pipeline, why does it yield different flow…

A: Note-  Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the…

Q: A 60 mm dia. siphon is drawing water from an oil reservoir as shown. If the head loss from 1 to 2 is…

A: Given:-  A 60 mm dia. siphon is drawing water from an oil reservoir as shown. If the head loss from…

Q: 1. A horizontal venturimeter with inlet diameter of 200 mm and throat diameter of 100 mm is used to…

A: As per bartleby policy, I can answer only the first question. If you want the answer for remaining…

Q: Vertical Q6) The flow-metering device shown consists of a stagnation probe at station 2 and a static…

A:

Q: A 60 mm dia. siphon is drawing water from an oil reservoir as shown. If the head loss from 1 to 2 is…

A: D=60mm To find velocity of flow at point 3

Q: Question 13 In the illustration: A B 2 D All friction factorf = 0.02 All pipe lengths L = 250m…

A: This problem is related to pipe flow from Fluid Mechanics. In this problem given about Diameter and…

Q: A vertical conduit is carrying oil (S = 0.95). A differential mercury manometer is tapped into the…

A: Given data : Specific gravity (SOil)=0.95Specific gravity (SMercury)=13.6 Unit weight of water…

Q: Q1// A well pumping at a uniform rate was shut down after 200min; thereafter. measurements of s' and…

A: This question is related to the Soil Mechanics.

Q: in Fig. (4) has a 4- piug Will pop dlut if the hydrostatic force df it reaches 25 N. For °20C…

A: F=25N diameter of plug=4cm

Q: what is the Value of (P-P)in N/m? the water in the manometers is air7 27Above Air 90mm H00 mm 2Somm…

A:

Q: The head of water over the center of an orifice of diameter 80 mm is 4.5 m. Find the theoretical…

A: Dia of the orifice (d) = 80mm Head of water over the head (h) = 4.5m Determine theoretical velocity…

Q: Two water tanks are connected to each other through a mercury manometer with inclined tubes. For a…

A: Given two water tanks,

Q: If the inlet diameter of the holding tank is 35cm and the outlet diameter is 30cm and the diameter…

A:

Q: A centrifugal water pump is tested under its design flow rate Q=250 m/hr. The static pressure at the…

A: Given Discharge   Q=250 m3/hr=0.0694  m3/secpressure  P1=1.2 bar=120 KPaand at outlet end   P2=8.5…

Q: Q3)A differential manometer is connected at two points A and B of two pipes. The pressure at A and B…

A: Solution- Given,   At A pressure is given by,PA=1 bar=100kN/m2PA=1 * 105kN/m2At B pressure is given…

Q: Depth of flow (y) in various cross-sections, R, = y Depth Yupstream mm 100 Ус 15 10 Ybefore the jump…

A:

Q: A tank has one of its side inclined inward at an angle of 30 degrees with horizontal. The free…

A:

Q: Vnich parameters do Barometer and Manometer measu o Pressure difference; Atmospheric pressure o…

A: solution  1.barometer measures atmospheric pressure  while the manometer pressure difference between…

Q: a) By using U-tube manometer how can you find out the pressure head? b) If you are lacking of…

A:

Q: An open circular vessel is 1m in diameter and 2m height. It contains water filled to a depth of…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?