10) Eight different students tuned in the circuit for resonance and the values ofresonant frequency in kHz were recorded as 412, 428, 423, 415, 426, 411, 423, 416 Calculate the following: (a) Arithmetic mean (b) Average deviation (c) Standard deviation (d) Variance.

Q: Determine the Laplace transform of the function shown and simplify. e2t+a (2 cos at – 3 cosh 2at)

A:

Q: How does an XOR gate schematic symbol differ from an OR gate symbol? Select the correct response: It...

A:

Q: In a tansistor, IC = 100 mA and IE = 100.2 mA. The value of B is. .......... а. 100 О. 50 O c. about...

A:

Q: Two resistors, R1 = 100 Q and R2 = 200 N are connected in parallel. If the current through R1 is 1 A...

A:

Q: 3. The antenna used for sky wave propagation is elevated at an angle of 30 degrees. Find the MUF if ...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Why there is a need to study Electrical skill problems?

A: Electrical skiil

Q: 3. Find the value of i. 2 A 20 V (+ 4Ω 16 V 3.

A:

Q: What does modulation/demodulation refer to and how analogue signals can be used/modified for the pur...

A: Data communication- The process of transferring information from one computer to another is known as...

Q: What is the total resistance of two equal valued resistors in series? Select the correct response: T...

A:

Q: Briefly explain each of the following topics: a. GPS system b. Traditional TV and HDTV

A: Satellite Communication  The communication links between various points on earth by the use of artif...

Q: (c) Determine with justification whether each of the following functions R →R is one-to-one, onto or...

A: The solution is given below 

Q: Activity 2 – Let’s solve it! Solve and answer the following problems using the concepts of dielectr...

A:

Q: If

A:

Q: Vcc Ic 2.2 k2 RB + VCE = 7.2 V B = 20 µA %3D IIE = 4 mA 812 Kohm 100 Kohm

A:

Q: 10.Analyze the following sequential circuits (derive the state transition table and the state diagra...

A: This is a problem of digital circuit. The solution is given below

Q: A conducting plate of thickness d carrying the current density of the field is placed in a region wi...

A: Answer - 

Q: 4.39 In the circuit shown in the image below, if R1 = 26 Q, V1 = 43 V, and /4 = 6.0 A, determine the...

A:

Q: 3. 3-phase system Y-A Phase voltage at load=100/O v has z =12+j12A/ Phase impedance of each Line =1+...

A:

Q: i = 12.5(1-e-t/CR) You have been asked to determine the time taken for the current to rise f...

A: Given, i=12.5(1-e-t/CR)R=140C=90i1=1 Ai2=2 A  

Q: What is the dimensioning system shown in the figure below? +1.31 67 .31 .51

A:

Q: What relation exists between the primary and secondary currents and turns? Subject Electrical Appara...

A:

Q: 3-ohm resistor is connected in parallel

A: Resistance in parallel-1/Req=1/R1+1/R2+1/R3+........... Resistance in series-Req=R1+R2+R3+.............

Q: Which gate does the following circuit represent? + V A Surce is study ared va В - A. XOR B. XNOR C. ...

A: Given, Implementation of logic gates using CMOS . The Answer for the above question is option D .i e...

Q: A lead wire and an iron wire are connected in parallel. Their respective specific resistances are in...

A: In this question we will find wire ratio of area with given length , current and specific resistance...

Q: Question 3. Answer the below questions for the given combinational circuit W3 W1 W2 y W4 Figure 1. C...

A:

Q: An Input Variable for an electric motor system could be: O Motor Mass Rotor Angular Position Supply ...

A: Electric motor converts electrical energy into mechanical energy. Here out is in the form of angular...

Q: Determine the total charge transferred over the time interval of 0 < t< 9 seconds whet i(t) = (1/2) ...

A: The solution is given below 

Q: What variable remains constant for both series only and parallel only connections?

A: Series - CURRENT parallel - VOLTAGE

Q: H.W: Ske tch xcn)= 2" sin ( n)ucn) fun. Hints {^= (2')"= (t)"=65)"> decreasing exp Fun %3D %3D

A: The time domain signals can be continuous or discrete. The time domain signals can be periodic as we...

Q: Assume an operational amplifier is working on inverting amplifier in which it takes input resistance...

A: Given that Ri=30ΩRf=60ΩVi=150volt

Q: ... RG RL 50K 1K 20 Vpk-pk 1 Hz SCR Use IGT=1mA and VGT=1.2V Plot the input and output graphs, label...

A: The Circuit diagram is shown below, Here,IGT = 1mAandVGT=1.2V

Q: For 100 kW 40 m horizontal axis wind turbine is operating at an average windspeed of 8 mis. Assuming...

A: In this question,  We need to determine the power coefficient?  If wind power P= 100kW,  40m horizon...

Q: V For the circuits given below find the voltage of drain , source and gate ( Vo ,Vs ,VG) of each cir...

A: Given: Circuit diagram

Q: (b) Draw open and short circuit characteristics using the following data for 13kV ,150 MW,0.8 pf mac...

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part y...

Q: E1 +22 V 三 R, 340 V R1 R3 18 N E, = +22 V +

A:

Q: Which type of controller mode builds up corrective action proportional to the length of time the dis...

A: Controller mode- The method used by the controller to correct the error mode control. The four most ...

Q: S) The following 10 observations were received in the case of an ammeter: 41.7, 41.8, 42, 42, 42.1, ...

A:

Q: A 1-phase, 20 km line delivers a load of 12 MW at 22 kV having a lagging p.f. of 0.65 at the receivi...

A:

Q: An electric stove with four burners and an oven is used in preparing a meal as follows. Burner 1: 40...

A: The solution is given below 

Q: ulate the total charge

A:

Q: For the diode circuit of the figure below: 1. Determine v, and sketch its waveform for at least 4 cy...

A:  

Q: In order to measure the power taken by a small 220-V 60-Hz single-phase induction motor, it is conne...

A:

Q: X1(s) 1. Solve for G, (s) G2(s) F(s) ' X2(s) F(s) x,(t) X:(t) K,-I N/m K2-1 N/m fin f,= 2 N-s/m M, =...

A: Solution-  Using newton's law, we had the equations of motion for the given system, m1x1''+fv1+fv2x1...

Q: 2. Choose between one of these two design problems a) Design a 4-bit synchronous counter which count...

A: This is a basic problem of counter design The solution is given below

Q: Determine the proper size of copper wire conductor necessary to apply a 750 W electric motor that is...

A: It is given that: P=750 WL=100 feetVpanel=120 voltsVdrop=1.2 volts

Q: 3. Three particles of charge +70, +48, and -80 µC are placed in a line as shown below. Calculate the...

A: Electron-An electron is a fundamental particle, unlike protons and neutrons which are made up of par...

Q: A 60-ohm resistor is in parallel with 100-ohm resistor. Current in 50-ohm resistor is 7.2 A. What is...

A:

Q: The power in a circuit consisting of two equal resistors in series is known to be 5 watts. If the tw...

A: Given that 

Q: The numerical values of the voltages and currents in the interconnection seen in Fig. P1.27 are give...

A: If the current direction is in positive terminal element consumes power and if it is outside the pos...

Q: Prove that the transfer function of a first order low pass filter is H(f)=1/(1+j f/f_B )

A: In this question,  Prove that the transfer function of a first order low pass filter is H(f)=1/(1+j ...

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.