10 Q Source "C" ЗА 15 Ω: 12 Q) Source "A" 2 A Source "B" Source "D" 30 V 15 V Figure #1 By applying the Superposition Theorem, determine i. The current flowing through the eight-ohm (82) resistor ii. The power absorbed/supplied by the Two ampere (2A) current source iii. The total dissipated in the circuit

10 Q Source "C" ЗА 15 Ω: 12 Q) Source "A" 2 A Source "B" Source "D" 30 V 15 V Figure #1 By applying the Superposition Theorem, determine i. The current flowing through the eight-ohm (82) resistor ii. The power absorbed/supplied by the Two ampere (2A) current source iii. The total dissipated in the circuit

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.17MCQ: Consider the load convention that is used for the RLC elements shown in Figure 2.2 of the text. A....

See similar textbooks

Similar questions

The subject is: Smart Grid Please send the answer by typing ONLY. I don't want any handwritten. Q1- A 3 phase feeder having a resistance of 3 ohms and a reactance of 10ohms supplies a load of 2 MW at 0.85 pf lagging. The receiving end voltage is maintained at 11kV by means of a static condenser drawing 2.1 MVAr from the line. Calculate the sending end voltage and p.f. Also find the voltage regulation and efficiency of the feeder. Assume Delta connected.
An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cyclesource is then impressed across the combination. If the voltage drops across the coil andthe fixed resistor are 70 and 80 V, respectively, when the circuit current is 1.4 A, calculatethe resistance and inductance of the impedance coil. PLEASE ANSWER ASAP
Consider a house that has a 120V mains with mains frequencyof 60hz and a service current of 100A, which follows the safety standards of theresidential facilities.(a) Calculate the maximum power capacity.(b) Within the safety limit, the following devices can all operate at the sametime? If yes, what is the total power consumed? If not, what happens if all devicesare turned on at the same time and suggest a solution to the problem?- 4800W clothes dryer.- 400W washing machine.- 1200W dishwasher.- 1000W iron.- 860W air conditioning.- 150W color television.- 110W stereo sound.- 2400W electric stove.- 1200W microwave oven.- 1800W cooler.(c) Assuming that 60% of the maximum power were used daily, what is the total costper month for a kWh value of 10 cents?(d) Sketch the waveform, determine the phase difference and calculate the rms values of thefollowing waveforms: v(t) = 60 sin(wt + 20) and i(t) = 12 sin(wt - 20).
In a house there is a three-wire system configured as follows. A refrigerator with an impedance of (10 + j 10) Ω is connected to line L1 and to neutral, and to line L2 and neutral all the lighting in the house consists of 10 luminaires of 20 W each. In addition, there is a 240 V dryer that consumes 8 kW. Calculate a) current of line L1 and line L2 and neutral b) total power consumed.
An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cyclesource is then impressed across the combination. If the voltage drops across the coil andthe fixed resistor are 70 and 80 V, respectively, when the circuit current is 1.4 A, calculatethe resistance and inductance of the impedance coil.
1. A resistor, in series with a 138-microfarad capacitor, is connected to a 60-cycle source. If the voltage drop across the capacitor is 115 volts and the power taken by the circuit is 922 watts, calculate (a) the circuit current, (b) the ohmic value of the resistor, (c) the line voltage, (d) the circuit power factor. Please show complete solution and the circuit diagram. Please round off answers up to the 3rd decimal place. Thank you!
In your solution, follow the sequence: Given, unknown, solution, and final answer. BOX your final answers. thank you! 13. If R=10 ohms and L=0.05 henry are connected in series and energized by a 25 cycle sinusoidal voltage, the maximum voltage of which is 150 volts. Calculate the (a) impedance (b) instantaneous voltage (c) instantaneous current (d) instantaneous power (e) average power delivered to the load.
You have been privately contacted to rewire a site. During a visit, you observed that the building receives a 400V, 60Hz, star-connected, three-phase supply from the utility. There are also several three-phase equipment that require a 230V three-phase supply. You have decided to utilize three single-phase, dry type transformers to step down the building’s incoming supply to a 230V, delta-connected supply for the equipment. All the three-phase machinery can be modelled as an equivalent balanced three-phase star-connected load with a resistance and inductance of 0.5Ω and 0.16mH respectively per phase. Some preliminary calculations and analysis are required before starting the wiring design.Draw a labelled diagram of the entire three phase system clearly showing all known voltages (phase and line values) and the three phase configurations of all components.
2.) A multifamily dwelling having 59 units has a total load per dwelling of 21,300 VA. Compute for the Maximum current rating if the number of phase is 3 and nominal voltage is 400. Round off answer to four decimal places if necessary 3.) Compute the KVA basis of this school using optional method service load calculation with following details. ROUND ANSWER TO FOUR DECIMAL PLACES if necessary. Total load = 748 KVA Total area = 2,933 sqm 4.)Compute the total VA of a show window that is 5m
Referring to the Figure 1 below, given the value of frequency, f =50 Hz Determine: - i) The phasor domain equivalent circuit ii) The value of voltage source, Vs iii) The value of voltage, Vo Write your answer in 3 decimal places.
Dont copy paste need new SOLUTIONs.solve with diagrams with clean Handwriting or understanding solutions A single-phase 60-Hz power line is supported on a horizontal crossarm. The spacing between conductors is 8 ft. A telephone line is supported on a horizontal crossarm 6 ft below the power line. The conductors of the telephone line are AWG No. 14 solid copper (d = 1.6277 mm) spaced 2 ft between centers. The conductors of the power line are AWG No. 2 solid copper (d = 0.2576 in). Find the mutual inductance between the circuits and the voltage per mile induced in the telephone line if the current in the power line is 150 A.
A three phase energy meter having a meter constant of 0.12rev/kWh isused with a potential transformer of ratio 22000/110V and a currenttransformer of ratio 500/5 amperes. When connected to a load of unitypower factor , the disc makes 40 revolutions in 61 seconds. If theinstrument readings are 110V and 5.25A, find the percentage error.