10. A 110-Volt AC line feeds two circuits in parallel. The currents are (2.2 – j6.5)A and(1.8 – j3.5)A. The power consumed by the two circuits is approximately 11. The current thru an inductor with inductance of 1mH is given as i(t) = 0.010sin10°t A. What is the voltage across this conductor?

10. A 110-Volt AC line feeds two circuits in parallel. The currents are (2.2 – j6.5)A and(1.8 – j3.5)A. The power consumed by the two circuits is approximately 11. The current thru an inductor with inductance of 1mH is given as i(t) = 0.010sin10°t A. What is the voltage across this conductor?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.27P: An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8...

See similar textbooks

Related questions

Q: I need help understanding how to use KVL and KCL to get the equations for the dependant source varia...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: A charge located at the origin in free space produces a fields for which Ez=2kV/m at point P(-2, 4, ...

Q: 10.12. An LTI diserete-time system has the impulse response (0.9Y"u[n]. (n) Determine whether this s...

A: The solution is given below

Q: he rotor is star connected and has an impedance of (0.8 + j6) ohm per phase. Find the rotor current ...

A: Solution- Given, Rotor impedence = 0.8+j6 ohm Stator impedence = 4+j3 ohm Voltage = 65 V sl...

Q: Consider the Fourier scries of a square wave function given by 1 if -1<t < 0 f(t) = u(t + 1) + u(t) ...

A: The given square wave is shown below: It is given that: ft=ut+1+ut-2ut-1=1 if -1<t<02 if ...

Q: Evaluate the integral: 3 I= ƒ (t° + 8) [8 (t) + 95 (t – 1)] dt. -1 Express your answer using three s...

Q: 1. How can you draw the spectrum of FM?

Q: 1. How can you draw the spectrum of EM?

A: We are authorized to answer one question at a time since you have not mentioned which question you a...

Q: 6. R=_kQ |= 4 mA E = 6 V

A: This can be solved by using KIRCHOFFS voltage law Here current is flowing from load to source So loa...

Q: Q Q2: 20 volts Zener diode is used in the circuit of fig. (1), if I zan is (400) mAmp., I zin is (10...

Q: *Dont use Mernel Egns VDD common source amplifier VinoHEM2 sdlve usng KCL and KVL Vout A pply the me...

Q: 3. R=__Q 1=12 mA E= 12 V

Q: In a BJT fixed bias configuration, if the base supply voltage (VBB) is set to zero, what will be the...

A: We need to select correct option for given statement

Q: Vcc Vec = 20V R1- 40 kohm R2- 10 kohm Rc -4 kohm RE-2 kohm Rs=1 kohm RL = 22 kohm Cs- 10 uF Ce-1 uF ...

A: We need to find voltage gain for given circuit

Q: The voltage v = 214 sin(100t+50°) V is connected acroos a 215-µF capacitor. Determine the capacitive...

Q: Suppose that the signals x[n], x2[n] and x,[n] are given by 2mn and rfn] ='c2=nu20 ). 2mn xi[n] = co...

Q: QUESTION 25 Each of the following will improve a memory chip except more memory locations longer acc...

A: The solution is given below

Q: Theoretical Calculations: 5. Name five other application for op- amp, sketch their circui and their ...

Q: A 10-HP single-phase AC motor is connected to a 200-volt line. What will be the full-load running cu...

A: The solution is given below

Q: Obtain the transfer function of the electrical system. E¡ (s) R R

A: Since you have posted the multiple questions so we are supposed to answer the 1st one.

Q: What frequency is 3 octaves below 40 kHz? 100 Hz 1 kHz 5 kHz а. b. с. d. 15 kHz

Q: Q3. Using the Laplace transform tables, find the Laplace transforms of the following functions for t...

A: There are some standard derived transforms of functions Just use them The given function is sum of s...

Q: 6. R=_kQ |= 4 mA E = 6 V

Q: 1. For the following circuit assume r = 30.6 1 Vee 16V a. Draw the small signal equivalent circuit. ...

A: Given question is related to bjt in common emitter configuration it can be used as power amplifier

Q: 9.6 V VDc 9.2 V T= 8.3333 ms Ripple Factor = 8.6957% The Full Wave (Bridge) Rectifier Si Diodes vi L...

A: Frequency is the reciprocal of time period (T)

Q: x(n): n, 0 < n< 3 0, otherwise

A: Given sequence shown x(n)=n0≤n≤30otherwise

Q: C R2 R Figure 15.1 A A first-order low-pass filter.

A: for ideal op amp non-inverting terminal voltage(V+) is euqal to inverting terminal voltage(V-) ie...

Q: 2. Design a 3-bit ALU which can perform 5 micro-operations - AND, NAND, OR, NOR, and XOR. Do provide...

Q: What is the difference between wound rotor induction machines and squirrel cage machines

A: The wound rotor (also called as slip ring) and squirrel cage machines are the type of rotor in induc...

Q: a. The total vector voltage in rectangular coordinates. b. The magnitude of the voltage that a voltm...

Q: A short transmission line connects a step-up transformer on the source side with a series impedance ...

A: It is given that: ZSD=j50 ΩTurn ratio of step-up transformer=1:10Turn ratio of step-down transformer...

Q: +120 V ... 2:1 ideal diodes C = 10 uF RL= 10 kohms -120 V fin = 60 Hz Power-supply filter Determine ...

Q: 2. It is impossible to obtain analytical solutions for the power flow equations, because: a. The num...

A: To analyze a complex power flow network having multiple bus, iteration based approach is used which ...

Q: A circuit has a 120-V 60-Hz source connected to a 100-0 resistance and a 100-0 inductive reactance i...

Q: Consider a TDMA cellular system: a) The total system bandwidth is 50 MHz; b) FĎD is used; c) Each TD...

A: According to the question, we need to calculate two way voice channel. Consider a TDMA cellular syst...

Q: Use superposition theorem in solving the brabch currents. please show complete and clean solution

A: In this question We need to determine the branch current using the super position theorems. Here 3...

Q: 3. Determine the node voltages V1 and V2 using nodal analysis. 6A 2 loA 48n 242 (↑)18A

A: Given:

Q: .Obtain the Fourier series of the function for the waveform shown in Figure 11.

A: The given signal is shown below:

Q: Q2: Find inverse F.T of: 2(1 + jw) Y(ω) -π (ω) + jw ' (1+ jw)? + 16

A: It is given that: Yω=πδω+1jω+21+jω1+jω2+16

Q: Ii I2 5.5/30°n sn I3 Vt 10n J7

Q: Determine the total resistance and the current along 3 ohms in downward direction.

Q: K Q3: For the unity feedback system with G(s)= (s+3)(s² +4s+5) Do the following: a). Find the locati...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts f...

Q: The current of an AM transmitter is 20 A when unmodulated but increases to 22 A when modulated. Calc...

Q: 1. Compute the Band Width and Power of AM-SSB? 2. Which side the filter is select (upper or lower)? ...

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other par...

Q: loaded zener regulator, has the following parameters: Vin= 16V; the ener rated voltage 10V, series r...

Q: 2. What is the minimum band width required to modulate the voice signal by using FM ?

A: Frequency modulation-Frequency modulation means varying the frequency of carrier wave with principal...

Q: The rms antenna current for an AM transmitter increases by 15% over the unmodulated value when sinus...

A: Power = I^2 *R using this power relation we can convert power formula to current related formula

Q: Construct the RC circuit in Figure 6.3. Use a variable resistor of 100k2 and C=0.001µF. Set the sign...

A: Since proteus software is not freely available, the circuit setup and simulation has been done on ti...

Q: V.(s) Given the circuit below with zero initial conditions, determine the transfer function H(s) = I...

Q: Subfrwed the folloeing given yectors firnm A = 30+ j$2 mÁ B = (-395-j ) are another. 14

Question

Write your solution pls.

10. A 110-Volt AC line feeds two circuits in parallel. The currents are (2.2 – j6.5)A
and(1.8 – j3.5)A. The power consumed by the two circuits is approximately
11. The current thru an inductor with inductance of 1mH is given as
i(t) = 0.010sin10ºt A. What is the voltage across this conductor?
40

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The current in a pure capacitor circuit is i=0.17cos500t. If the rms value of the impressed emf is 80 volts. a) What are the equation for the voltage and power? b) What is the circuit frequency?
a) Explain why root mean square (RMS) is used to quantify the strength of an AC signal. b) If SI units are Meter (m), Kilogram (kg), Second (s), Ampere (A), Kelvin (K), Mole (M) and Candela (C), then express Voltage, Resistance, Capacitance, Inductance, Power and Energy in terms of SI units.
1. With a neat sketch briefly explain how an alternating voltage is produced when a coil is rotated in a magneticfield. 2. Derive expressions for average value and RMS value of a sinusoidally varying AC voltage 3. A circuit having a resistance of 12Ω, an inductance of 0.15 H and a capacitance of 100μf in series is connectedacross a 100V, 50Hz supply. Calculate the impedance, current, the phase difference between the current andsupply voltage. 4. Two circuits with impedances of Z1 = 10 + j15Ω and Z2 = 6 – j8Ω are connected in parallel. If the supply current is 20A, what is the power dissipated in each branch?
1. Explain the difference between the AC and DC? Give examples 2. Explain how RC and RL works in a circuit?
In a purely inductive AC circuit as shown in the figure, ΔVmax = 100 V. a) The maximum current is 9.00 A at 40.0 Hz. Calculate the inductance L. b) At what angular frequency ? is the maximum current 1.50 A?
Discuss why a. Complex power in an AC circuit is more than the DC resistance. b. Receiving end voltage of an unloaded long line may be more than sending end voltage. c. Inductance of the three phase of a transmission line are generally not equal. d. It is necessary to use the geometric means radius in the formula for the inductance calculation whereas the formula for the capacitance calculation uses the actual radius.
Problem: 3-Phase Belted Conductors Assume a 2 mile long, three- conductor belted cable is connected to a 24.9 KV, three-phase, 60 Hz bus. The charging current per conductor is found to be j8.31 A. A test result shows that the capacitance between all conductors bunched together with sheath is 0.8 u F/mi. tau What must be the measured capacitance between two conductors bunched together with the sheath and the third conductor ?
1. Discuss the influence of the bypass, coupling, internal, and stray capacitances on the frequency response.
Write about sinusoidal current, write its indirections and contraindications?define in details
Solar panels on one of the NWU solar car prototype, have an emissivity of e = 0.655. When in direct sunlight, they absorb energy at a rate of 796 J/s per square meter of surface. Assume that the only energy loss is due to the emission of radiation. What equilibrium temperature are the panels reaching?
What is the capacitance per kilometer per phase of a single circuit, two bundle conductor line with horizontal configuration? The distance between the bundled conductors is 30 cm and the diameter of each conductor is 5cm. The distance between the centers of the bundle is 5mChoices: 0.0132uF/km 0.0126 uF/km 0.0143uf/km 0.0116uF/km Please in typing format please
An RG-8/u coaxial cable line has a 50 W characteristic impedance and a nominal capacitance of 10 mF/ft. What is the outer diameter if the wire conductor inside diameter is 0.023 inches and the dielectric constant of the insulation is 2.23?