3-Phase Belted Conductors Assume a 2 mile long, three- conductor belted cable is connected to a 24.9 KV, three-phase, 60 Hz bus. The charging current per conductor is found to be j8.31 A. A test result shows that the capacitance between all conductors bunched together with sheath is 0.8 u F/mi. tau What must be the measured capacitance between two conductors bunched together with the sheath and the third conductor ?

3-Phase Belted Conductors Assume a 2 mile long, three- conductor belted cable is connected to a 24.9 KV, three-phase, 60 Hz bus. The charging current per conductor is found to be j8.31 A. A test result shows that the capacitance between all conductors bunched together with sheath is 0.8 u F/mi. tau What must be the measured capacitance between two conductors bunched together with the sheath and the third conductor ?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.12P: Find the inductive reactance per mile of a single-phase overhead transmission line operating at 60...

See similar textbooks

Similar questions

an overhead line is connected to a terminal apparatus through a length of single phase cable, the characteristics impedances being 400 and 50 ohms respectively. A traveling wave of vertical fromt and infinite tail of 100kv magnitudes originates in the overhead line and travels towards the junction with the cable during a period of 2us after the arrival of the wave at the junction. what voltage is reflected back into the line?
Calculate the velocity factor of a coaxial cable used as atransmission line, with the characteristic impedance of 30 ohms,capacitance of 20pF/m and a 80uH/m inductance.
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC = 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductors are transposed at regular intervals
Find the inductive reactance per mile of a single-phase overhead transmission line operating at 60 Hz given the conductors to be Partridge and the spacing between centers to be 30 ft.
15/ For Graded Insulators, the Capacitance of the unit nearest the line is the least. Select one: True False
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC = 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductorsare transposed at regular intervals.
Suppose that a network can be divided into two subnets connected by only two conductors, as shown below. Two points on these conductors are labeled a and b. The power factor seen to the right of a and b is defined as cos (ϕ) if ϕ is the angle formed by the phasor V and I. (Given the parity of the cosine, it does not matter if it is the angle by which V is advanced with relative to I or for the one that is delayed.) (Image 1) Now consider the following circuit, in which six points have been marked. (Image 2) a) Determine the power factor seen to the right of a3 and b3analyze your result. Does it make physical sense? What is happening to the currents in the inductor and in the capacitor? b) Determine the power factor seen to the right first of a2 and b2 and then of a1 and b1. Re-analyze your results. c) Calculate the capacitance that must be connected between a1 and b1 so that the power factor seen to the right of these points is 0.95 in lag. Assume the source frequency is 60 Hz.
Derive expression for capacitance in a transmission line.
Design a quarter wave matching section if the line has a characteristic impedance of 100 ohm while the load Is a 300 ohm resistor. Specify the length of the matching section if the velocity factor is 0.90 at a frequency of 150 MHz.
For the network, determine IE, VC and VCE. show complete solutioions
Use the external excitation method for part a.
1. Discuss the influence of the bypass, coupling, internal, and stray capacitances on the frequency response.