10. A circuit is made up of 10 resistance, 12 mH inductance and 281.5 µF capacitance in series. The supply voltage is 100 V (constant). Calculate the value of the current when the supply frequency is (a) 50 Hz and (b) 150 Hz.

Q: Question-2 Consider the following circuit where R₁ = 300 and R₂ = 100. Vin Given that: Vin (s) = =…

A:

Q: Problem 1 Consider the op-amp circuit shown below 100F yin a) Choose the resistors R1 and R2 and R3…

A:

Q: In the following network, the voltage magnitudes at all buses are equal to 1 p.u., the voltage phase…

A: Given- Voltage phase angles are small, Voltage magnitudes at all buses = 1 p.u. Line resistance are…

Q: 1.3 A single-phase AC generator feeds a load. The generator may be modeled as an ideal sinusoidal…

A: In this question we need to draw and label the circuit, write down governing equations and draw the…

Q: 2.) The power density is 4 mW/m² at some distance R from an isotropic antenna. The isotropic antenna…

A: Note: Since you have asked multiple questions, as per the Bartleby guideline, I am solving the 2)…

Q: b) Find the Thévenin equivalent of the circuit in Figure 3.126. R₁ V R₁ R₂ R3 LA | I A'

A:

Q: A permanent magnet DC servomotor with the following motor parameters: Torque Constant: Back EMF…

A: Permanent magnet DC servomotor KT =3×10-2   Nm/A KE =3×10-2    V-s/rad

Q: 1b) Find the currents and voltages in the circuit 30 V Α 8Ω α με 3Ω και ΕΩ

A: In this question we need to find the current and voltage of the given circuit. In parallel voltage…

Q: Show that a system of differential equations that describes the currents i(t) and i3(t) in the…

A:

Q: A non-inverting op amp configuration is shown. a. Find the gain of the amplifier, vo/vs. b. If vs 1…

A:

Q: FIXED BIAS 12 V 470k I t = 2.2k 47 P. 100

A: Since you have posted the multiple questions so we are supposed to answer 1st one.

Q: Q3. In a closed loop control system in the following, an open source transfer function is given as…

A: Given: Open source transfer function is GsHs=Gess2+10s+9. Gain for Gcs=1, Gcs=s+2, Gcs=s+3.

Q: 1. Use nodal analysis to determine io and VR and verify the answer using mesh analysis (Loop current…

A:

Q: 1.) Find the distance from a transmit antenna (gain = 27 dB) with 10 Watt input power at which the…

A: Note: Since you have asked multiple questions, As per the Bartleby guideline, I am solving the first…

Q: 36. Eight 20 A-hr lead-acid cells are arranged as in the drawing below (top view). What is the…

A: I have written this solution as handwritten solution. Hope you find the solution clear.

Q: le Select one: a. 840 b.42 c. 24 d. 84✔ e. None mmF -0.044 Wb Re Consider the magnetic core with its…

A:

Q: 5. Consider the photo of the clutch on the left.   (a) Draw a circuit diagram of the connection…

A: According to the question, (a) For the above circuit, we need to draw a circuit diagram of the…

Q: A 4 pole, lap wound de motor has 540 conductors. Its speed is found to be 1000 rpm when it is made…

A:

Q: 5. Consider a discrete system, if the input x(n) = (0.6)" u(n) and the impulse response h(n) =…

A:

Q: A transformer circuit breaker is equipped with 500/5 A C.T.s connected to a induction type over…

A: Given- 500/5A C.T.s transformer circuit breaker- 125% plug setting and 0.4 time setting, 3-ϕ fault…

Q: Question-21 Consider the following circuit where R₁ = 300 and R₂ = 100 2. R₁ W Vin 1) Given that:…

A:

Q: Find the Laplace transformation of the following function π. (2t + 1)² + cos (3t+ 3

A: In this question We need to determine the Laplace transform of the given following function.  We…

Q: In Figure shown below, use Thevenin's Theorem to Determine RTH, VH, IN & Maximum power transfer at…

A: For the given circuit, the thevenin's equivalent resistance, thevenin's voltage, norton's current…

Q: The signal power at the input to an amplifier is 100µW and the noise power is 1pW. At the output,…

A: Given: For an amplifier,  Input Signal power, Si=100 μW, Input noise power, Ni=1 pW, Output Signal…

Q: A system is described by the following differential equation: d^y _d³y d²y dy 5- +4 + 2y = 2u dt³…

A: it us asked to represent the given differential equation in controllable canonical form and to find…

Q: For R1=55, R2=40, R3=45 and R4=75 Calculate the equivalent resistance at terminals a-b for th shown…

A: I have written this solution as handwritten solution. Hope you find the solution clear.

Q: 1. For the symmetrical 3-phase circuit in Figure 1: a) Draw 1-phase equivalent circuit b) Calculate…

A: Given data Line-to-line voltage URS=400∠30° V  LIne Resistance Rline=2 ohms  Load Inductance…

Q: Va 20 ΚΩ Ub 5 ΚΩ 160 ΚΩ 18 V -18 V 240 ΚΩ Calculate v, if va = 3 V and v = 0 V. Express your answer…

A:

Q: continued fraction expansion

A:

Q: For R1=4, R2=17, R3-28, R4=34, K1=3 and I1=12 A in the shown circuit, find the node voltages: R1 www…

A: Given data, R1=4Ω, R2=17Ω, R3=28Ω, R4=34Ω, K1=3, I1=12 A. Circuit diagram is given as,

Q: B: Find current and voltage in the circuit shown in Fig. b 0.54. a 1 42 13A

A: here we have to find the current ( i0 ) and voltage ( v0 ).

Q: Figure 2 shows an input interfacing circuit. By using your own words, explain how it works. Switch…

A: it us asked to explain the given circuit

Q: ● 1. 2. H.W: Simplify the following Boolean expressions: (Ā+B+C).(A+B+C).(C+D).(C+D+E) A.B.C +…

A: In these questions We need to simply the given expression.  We know As per boolean algebra formula…

Q: Determine the resistance of an aluminium coil of 183 cm as diameter consists of 14400 turns and the…

A: We need to find out the resistance for given coil .

Q: Consider the series RC-circuit shown below for which R = 66.0 kn, C = 45.5 µF, and & = 23.5 V. Find…

A:

Q: Solve for current (in uA) through R when Vin = 5V. Use Figure a. +5V -5V (a) R 4.7ΚΩ +50V -50V (b) R…

A:

Q: The primary coil of a transformer has 1, 32, 000 turns and is connected to A.C. input source of 220…

A: Given- Number of turns in the primary coil Np=1,32,000 A.C input source=220 V Number of turns in the…

Q: 3. An iron cored toroid of relative permeability 980 has a mean length of 120 cm and core are of…

A:

Q: For the following block diagram, find the closed loop transfer function: R K1 F(s) + + G(s) K2

A: In this question We need to determine the closed loop transfer function.  We are solving this…

Q: Write a difference equation that characterizes a system whose frequency response is H(el) =…

A:

Q: Write the following as a single sine and as a single cosine representation: y = 1.34 sin(7t - 0.55)…

A: For the given function , we need to convert into a single sine and cosine as a addition of phasor…

Q: d²y + dt² 3y = [(2x (2x + cosx)dt + dx dt

A: it is asked to find whether the given system is linear or not

Q: For the circuit shown in the Figure find the node voltages v, and v, using r 492 www 2 V 22 22

A: Circuit is given as:

Q: 2. A two bus power system is shown in figure. The Incremental fuel costs of the two generators in…

A: Given a 2 bus power system The incremental fuel cost of the 2 generators in Rs/MWhr is given…

Q: Implement the circuit f(x1,x2,x3,x4)=x1+(x2¹*x3*x4')+(x2*x3*x4) using NAND gates only.

A:

Q: 55. A half-wave rectifier circuit is shown in the figure. The minimum reverse voltage rating (V) of…

A: In this question we need to choose a correct option

Q: A three-phase, fully controlled thyristor bridge converter is used as line commutated inverter to…

A:

Q: An RL circuit with a 8-92 resistor and a 0.04-H inductor carries a current of 1 A at t=0, at which…

A:

Q: 11 USE NODAL ANALYSIS Given a = 10, b=4, c = 2, d = 2, e = 4,f=1, g = 3 and h = 2, in the circuit…

A: The required parameter can be calculated by finding the node voltage using nodal analysis. The node…

Q: EOCP 3.6 Find the frequency response for the following system: 9) y(n) + ay(n-1)= x(n) + x(n − 1) +…

A: Dear Student, Since you have posted multiple questions, we will provide the solution only to the…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.