10. A stream of 2 kg/s of CH, at 1.6 bar and and 140 K is compressed adiabatically to 50 bar and 400 K in a steady-state process. Compute the following using the method of your choice (suggested: P-H diagram for thermodynamic properties of methane). For CH₂: T. 190.6 K, P, 4.604 MPa, = 0.011 ) AH Hout- Hin (kJ/kg)

10. A stream of 2 kg/s of CH, at 1.6 bar and and 140 K is compressed adiabatically to 50 bar and 400 K in a steady-state process. Compute the following using the method of your choice (suggested: P-H diagram for thermodynamic properties of methane). For CH₂: T. 190.6 K, P, 4.604 MPa, = 0.011 ) AH Hout- Hin (kJ/kg)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q22(i) Construct the flow chart (diagram) and compute the total heat required to convert 900 g of ice at –30°C to steam at 145 °C. (Cice = 2090 J/kg.°C, Cwater = 4186 J/kg.°C, Csteam = 2010 J/kg.°C, Lf = 3.33 × 105 J/kg, Lv = 2.26 × 106 J/kg.)
3.) Find the pressure ,specific volume ,internal energy ,enthalpy ,entropy of saturated water at 300 F . 4.)Find the temperature ,specific volume ,internal energy ,enthalpy ,entropy of saturated steam at a pressure of 1 inch Hg absolute.
A steam trap is a device to purge steam condensate from a system without venting uncondensed steam. In one of the crudest trap types, the condensate collects and raises a float attached to a drain plug. Whenthe float reaches a certain level, it “pulls the plug,” opening the drain valve and allowing the liquid to discharge. The float then drops down to its original position and the valve closes, preventing uncondensed steam from escaping.(a) Suppose saturated steam at 25 bar is used to heat 100 kg/min of an oil from 135°C to 185°C. Heat must be transferred to the oil at a rate of 1:00 x 10 4 kJ/min to accomplish this task. The steam condenses on the exterior of a bundle of tubes through which the oil is flowing. Condensate collectsin the bottom of the exchanger and exits through a steam trap set to discharge when 1200 g of liquid is collected. How often does the trap discharge?(b) Especially when periodic maintenance checks are not performed, steam traps often fail to close completely…
A water vapor turbine operates between 30 bar, 400 ° C input conditions. 160 m / s and an output corresponding to saturated steam at 0.7 bar and a speed of 100 m / s. The mass flow is 1,200 kg / min. And the output power is 10,800 kW. Deter- Men the magnitude and sense of heat transferred in KJ / min, if the variation of potential energy is negligible.
A rocket motor with chamber pressure and temperature of 2.04 MPa, 2200 K, operates at sea level where pressure is 0.1 MPa. Find thrust produced and specific impulse for propellant consumption of 1.0 kg/s. Take cp = 1500 J/kg K, k = 1.3, g = 9.807 and R = 346 J/kg K. Find also thrust when the pressure inside the nozzle is 50% of initial
Ammonia in a large container overheats to 14 bar, 300°C, due to a failure. At this state, a small crack opens in the container that acts as a nozzle. The outside environment is at 1 bar, 25°C, and the mass flow rate of Ammonia is 10 g/s . Assume negligible nozzle inlet velocity and adiabatic reversible flow. What is the exit velocity, and the exit cross section?
Rankine Cycle What two conditions can you define for state 2 (pump) that are inferred from other states?
5.) Find the temperature , specific volume ,internal energy ,enthalpy ,entropy of saturated steam at a pressure of 850 psia . 6.) Find the pressure ,specific volume ,internal energy ,enthalpy ,entropy of saturated water at 100 F.
Solve please, should 100% sure of ans. Air enters a well-insulated turbine operating at steady state with a negligible velocity at 4 MPa and 300 oC, It exits the turbine at 100 kPa pressure at 100 oC. The diameter of the exit pipe is 60 cm. The velocity at exit is 90 m/s. a. What is the volumetric flow are at the exit? Express your result in units of m3/s. b. What is the molar flow rate at the exit? Assume that at the exit conditions, air may be considered to behave like an ideal gas. Express your results in units of mols/s c. What is the mas flow rate? Express your result in units of kg/s.
P23. Steam enters an insulated nozzle with negligible velocity, 200 psi and 500°F. Steam exits at 100 psi and 400°F.For steady-state operation and neglecting potential energy effects, determine the velocity of the steamleaving the nozzle in ft/s.
A two stage compressor with first stage piston displacement of 94,390 cu.m/sec is driven by a motor. Motor output is 35 HP, suction temperature 22 degC, volumetric efficiency is 85%, mechanical efficiency is 95%, the intercooler pressure is 30 psi gage. Air temperature in and out of the intercooler are 105deg C and 44 degC, respectively. Final discharge pressure is 100 psi gage, while suctionis estimated to be 14.4 psi. Determine the compression efficiency.
Steam at 10 bar, 600°C, 50 m/s enters aninsulated turbine operating at steadystate and exits at 0.35 bar, 100 m/s. Thework developed per kg of steam flowingis claimed to be (a) 1000 kJ/kg, (b) 500kJ/kg. Can either claim be correct?Explain.