10. A toy car is on a small indoor track, which is 100-m in circumference. The car starts from rest, accelerates uniformly, and after 5 seconds reaches a point halfway around the circle. At this time, what is the magnitude of the car's acceleration? A) 4 m/s B) 9 m/s C) 16 m/s D) 25 m/s E) >25 m/s antel The block is released

10. A toy car is on a small indoor track, which is 100-m in circumference. The car starts from rest, accelerates uniformly, and after 5 seconds reaches a point halfway around the circle. At this time, what is the magnitude of the car's acceleration? A) 4 m/s B) 9 m/s C) 16 m/s D) 25 m/s E) >25 m/s antel The block is released

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter8: Potential Energy And Conservation Of Energy

Section: Chapter Questions

Problem 64P: A block of mass 500 g is attached to a spring of spring constant 80 N/m (see the following figure)....

See similar textbooks

Similar questions

Calculate the elastic potential energy of a spring with spring constant k = 225 N/m that is (a) compressed and (b) stretched by 1.00 102 m.
A 500-kg dragster accelerates from rest to a final speed of 110 m/s in 400 m (about a quarter of a mile) and encounters an average frictional force of 1200 N. What is its average power output in watts and horsepower if this takes 7.30s?
The Flybar high-tech pogo stick is advertised as being capable of launching jumpers up to 6 ft. The ad says that the minimum weight of a jumper is 120 lb and the maximum weight is 250 lb. It also says that the pogo stick uses a patented system of elastometric rubber springs that provides up to 1200 lbs of thrust, something common helical spring sticks simply cannot achieve (rubber has 10 times the energy storing capability of steel). a. Use Figure P8.32 to estimate the maximum compression of the pogo sticks spring. Include the uncertainty in your estimate. b. What is the effective spring constant of the elastometric rubber springs? Comment on the claim that rubber has 10 times the energy-storing capability of steel. c. Check the ads claim that the maximum height a jumper can achieve is 6 ft.
A 5.0-kg block is pushed 3.0 m up a vertical wall with constant speed by a constant force of magnitude F applied at an angle of = 30 with the horizontal, as shown in Figure P5.76. If the coefficient of kinetic friction between block and wall is 0.30, determine the work done by (a) , (b) the force of gravity, and (c) the normal force between block and wall, (d) By how much does the gravitational potential energy increase during the blocks motion? Figure P5.76
A block of mass 500 g is attached to a spring of spring constant 80 N/m (see the following figure). The other end of the spring is attached to a support while the mass rests on a rough surface with a coefficient of friction of 0.20 that is inclined at angle of 300 . The block is pushed along the surface till the spring compresses by 10 cm and is then released from rest. (a) How much potential energy was stored in the block-spring-support system when the block was just released? (b) Determine the speed of the block when it crosses the point when the spring is neither compressed nor stretched. (c) Determine the position of the block where it just comes to rest on its way up the incline.
A childs pogo stick (Fig. P7.69) stores energy in a spring with a force constant of 2.50 104 N/m. At position (x = 0.100 m), the spring compression is a maximum and the child is momentarily at rest. At position (x = 0), the spring is relaxed and the child is moving upward. At position , the child is again momentarily at rest at the top of the jump. The combined mass of child and pogo stick is 25.0 kg. Although the boy must lean forward to remain balanced, the angle is small, so lets assume the pogo stick is vertical. Also assume the boy does not bend his legs during the motion. (a) Calculate the total energy of the childstickEarth system, taking both gravitational and elastic potential energies as zero for x = 0. (b) Determine x. (c) Calculate the speed of the child at x = 0. (d) Determine the value of x for which the kinetic energy of the system is a maximum. (e) Calculate the childs maximum upward speed. Figure P7.69
What average power is generated by a 70.0-kg moun-tain climber who climbs a summit of height 325 in in 95.0 min? (a) 39.1 W (b) 54.6 W (c) 25.5 W (d) 67.0 W (e) 88.4 W
In the movie Monty Python and the Holy Grail (https://openstaxcollege. org/l/21monpytmovcl) a cow is catapulted from the top of a castle wall over to the people down below. The gravitational potential energy is set to zero at ground level. The cow is launched from a spring of spring constant 1.1 104 N/m that is expanded 0.5 m from equilibrium. If the castle is 9.1 m tall and the mass of the cow is 110 kg, (a) what is the gravitational potential energy of the cow at the top of the castle? (b) What is the elastic spring energy of the cow before the catapult is released? (c) What is the speed of the cow right before it lands on the ground?
. A particular hydraulic pile driver uses a ram with a mass of 1040 kg. If the maximum pile energy is 11,780J, how high must the ram he raised to achieve this value? Assuming it takes 0.62 s for the pile driver’s winch motor to raise the ram at a constant speed to this height, what is the power output by the motor in completing this task? Express your answer in both watts and horsepower.
Consider the blockspringsurface system in part (B) of Example 8.6. (a) Using an energy approach, find the position x of the block at which its speed is a maximum. (b) In the What If? section of this example, we explored the effects of an increased friction force of 10.0 N. At what position of the block docs its maximum speed occur in this situation?