Given: D1: 4.3 cm and the samller diamater is D2: 1.7 cm 10.0 cm5.00 cmD2D1m/s.The speed of the water flowing in the smaller channel with diameter D2 is

Answered: Image /qna-images/answer/95736939-b3c4-4adc-be52-2a0a63ee12ac.jpg

Answered: 10.0 cm 5.00 cm D2 D1 m/s. The speed of…

Science

Physics

10.0 cm 5.00 cm D2 D1 m/s. The speed of the water flowing in the smaller channel with diameter D2 is

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter15: Fluids

Section: Chapter Questions

Problem 23PQ: What fraction of an iceberg floating in the ocean is above sea level? Assume the density of the...

See similar textbooks

Related questions

Q: Water flowing out of a 15 mm diameter faucet fills a 1.7 L bottle in 13 s. (a) At what distance…

A: Determine the flow rate of the water through the faucet as follows. Q=Vt=1.7 L13 s=1.7×10-3 m313…

Q: A large storage tank, open to the atmosphere at the top and filled with water, develops a small hole…

A: Given values: The height of the hole from the water surface, h=19.1 m The rate of flow, R=2.00×10-3…

Q: A solid cylinder with base area A= 20 cm^2 is placed completely underwater as shown in the figure.…

Q: You fill a 7.0 x 10-3 m3 bucket with water that flows from a pipe of radius 1.30 cm. If it takes…

A: given: volume of bucket=7*10-3 m3 radius of pipe=1.30cm time it takes to fill the tank=48 secs…

Q: Water emerges straight down from a faucet with a 2.50-cm diameter at a speed of 2.18 m/s. (Because…

Q: As shown, water is slowly poured into the container until the water level has risen into tubes 1, 2,…

Q: A jet of water squirts out horizontally from a hole near the bottom of the tank shown in the figure.…

Q: Calculate the pressure on the top lid of a chest buried under 4.25 meters of mud with density 1.75 x…

A: The pressure exerted on an object is calculated by using the formula P=hρ g , where h is the depth…

Q: Water is flowing in a pipe with radius of 25.4 cm at velocity of 5 m/s. The viscosity of water is…

A: Reynolds number is the measure of type of flow. Reynolds number gives the information about the…

Q: Water (density=1.0gcm3) rises in a glass capillary tube to a height of 8.4 cm at 25∘C. What is the…

A: The water in a capillary tube rises because of the interfacial forces . This attaraction is mainly…

Q: What is the average flow rate in cm/s of gasoline to the engine of a car traveling at 101 km/h if it…

A: Given data: Speed of car (v) = 101 km/h Car's averages = 12.0 km/L Required: The average flow rate…

Q: A cylindrical tank with a large diameter is filled with water to a depth D = 0.458 m. A hole of…

Q: A container of cross-sectional area 122 cm2 contains liquid of density 1.75 g/cm3 to a height of…

Q: A cylindrical tank with a large diameter is filled with water to a depth D = 0.350 m. A hole of…

Q: Water pressure acting on sunk plane at depth is 4×10⁶Pa. What is the magnitude of the force in kN…

A: Pressure, Area,

Q: 10.0 cm 5.00 cm D1 D2 m/s. The speed of the water flowing in the Smaller channel with diameter D2 is

A: Here given the diagram with height of liquid. In first tube height is 10 cm and in second 5 cm. We…

Q: 2. Water is to be pumped to the top of the Empire State building, which is 366 m high. What gauge…

Q: (10.14) The maximum gauge pressure in a hydraulic lift is 17.0 atm. What is the largest-size vehicle…

Q: What is the average flow rate in cm/s of gasoline to the engine of a car traveling at 114 km/h if it…

A: The expression for average flow rate of gasoline to the car engine is given by Q=vL 1 Here, Q is…

Q: 90 m thick. Its density is 700 kg/m^3. a. What volume of lead must be fastened

Q: Calculate the pressure on the top lid of a chest buried under 4.00 m of mud with density equal to…

A: GivenHeight of mud, h1=4 mDensity of mud, ρ1=1.75×103 Kg/m3Depth of lake of water, h2=10 m

Q: A jet of water squirts out horizontally from a hole near the bottom of the tank shown in the figure.…

Q: At what flow rate might turbulence begin to develop in a 0.380 m diameter water main? Assume a 20°C…

Q: 3. An open tank contains brine to a depth of brine is 1,030 kg/m³ and density of oil is 880 kg/m².…

A: Given:- Brine depth = 2.0 m oil on top of the brine = 3 m density of brine = 1030 kg/m3 density…

Q: 15.2 PQ4A rectangular open channel has a base of length 2h, and the water is flowing with a depth of…

A: (a) Write the given data. Base length=2bDepth=b

Q: A barrel contains a 0.140-m layer of oil floating on water that is 0.255 m deep. The density of the…

A: Given:Height of oil layer on the water surface: H0 = 0.140mHeight(depth) of water : Hw =…

Q: Water is flowing through a rectangular pipe with cross-sectional area 1.5 m with a velocity of 3.6…

Q: A cylindrical tank with a large diameter is filled with water to a depth D = 0.295 m. A hole of…

Q: A rectangular parallelepiped with a square base d = 0.255 m on a side and a height h = 0.120 m has a…

A: A square base sides of a rectangular parallelepiped, A height of the rectangular parallelepiped,…

Q: You fill a 5.0 x 103 m3 bucket with water that flows from a pipe of radius 1.25 cm. If it takes 14.0…

Q: 2. A cylindrical tank with a diameter of 1.5 meters contains a fluid with specific gravity of 9.0.…

Q: A cylindrical bucket sitting on the edge of a table has a 3.50 mm diameter hole near the bottom.…

Q: Water, with a density of ρ = 1185 kg/m3, flows in a horizontal pipe. In one segment of the pipe the…

A: Given that, the density of water ρ = 1185 kg/m3, v1 = 4.33 m/s, and v2 = 3.77 m/s.

Q: The volume flow rate in a small rubber water pipe is 2.58 x10−6 m3/s. If the radius of the pipe is…

A: Given : Q = 2.58 x10−6 m3/s r = 9.18 mm = 0.00918 m

Q: A jet of water squirts out horizontally from a hole near the bottom of the tank shown in the figure.…

A: Let depth of water inside the tank be h

Q: A fluid is flowing in a 0.656 m x 1.092 m channel at the rate of 3.51 m/s and has a specific volume…

A: Given value--- channel dimension = 0.656 m × 1.092 m. Speed =3.51 m/sec. specific Volume = 3.448…

Q: A horizontal pipe 3.5 cm in radius is joined to a pipe 14 cm in radius. (a) If the velocity of…

Q: The inside diameters of the larger portions of the horizontal pipe are 2.50 cm. Water flows to the…

Q: The mattress of a water bed is 2.00 m long by 2.00 m wide and 30.0 cm deep.(A) Find the weight of…

A: Given data The length is, l=2.00 m The width is w =2.00 m The depth is d=30.0 cm Step 1 The volume…

Q: Water flows along a streamline down a river of constant width(Fig. CQ9.7). Over a short distance the…

A: accoridng to th equation of continuity,

Q: The inside diameters of the larger portions of the horizontal pipe depicted in the figure are 2.50…

A: Fluids are defined as the material that has the special property of being able to flow. This…

Q: What is the pressure (in Pascal ) on a submarine window located 442 m below the surface. The density…

A: The expression for find pressure on a submarine window is P=P'-P''=Patm+ρgh-Patm=ρgh Here, P' is the…

Q: A container of cross-sectional area 107 cm2 contains liquid of density 1.75 g/cm3 to a height of…

Q: A cylindrical tank with a large diameter is filled with water to a depth D = 0.278 m. A hole of…

A: Given data: The depth of water is D=0.278 m. The cross-sectional area of hole is A=7.04 cm2.

Q: A cylindrical tank with a large diameter is filled with water to a depth D- 0.327 m. A hole of…

Q: A 2m wide channel is conveying water at a depth of 0.5m, what is the daily flow if the velocity is…

A: The formula for the cross-sectional area of the channel is: The formula for the flow rate is:

Q: What is the average flow rate in cm/s of gasoline to the engine of a car traveling at 106 km/h if it…

A: Explanation Average flow is defined as the volume consumed in unit time. So average flow rate is,…

Q: A large tank contains water to a depth of 1.0 m. Water emerges from a small hole in the side of the…

A: Given Data: Water depth, H=1 m Depth of hole from the water level, h=20 cm=0.2 m Diameter of hole,…

Concept explainers

Estimate of calculation

Question

Given:

D1: 4.3 cm and the samller diamater is D2: 1.7 cm

10.0 cm
5.00 cm
D2
D1
m/s.
The speed of the water flowing in the smaller channel with diameter D2 is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Oil having a density of 930 kg/m3 floats on water. A rectangular block of wood 4.00 cm high and with a density of 960 kg/m3 floats partly in the oil and partly in the water. The oil completely covers the block. How far below the interface between the two liquids is the bottom of the block?
A table-tennis ball has a diameter of 3.80 cm and average density of 0.084 0 g/cm3. What force is required to hold it completely submerged under water?
What fraction of ice is submerged when it floats in freshwater, given the density of water 0°C is very close to 1000 kg/m3?
Explain why the fluid reaches equal levels on either side of a manometer if both sides are open to the atmosphere, even if the tubes are of different diameters.
Calculate the Reynolds numbers for the flow of water through (a) a nozzle with a radius of 0.250 cm and (b) a garden hose with a radius of 0.900 cm, when the nozzle is attached to the hose. The flow rate through hose and nozzle is 0.500 us. Can the flow in either possibly be laminar?
Why is it difficult to swim under water in the Great Salt Lake?
The small piston of a hydraulic lift (Fig. P15.6) has a cross-sectional area of 3.00 cm2, and its large piston has a cross-sectional area of 200 cm2. What downward force of magnitude F1 must be applied to the small piston for the lift to raise a load whose weight is Fg = 15.0 kN? Figure P15.6
Pascal’s Principle and Hydraulics 59. How much pressure is transmitted in the hydraulic system considered in Example 14.3? Express your answer in atmospheres.
A large storage tank with an open top is filled to a height h0. The tank is punctured at a height h above the bottom of the tank (Fig. P15.39). Find an expression for how far from the tank the exiting stream lands. Figure P15.39
The small piston of a hydraulic lift (Fig. P14.8) has a cross-sectional area of 3.00 cm2, and its large piston has a cross-sectional area of 200 cm2. What downward force of magnitude F1 must be applied to the small piston for the lift to raise a load whose weight is Fg = 15.0 kN?
The inside diameters of the larger portions of the horizontal pipe depicted in Figure P9.45 are 2.50 era. Water flows to the right at a rate of 1.80 104 m3/s. Determine the inside diameter of the constriction. Figure P9.45
What is the average flow rate in cm3/s of gasoline to the engine of a car traveling at 100 km/h if it averages 10.0 km/L?