Answered: 10.67 In a rectangular channel 4 m wide…

10.67 In a rectangular channel 4 m wide flow of 7.65 m/s the depth is 0.4 m. If a hydraulic jump is produced, (a) what will be the depth immediately after it? (b) What will be the loss of energy?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Consider a 1,5m wide rectangular channel carries a discharge Q(m3/s). It is further observed from…

Q: A hydraulic jump at the base of a spillway of a dam is such that the depth upstream and downstream…

A: As per authoring guidelines, if the question number is not specified, the first question or three…

Q: At the bottom of an 80-ft-wide spillway is a horizontal hydraulic jump with water depths 1 ft…

Q: What factors account for the loss of energy in laminar flow? How does the energy loss vary with…

Q: The hydraulic jump has a depth of 5 m at the downstream end, and the velocity is V2=1.75 m/s. If the…

A: NOTE: Due to some technical issue, formulation and equation writings is not possible. Hence, images…

Q: Water flows in a trapezoidal channel of 2 m width and side slope at 1:1. At upstream depth of 2 m,…

Q: PROBLEM 4: For the 50-mm-diameter siphon drawing oil (sp gr = 0.82) from the oil reservoir, the head…

A: d=50mm To find discharge from siphon and pressure at point 2

Q: 8. When the energy is at minimum for flow discharge, it is called a) Normal depth b) Roughness c)…

Q: Hydraulic jump occurs in a 4 m wide rectangular channel. Discharge in channel 7.5 m^3 /s, hydraulic…

Q: Problem 2. A well is located in a completely confined aquifer with a hydraulic conductivity of 12…

Q: A spillway discharges a flood flow at a rate of q= 7.75 m3/s per meter width. At the downstream…

Q: ectangular channel 2,5 m wide such hat the depth after the jump is 45m, If the discharge in the…

Q: A hydraulic jump occurs in a rectangle, open channel. What would be the pre jump depth if the…

A: Given data in question Discharge per unit width Energy loss Rectangular channel To find out Pre…

Q: A spillway 1.5 m deep goes over a dam 30 m high. Using a weir factor Cw of 1.92, determine (a) the…

A: Given :

Q: The specific energy, E, is defined as the total energy head with respect to the channel or pipe…

A: Given data : Flow rate (Q)=1 m3/sWidth (w)=5 mDepth (d)=20 cm

Q: A pumping well in confined aquifer has a diameter of 0.3 m. For a certain discharge, the radius of…

A: Discharge is the flow of volume of water flowing per unit of time and is the product of velocity of…

Q: Suppose that a stable hydraulic jump forms between the two sluice gates shown in Figure 5.15. If the…

Q: Consider the flow of water in a 10-m wide channel at a rate of 70 m3 /s and a flow depth of 0.5 m.…

A: Using formula

Q: A small pipe 0.60 m long is filled with water and capped at its ends. If placed in a horizontal…

Q: Given that unit discharge in a rectangular channel is 18 m3 /s/m and the head loss across a…

A: Given data: Unit discharge (q) = 18 m3/s hydraulic jump (HL) = 1.1 m Assume acceleration due to…

Q: A hydraulic jump occurs in a trapezoidal channel with slope of 1:1 and base width of 4 m. If the…

Q: For a uniform flow with depth of 0.6 m and Froude number of 2.0 in a rectangular channel, the…

A: Given data: uniform flow. flow depth= 0.6 m Froude number (Fr)=2.0 rectangular channel.

Q: A confined aquifer has a thickness of 85 ft. An 86-in diameter well drilled to the bottom of the…

A: To find discharge and velocity

Q: The siphon in Figure 4 is a pipe of diameter D= 0.4 m with roughness ɛ = 0.4 mm. – Calculate the…

A: step 1-

Q: What will be the average velocity ( Darcy velocity ) of flow in the aquifer at a distance 20 ft from…

A: Given Data:Thickness of aquifer = 85 ftDiameter of well drilled = 86 inTo determine:Maximum rate of…

Q: 2. A rectangular channel 4 m wide flows at a flow rate of 10 m^3/s at a depth of yt=2.5m.lf the…

Q: (b) A vertical sluice gate with an opening of 0.67 m produces a downstream jet with a depth of 0.4 m…

A: Gate opening ho =0.67m Channel width W= 0.5m Sequent depth h2 =2.5m Discharge Q= 20m3/sec Jet depth…

Q: Water on the horizontal apron of the 30 m -wide spillway shown in Fig. E10.8a has a depth of 0.2 m…

Q: hydraulic jump is formed in a 4 m wide rectangular open channel at a short distance downstream of a…

Q: Figure: 1 Plot the specific energy versus depth curves (in normal graph paper) for Q = 400 and 800…

Q: A liquid flows at a depth of 400 mm with an average velocity of 6 m/s in a rectangular channel.…

A: Given data: Depth of flow=400 mm Average velocity=6 m/s It is asked to determine critical depth.

Q: A hydraulic jump occurs in a rectangular channel that is 7 m wide. The initial depth is 0.8 m, and…

Q: A rectangular channel carries a dis-charge of 2 m/sec per meter width. If the loss of energy in the…

A: step 1-

Q: A rectangular open channel, with a constant discharge of 32m3/s, has a smooth expansion from (1) to…

A: Given data: Q=32 m3/s Section 1-1 y1=2.4 mb1=3.6 m Section 2-2 y2=0.8 m

Q: Water flows through a 4m wide rectangular channel at a flow depth of 0.5m. Then, a hydraulic jump…

Q: The spillway below discharges to a rectangular channel with 2 m width and 2.4 m³/s discharge. Find…

A: solution attached in next step

Q: The depth of uniform flow in a 3 m wide straight rectangular channel, for a discharge of 10 m³/s, is…

Q: a. Calculate the flow rate out of the reservoir, if at the discharge (point C) the cros sectional…

A: Given -

Q: 51. Draw the phreatic surfaces and determine the flow rates with and without the drainage blanket…

A: Phreatic line is the top most flow line also called line of seepage. Soil mass below phreatic line…

Q: The celerity of the pressure wave is 976 m/s instantaneously in a 600 m long pipe from a reservoir…

A: The given data is shown below: Celerity=976 m/sLength of pipe=600mDiameter=1.20mFlow rate=0.85 m3/s

Q: A hydraulic jump occurs in a horizontal rectangular channel. which is 1 m wide. The pre-jump depth…

Q: 5) A hydraulic jump occurs in a rectangular channel 3 m wide. The water depth after the jump is 2.0…

A: Given data Width Depth after jump Bottom slope Roughness coefficient

Q: EX.7. A 45cm-well in an unconfined aquifer of saturated thickness of 45 m yields 600 Ipm under a…

Q: For the hydraulic structure shown below: (A) What is the pressure head at points A, B? (B) What is…

A: (A) From the given given diagrams. The upstream head is 40 ft. The downstream head is 10 ft. The…

Q: A confined aquifer has thickness of 33km and 7km wide. Two observation wells are located 1.2km apart…

A: Solution: Given Data: Thickness of confined aquifer=33 kmwidth of confined aquifer=7 kmHead of well…

Q: Problem 3. Given the following set up, where the reservoir levels are maintained at a constant…

A: Given,

Q: A concrete dam is 30 m long from upstream side to downstream end. The dam is situated on a…

A: Figure showing the flow net for seepage occurring beneath the dam…

Q: In the vertical wall of a reservoir (A) there is a drowned hole that it flows into another reservoir…

A: For Orifice-2,Coefficient for Contraction (Cc) = 0.64Discharge Coefficient (Cd) = 0.604Actual…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

100%

10.67 In a rectangular channel 4 m wide with a
flow of 7.65 m/s the depth is 0.4 m. If a
hydraulic jump is produced, (a) what will
be the depth immediately after it?
(b) What will be the loss of energy?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Hydraulic structure A rectangular channel 10m wide carries 60 cumecs. If the energy Dissipated in the hydraulic jump occurring in the channel is 4.17 N.m/N. State the properties of the jump and design U.S.B.R. stilling basin with Sketch.
a hydraulic jump occurs in a 3-m wide rectangular channel. the depth and the velocity after jump are 1.75m and 2m/s. what is the loss of energy in the jump. and if the length of the channel is 200 m determine slope of the channel.
A 1.15 m diameter pumping well penetrates vertically through a confined aquifer which is 42 m thick. While pumping at a rate of 2880 m3/day, the drawdown in an observation well 20 m away is 2.0 m. In another observation well, that is located 60m away, the drawdown is 0.45m. Initial piezometric level is 52m above the datum. Determine: The radius of influence of the pumping well?
5.Hydraulic jump occurs in a 4 m wide rectangular channel. Discharge in channel 7.5 m^3 /s, hydraulic jump upstream depth 0.2 m. Determine :the rate of energy loss due to hydraulic jump.
1. A sharp-edged orifice in a 30 deg plane has its vena contracta at Elev. 107m. If the water surface of the tank is at Elev. 15.25m and the top of the jet is at Elev. 14m, find the velocity and the coefficient of velocity.
In Figure W is shown a thin-walled inverted box 1.60 m long and 30 cm square, which was full of air before being submerged. In position (a), it is being held by 0.0280 m3of concrete anchor weighing 23540 N/m3. Determine the depth D1. At what other depth D2(position B) is the system in equilibrium?
Read the question carefully and give me right solution with clear calculations. Note: If you don't know the solution please leave it but don't give me wrong solution. If the sequent depth equal to 1.7 m, and the energy dissipated =0.5 kg.m/kg of a hydraulic jump in a rectangular channel, what's the length of the jump?
For a hydraulic jump in a rectangular channel the velocity and depth after the jump are known to be 0.8m/s and 1.75 m respectively. Calculate the depth before the jump, the energy loss and the power dissipated per meter width.
A 1.15 m diameter pumping well penetrates vertically through a confined aquifer which is 42 m thick. While pumping at a rate of 2880 m3/day, the drawdown in an observation well 20 m away is 2.0 m. In another observation well, that is located 60m away, the drawdown is 0.45m. Initial piezometric level is 52m above the datum. Determine: A.The approximate head in the pumping well for steady state condition B.The approximate drawdown in the pumping well C.The transmissivity of the aquifer D.The radius of influence of the pumping well
A 3.4-m square vertical tank 10 m high contains 3.9 m of oil (SG=0.77). A 82 mm diameter circular sharp edged orifice is located 52cm above its bottom. Assume c=0.63, how long will it take to lower the water level to 0.9 m deep remaining after opening the orifice?
Hydraulic structure Q.4] A hydraulic jump occurs in rectangular channel 6.1m wide, the rate of flow 22.6 cumecs, if the depth of water before jump is 0.47m. calculate the energy dissipated of the jump. What's the type of U.S.B.R. stilling basin of this case.?
A well pumps at a steady rate of 600m3/day in a confined aquifer. It is installed with a gravel pack in a hole that is 30 cm in diameter. The head in the pumping well is 427.9 m. The head in an observation well located 8 m away is 430.2 m. Calculate the transmissivity of the aquifer, assuming steady, radial flow.