100 moles of carbon monoxide at 250 degrees celsius is combusted with 100 moles of oxygen gas which is at 100 degrees celsius.if the product gases leave at 380 degrees celsius, how much heat is transferred to or from the system?

Q: Based on the topic stated and the data obtained, the rxn AB follows the mechanism given below. Step…

A:

Q: equilibrium constant of the reaction

A:

Q: A 10-mm-diameter Brinell hardness indenter yielded a hardness of 350 HB when 1250-kg | s used on a…

A: ASTM E10 defines the Brinell hardness test technique, which is used to determine Brinell hardness.…

Q: 6. Diffusivity. the diffusivity of volatile solvents is frequently measured using an Arnold cell.…

A: Given data: Zo=10 cm=0.1 mZt=0 PT=101.325 KN/m2PA2=53.3 KN/m2MA=84.9 g/mol=84.9×10-3 Kg/molρA=1.33…

Q: At 25°C, a binary mixture has the following values of activity coefficients X₁ 0.0115 0.0160 0.0250…

A: We are given the data for activity coefficients and fraction of components. We have to fit these…

Q: At 63°F, refrigerant R-22 has a weight of 21⁄5 pounds for each cu ft of the R-22in gaseous form. A…

A: Given At 63°F, refrigerant R-22 has a weight of 21⁄5 pounds for each cu ft of the R-22 in gaseous…

Q: With the aid of illustration, contrast and explain the difference between galvanic corrosion and…

A:

Q: Why is the fugacity a better way to consider phase equilibria compared to the molar Gibbs energy?

A:

Q: A 0.2160 g sample of primary standard grade HgO (MM = 216.59) was dissolved in 75 mL of an aqueous…

A: Given Primary standard grade HgO(MM=216.59)=0.2160 g Aqueous solution volume of KI=75mL Liberated…

Q: 2. If a centrifuge is 3 ft diameter and rotates at 1,000 rpm, the speed of a laboratory centrifuge…

A: When a particle of mass rotates in a centrifuge of diameter D at an angular velocity of ω, it is…

Q: maximum conversion of A.

A:

Q: A certain reaction proceeds in a constant - volume and isothermal CSTR: -TA = KC₂2.15 If the…

A:

Q: The following liquid phase reaction is done in a constant volume CSTR: A → P Which obeys the…

A:

Q: E- The work can be computed as: W = fp dv. Using a combination of the trapezoidal rule, Simpson's…

A:

Q: Determine which solutions with the higher ionic strengths (I). Assume that they are 100% ionized.…

A:

Q: 250 oC geothermal fluid flowing at 40 kg/s from an offshore well. The average ocean temperature in…

A: Steam is used in geothermal power plants to create energy. The hot water reservoirs that produce the…

Q: provide the handwritten solution because I can't understand it

A:

Q: The following gas phase reaction occurs in an isothermal packed - bed reactor: Which obeys the…

A: Write the reaction as follows: A → P   The rate equation is -rA' = k1PA1.5   Given, The initial…

Q: F 3) Create a Pxy diagram using Raoult's Law for water and methanol at 60 C. Make sure to label: A)…

A: Consider water as component one and methanol as component two. Partial pressures of these components…

Q: In a desert chemical plant, the operator wishes to store chilled water underground in a spherical…

A:

Q: The following liquid phase reaction is done in a constant volume batch reactor: A+S →P→ Which obeys…

A: We are given the following information: rate of reaction: -rA=k1CA1.31+k2CA2Liquid phase reaction…

Q: Create a Pxy diagram using Raoult's Law for water and methanol at 60 C. Make sure to label: A)…

A: P, x-y diagram of water and methanol at a given temperature is to be created.

Q: ) ascertain the fireball's maximum size and how long it will remain in the air. ) calculate the…

A: A. Within less than one millionth of a second after the weapon detonating, a fireball—a spherical…

Q: Milk, with specific heat 3.8 kJ/(kg. K), that has been pasteurised to 68 °C is being cooled down to…

A:

Q: Consider the flow of a fluid through the piping system shown below in Figure 1. Flow If D₁ = 4D2,…

A:

Q: Briefly explain solid and liquid separation in leaching process in hydro metallurgical Engineering

A: A compound can be extracted from a solid material that has been dissolved in a liquid by the process…

Q: A drying gas in cross-flow enters at one end of a stack of trays at 90°C and leaves at 70°C. The…

A: Given that, The inlet temperature of drying gas Th,1 = 90oC The exit temperature of drying gas Th,2…

Q: expression for the overall rate

A: Given, A + B↔ C Rate limiting Step - Desorption Step

Q: Q1// A liquid mixture of benzene-toluene is to be distilled in a fractionating tower. The feed of…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Calculate the pH of buffers that contain the acid and conjugate base concentrations listed below. a.…

A: Given Data  (a) [CH3COOH] = 0.45 M and [CH3COO-] = 0.75M pKa for acetic acid = 4.74

Q: Consider a gas with two components, A and B. Gas A has a partial pressure of 60 psi while gas B has…

A: Given that- Gas components=A+B Partial Pressure, PA= 60 psi Partial Pressure, PB= 45 psi Molar mass…

Q: der r a tensile test, it can be demonstrated that necking begins when the value of true strain at…

A: At maximum load, where the increase in stress owing to the specimen's reduced cross-sectional area…

Q: A stream of 220kmol/h of a binary mixture containing benzene and toluene (45 mol% benzene) needs to…

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved…

Q: steam injection heater

A:

Q: Q16: A) What do you understand by Gibbs phase rule, and explain in detail each term used in the…

A: As per Bartlebey guidelines, answer of first question should be given if different multiple…

Q: sensitivity of enthalpy and entropy

A:

Q: 4. What is the terminal velocity of a cubic steel particle, 0.40 mm in each side, settling in an oil…

A: Write the expression for terminal velocity as follows: vt = 2mgρACd     ......1   Here, vt is the…

Q: The general Ksp expression in terms of "S" (molar solubility) of FePO4 is: Select one: a. 10885 O b.…

A: Write the reaction for the dissociation of FePO4 as follows: FePO4  → Fe3+ + PO43- One mole of FePO4…

Q: Calculate the pH of buffers that contain the acid and conjugate base concentrations listed below. a.…

A:

Q: An equimolar solution of n-heptane and n-octane was subjected to Rayleigh distillation (single…

A: A mixture of n-heptane and n-octane is separated in a differential distillation column.

Q: For a binary liquid mixture at 301 K and 2.9 bar, we've measured the laboratory molar volume to be…

A:

Q: Consider the following gas phase reaction in an isothermal, isobaric batch reactor. The reactor is…

A: Given gas phase reaction in a batch reactor is- 3A → B+ C      -r1A=k1ACA3 For the reaction, the…

Q: Why do we need to define mass transfer coefficient? How mass transfer coefficient is different from…

A: Given information: Mass transfer coefficient Diffusion coefficient

Q: Derive the velocity profile of the fluid inside the two stationary plates. The plate is initially…

A: Considering a small volume of a cube and velocity profile is obtained then it is integrated to…

Q: 4.34 Consider the liquid-phase reaction system A →→ B, r₁ = k₁ CA k₂ C² A → C, (a) Will a PFTR or…

A:

Q: A manufacturer of beef sticks produces a wastewater flow of 2000 m³/day containing 120,000 mg/L…

A: Given, The flow rate of waste water, Vw = 2000 m3/day The concentration of salt in the waste water,…

Q: Consider 4 kg of austenite containing 0.45 wt% C, cooled to below 727 °C Composition (C

A:

Q: The following liquid phase reaction is done in a constant - volume CSTR: A+S →P→ Which obeys the…

A: The concentration expression in terms of initial concentration and conversion is considered. The…

Q: A liquid phase reaction A → 2.5 was done in a 100 L isothermal CSTR. Initially, the reactor is…

A: Given: The volume of the CSTR given is V = 100 L The volumetric flow rate is vo = 2 L/min The…

Q: Consider the flow of a fluid through the piping system shown below in Figure 1.

A: