100 m/s 120 m h 35 m Turbine 2) Generator Nturbine-gen 80%

Q: What is the flow rate of water through the system shown for the turbine to produce 20 kW. Neglect…

A: Given Data  Height, h= 30m   density =1000 Kg/m3.

Q: In a pumping system handling water, the level in the suction tank is 3m below the pump shaft…

A:

Q: In Francis turbine, the pressure gage leading to the turbine casing reads 385 kpa and center of…

A: Given data:

Q: The hydroelectric facility that has been proposed will consist of a turbine with an efficiency of…

A:

Q: S. A pump is to deliver 80 gpm of water at 140°F with a discharge pressure of 150 psig. Suction…

A:

Q: Florida Tidal power plant is one of the famous efficient tidal plant. What is the energy or power…

A:

Q: Maximizing the wind velocity of 92 m/s and 25 units of wind turbine was installed at the seaside…

A: Wind velocity, v= 92 m/s Number of turbines, n= 25 Area of the turbine blade, A= 42 m^2 Air density,…

Q: (b) A small centrifugal pump is used to pump 30°C water at the rate of 6 L/s with a head of 44.54 m.…

A:

Q: At the bottom of a pressurized water tank is a mouth with a diameter of 5 cm, where water is…

A: Fluid is a state of matter which deforms continuously on the application of force externally,…

Q: A small centrifugal pump is used to pump 30°C water at the rate of 6 L/s with a head of 44.54 m. If…

A:

Q: water circulates throughout a house in a hot water heating system. if the water is pumped at a speed…

A:

Q: 1Two water pumps are arranged in series. The performance data for both pumps follow the parabolic…

A:

Q: b. A client is desirous of pumping water at 60°F from one reservoir to another at 120 ft higher…

A:

Q: Through a duct air enters a fan at 6.3 m/s and an inlet static pressure 2.5 cm of water less than…

A: Solution is attached below:

Q: In a pumping system handling water, the level in the suction tank is 3m below the pump shaft…

A:

Q: Heavy oil is flows in a 40 cm diameter cast iron pipe f= 0.044. If the head loss due to pipe…

A:

Q: A tidal power plant of single basin type, has a basin area of 25 x 10 to power 6 m2. The tide has a…

A: Given dataBasin area = 25 x 106 m2Tide maximum height = 10 mTurbine stops operation below a head of…

Q: :Determine the absolute pressure at the inlet section of the pump. Flow rate of the pump Q=2,3…

A:

Q: he hydroelectric facility that has been proposed will consist of a turbine with an efficiency of…

A: Given:Efficicnecy of turbine=η=89.2%=0.892vertical depth of 14.8 m below the riverbedHydraulic…

Q: The penstock if hydro-electric plant is 0.5 x 0.5 m with velocity of 5.5 m/sec has a head of 20 m.…

A: .

Q: A turbine extracts 3 MW from a water flow with a rate of 23 m/s. The head loss across the turbine…

A: Find the pressure difference between 1 and 2. And elevation (h).

Q: Although hydraulic turbines considered one of the most efficient power plants, their ecological…

A: turbines are used to harness the electricity from the energy of water. Effect of Hydraulic Turbine…

Q: (a). Differentiate the following as applied to hydropower generation i). High head development ii).…

A: Hydropower : The energy we produce from running water or water falling from height is called…

Q: Question 1 2 = 40 m P2 = 350 kPa gage a2 = 1.0 1= 30 m P1 = 70 kPa gage a = 1.0 - Pipe D= 0.5 m head…

A:

Q: Three pipes are connected in parallel. The difference in heads in each pipe is 40 m. Pipes Diameter…

A:

Q: A pump is 2.2 m above the water level in the sump and has a pressure of –20 cm of mercury at the…

A:

Q: The tailwater elevation and the headwater elevation of a hydroelectric plant are 80m and 140m…

A:

Q: The diameter of the pipe is 100 mm and velocity of oil (SG=0.89) is found to be 3,4 m/s. 32.…

A:

Q: (2) As shown in hydraulic circuit below, the fixed delivery rate of hydraulic pump qp=120 mL/r,…

A: Gggg

Q: 5. Refer to the figure below. In a hydroelectric power plant, 70m/s of water (p = 010kg/m³) flows…

A:

Q: Water flowing at 0.5 m3/min enters the turbine of a micro-hydroelectric generator and delivers a…

A: The power delivered by the generator is 19.8 kW.

Q: A pumped storage power plant with a head of 150 m, with a flow rate of 6 cms for power generation…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: = constant d Q16/ A pipe diameter of 400 mm carries water at a velocity of 25 m/s. The pressures at…

A:

Q: Due to surface tension , water from faucet tapers from a diameter of 0.5 in to 0.3 in. after falling…

A: Given that: Water from faucet tapers from a diameter of 0.5 in to 0.3 in. after falling 10 in. It is…

Q: Q4. Water from a reservoir is conveyed via a pipeline of constant diameter and 1000m length to a…

A:

Q: A rotary pump directly connected to a 5-Hp electric motor operating at full load under following…

A: Given:Fluid Handled : 40 0API Oil  Temperature : 210C  Specific Gravity: 0.85  Volume Flow Rate : 20…

Q: A cylindrical tank with a large diameter is filled with water to a depth D = 0.402 m. A hole of…

A:

Q: A fully-filled open storage tower of height 32 m and diameter 3.0m supplies water to a house. A…

A: Consider the figure: Given:QB=0.0025 m3Applying Bernoulli's theorem between A and…

Q: Which quantities are added when two pumps are connected in series and parallel?…

A: When two identical pumps are arranged in series then head is double with same mass flow rate. When…

Q: For the water pump shown in the figure below, p1 = 13.3 psia and p2 = 49.5 psia. The temperature of…

A:

Q: 01: A stream of water of diameter d = 0.1 m flows steadily from a tank of diameter D = 1.0 m.…

A: Given Data  Diameter of stream of water, d=0.1m Diameter of the tank, D=1m Height of the tank, h=2m…

Q: As per common design practice, the three types of hydraulic turbines, in descending order of flow…

A: Given ; Hydraulic turbine is a rotary machine that converts kinetic energy and potential energy of…

Q: three immiscible fluid are contained in a tank 1.0 m of water, 1.20 m of oil (s=0.80 and air under a…

A:

Q: The net head of a little aquarium pump is given by the man- ufacturer as a function of volume flow…

A: From the given data,

Q: Q13. A tank is shaped like a circular cone, with its apex pointing down (like an ice cream cone).…

A: Given: For a circular cone h=7mrtop=4 mhwater=5mρ=1000 kg/m3g=9.8 m/s2 To solve

Q: If the static head of a fan which delivers 1,420 li/sec is 21.17 m. of air through a duct 30 cm in…

A:

Q: on the island, hydropower is expected to be extracted from a river of the river system via a pipe,…

A: Given :     Discharge Q= 35 m3/s ( February to may )    Discharge  Q= 115 m3/s ( June to January )…

Q: A sump pump (used to drain water from the basement of houses built below the water table) is…

A: m• = 0.85 L/s = 0.85 × 10-3 m3/s  P = 3.05 × 105 Pa. a) di = 2.8 cm = 0.028 m  ∆h = 2.4 m = 2.4 m…

Q: The brake horsepower and water horsepower of a pump are determined to be 15 kW and 12 kW,…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.