11 To increase the voltage in the system, :the modules are connected in (ähäi 2) .Series .Parallel

Q: DETERMINE ETH,RTH,IB,IC,IE,VB,VC,VE ,VCE

A: In this question,  We need to determine the Thevenin voltage Eth  , Rth ,  collector current, emitte...

Q: 3. Refer to the circuit shown C 120V, 60HZ Z = 10+j12 2 (a)What is the power factor? (b) What is the...

A:

Q: 1. Find the current Is using Ohm's and Wye Delta Transformation. Is 12 kN 18 k). 6 kN 12 V 4 kN 9 kN...

A:

Q: : Mention and explain any 4 the differences between conducting and Non-conducting wires

A: Conducting and Non-conducting wires:

Q: j4 2 10. Obtain the equivalent impedance of the circuit in Fig. 1.38. ell Zeg Lea j2 2 -j2 2 Fig. 1....

A: In this question,  We need to determine the equivalent impedance of the circuit as shown in the circ...

Q: Find inverse Laplace transform of 10 F(s) = (s + 2)(s² + 6s + 10)

A:

Q: The Boolean expression AC+BC is equivalent to ĀC+BC+AC O BC+AC+BC+ACBO AC+BC+BC+ABC O ABC+ABC+ABC+AB...

A: Given a Boolean expression, AC+BC¯

Q: E3.7 Use nodal analysis to find the current I, in the network in Fig. E3.7.

A: The node voltage can be obtained by using kirchhoff's current law at the node. 

Q: Q1/ A piece of resistance wire, 15.6 m long and of cross-sectional area 12 mm² at temperature of 0 °...

A:

Q: Q3 Given z,=(3+j4)² and z,= 2.5jej40x a. Find z¡+Z2 b. Find the magnitude and phase of z,z2

A: Given Z1=(3+j4)2 Z2=2.5ej40π

Q: Given the full-wave rectifier circuit shown below and given that the diode is made up of Silicon and...

A:

Q: A ferromagnetic core is shown in Figure PI-2. The depth of the core is 5 cm. The other dimensions of...

A:

Q: Find the voltage across 10-ohm resistor. 10ix 12 Ω 15Ω 4Ω 8Ω ix 6Ω V 102 10Ω 12 V 24 V

A:

Q: R3 = 1.5 k2 moa R1 = 1 kN R2 3 kN Vs= 12 V 2 mA o b

A:

Q: Justify: Mention and explain any 4 the differences between conducting and Non-conducting wires

A:

Q: Two 1-phase transformers A and B rated at 250 kVA each are operated in parallel on both sides. Perce...

A:

Q: A control system is represented by the block diagram as shown in Figure 3. a) Draw the root locus di...

A:

Q: Design the CMOS diagram for the following Table: (A, B & C are the inputs and Y is the output in the...

A: We have to design the cmos diagram 

Q: Three vectors A, B and C lie on the 3D RCS. The scalar product of A and B is equal to -2. The scalar...

A:

Q: Two impedance Z, = 2+j3 and Z, = 3 +j6, are connected in parallel. The apparent power of the second ...

A:

Q: In the balanced three phase power measurement using two wattmeter method, each wattmeter reads 12 kW...

A: Two wattmeter method is used for the measurement of three phase power having unbalanced load.

Q: 3. Determine: Branch currents and power in each resistor Kirchhoff's Laws

A: Apply KVL in loop 1-20+5i1+3i1-i2+5=08i1-3i2=15 ...... (1)Apply KVL in loop 24i2-5+2i2-i3-5-5+3i2-i1...

Q: Data collection Voltage: 20.1W Current: T1 T2 T3 T4 T5 T6 T7 52.6 C 50.3 C 48.1 C 37.0С 27.4 C 26.4 ...

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: Find the voltage VA in the circuit shown in Fig. (i). Use simplified mode 15 V Si Ge 3 k2 (i) 3.

A: In this question,  Find the voltage VA  as shown in the circuit?  Assume forward bias voltage for si...

Q: Vz-0.98 - 0.06 j Z12 400 MW 250 Mvar Z13 Z4 24 Slack Bus 3 V = 1.05+0.0j V - 1.0-0.05j Va- 0.95 - 0....

A:

Q: 5. A Michelson interferometer is used to measure the spectrum line width of the light beam generated...

A:

Q: In a series-parallel circuit, the two parallel branches A and B are in series with C. The impedances...

A:

Q: Compute the charge stored on a 4-pF capacitor with a 24V across it.

A: The charge stored in a capacitor, Q in coulomb as the product of the capacitance C (in Farads) of th...

Q: Rea (2) -R (3) 을 (4) 극R (1) (5) R (6) R (7) R (8) R (9) R (10) 9R RI

A: Brief description : Resistor is an electrical element which is used to limit the amount of flow of c...

Q: Given tree impedances: zl = 10 + j0, Z2= 3 + j4 and Z3 = 8 – j6. Impedances Z2 and Z3 are connected ...

A:

Q: 5. Will the lamp become bright or dim or stay the same when we move the brush to the right? Why Will...

A:

Q: 12. A power signal x(t) with no signal power outside the frequency range - fe/100 < f < fe/100 is mu...

A:

Q: A resistor R is connected in parallel with a 10 ohm inductive reactance. The combina then connected ...

A: Solve the problem

Q: 1. Identify the different symbols seen in the schematic diagram. Write it in a piece of paper and ca...

A: The given circuit is as shown below, We need to identify the symbols in the circuit and make a bloc...

Q: 4. The rand om variables x8y are independent and each is Uniformo in the interval Có, a). find the c...

A: Brief description:  Given that X &amp; Y are random variables which are distributed uniformly in the...

Q: + VEE Given: VCC = 3.00 V VEE = 9.00 V VEB = 0.74 V RE RB2 RB1 = 20 kOhm RB2 = 2.20 kOhm RC = 3.20 k...

A:

Q: Ex. Calculate the PA for the follow assembly code which is assume the DS = 4500h, SS = 2000h, BX = 2...

A: Registers can be used instead of using memory which is smaller in size and takes less time to be acc...

Q: 1. A relay coil is connected to a 210-V, 50-Hz supply. If it has a resistance of 30 2 and an inducta...

A:

Q: C1 L C2 C3 100v C4 C1= 10µF C2= 15µF C3= 5µF C4= 20µF Find the equivalent capacitance of the ci Find...

A:

Q: We want to install the 2000-meter wire in the college building, which one testing is the most import...

A: Here, we required to install the 2000-meter wire in the college building.  

Q: Charge per unit volume is called as Estimated Time for completion: 1 minute Ps Pv O PI

A: Given: Charge per unit volume

Q: A parallel circuit consists of a resistor having a conductance of 4 siemens, an inductive reactor ha...

A:

Q: In the 555 timer timing diagram shown below, the capacitor charge voltage controls the of the pin 3 ...

A: Answer: period(Time period) Time period(T)= t1 (high) + t2(low) So second option alone is wrong and ...

Q: Five resistors are connected in parallel. Compute for the (a) total resistance, (b) current flowing ...

A: Given, Five resistors are connected in parallel R1=10 Ω;R2=20 Ω;R3=30 Ω;R4=40 Ω;R5=50 Ω; V= 220 V  

Q: *11. Find Vs for the network of Fig. 7.84. 20 V 2.2 k2 Ipss = 4.5 mA Vps Vp =-5 V I ss = 6 mA Vp = -...

A:

Q: |2 A |I2 I3 I 6Ω 9Ω R E P = 12 W

A:

Q: What is the total capacitance of 20 capacitors, each of 10 µF, in series?

A: As we know that  The formula of equivalent capacitance is given as(if capacitance are same)- Ceq=( C...

Q: Question 1 Find the current, I which pass through 52 resistor by using Norton equivalent circuit. 2Ω...

A:

Q: A.  One way to think of the basic logic gate types (all but the EXOR and EXNOR) is to consider what ...

A:   a) The output of the NOR gate is low for any high input. The truth table of the NOR gate is shown ...

Q: A 25-hp 240-V 77.8-A shunt motor has an armature resistance of 0.083 N and a field-circuit resistanc...

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.