11.19 An abc-sequence set of voltages feeds a balanced three-phase wye-wye system. The line and load impedances are 1 + jl N and 10 + j1o n, respectively. If the load voltage on the ca phase is VAN = 110/30° V ms, determine the line voltages of the input.

11.19 An abc-sequence set of voltages feeds a balanced three-phase wye-wye system. The line and load impedances are 1 + jl N and 10 + j1o n, respectively. If the load voltage on the ca phase is VAN = 110/30° V ms, determine the line voltages of the input.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.51P: A three-phase line with an impedance of (0.2+j1.0)/ phase feeds three balanced three-phase loads...

See similar textbooks

Related questions

Q: For the bridge rectifier circuit shown in the Figure, assuming practical diodes, the peak value of…

A: We need to find out peak voltage and voltage across resistor .

Q: oblem: Based on the following block diagram answer the following questions. m,(1) ー20:Hに 20kHz 1(1)…

A: We need to find out the spectrum of the given signal .

Q: Assuming ideal diode the voltage across the resistor R2 in the circuit shown in the Figure is: R1 E1…

Q: 5. A welder machine operates automatically as follows : 30A current in 10 seconds, 20A in 10 sec.,…

A: In this question we will find RMS value of given waveform....

Q: For a voltage divider JFET

A: JFET- Full form of JFET is Junction Field Effect Transistor it the simplest form of field-effect…

Q: (b) The single-line diagram and the data for each device of three-phase power system are shown in…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: Vcc = 20 V 4.7 k2 220 k2 Vc Cc VB V; o Сс B= 180 Sos = 30 uS 56 k2 CE 2.2 k2

Q: esign a self-bias network using a JFET transistor with IDSS=8 in mA and VP=-5V to have a Q-point at…

Q: 10. A new cable section is being spliced to replace a broken section of cable. The loss before the…

A: The solution is given below

Q: Find Z m tlee Circuit below, given that Vo = 4 Lo v - Vo 20-8

Q: For a gated S-R latch, determine the Q and Q outputs for the inputs in below Show them in proper…

A: In this question we need to determine output

Q: Design and sketch the block diagram of the receiver that will recover signals, m, (t) and m(t) from…

A: According to the question, for the given transmitter as shown below We need to design and sketch…

Q: Use a Karnaugh map to find the minimum SOP form for each expression: la) АВС + АВС + АВС [b) А(ВС +…

Q: Given the transistor circuit with beta as 100, solve the ff: a. Base Voltage b. Collector Voltage c.…

A: Circuit diagram is given as,

Q: In an FM System, the andic Prequemey is IKH2 aned the andio Voltage is zv. The deviation is 4 KH2.…

Q: Consider the following RLC circuit with an input voltage denoted as x(t), and an output voltage…

A: Solution- a) from the RLC circuit, xt= itR+Ldidt+ytwhere yt=1C∫-∞tit dt yt =1C∫0tit dt…

Q: For the circuit in Figure Q2(a), the switch has been closed for a long time, and it is opened at t =…

A: The solution is given below

Q: A moving iron voltmeter reads 250v when connected to 250v dc .if connected to 250v 50 Hz .the…

Q: 100 μ HE 50 µF 12Ω HE 1.6 mH ig = 5 cos 2500t A vg = 20 cos(2500t + 90°) V. For the circuit above,…

A: The solution is given below

Q: If module with 60 cell measures Voc = 39.3V. What is the open circuit voltage for a module with 72…

Q: Discussion and conclusion based on the pic

Q: A DC compound generator has no-load armature current of 1A. Armature resistance is 1N and shunt…

Q: he transistor circuit with beta as 10o. Answer the following items below. Ok Ohrh 16 V 2.7 k Ohm

Q: determine the line currents

Q: Using Fig. P12.40, at what frequency does

Q: Determine VTh at terminals a-b for the following circuit: 300 360 V 1500 R.Q b O 300V O 100V O60V O…

Q: 1.90 V 16

A: Current in series connection and voltage in parallel connection remain same Current in parallel…

Q: 5 An abc-phase-sequence three-phase balanced wye- connected source supplies power to a balanced…

Q: The condition of circular polarization . .is

Q: Design a 5-bit adder-subtractor circuit using to illustrate the following operations: (a) 25-9 (b)…

Q: Assuming ideal diode the voltage across the resistor R2 in the circuit shown in the Figure is: R1 E1…

Q: For a power station, the yearly load duration curve is a straight line from 40,000 to 3000 kw. To…

Q: 2. For the below logic circuit, draw the Waveforms at the numbered points. A A B B D D E E F F

Q: Inputs Output АВС X 0 0 0 1 0 0 1 0 1 0 1 0 11 1 100 1 10 1 1 10 1 111 1

A: The solution is given below

Q: (ii) A 2-stage amplifier have two identical amplifiers, each with a dominant lower cut- off…

A: A 2-stage amplifier has two identical amplifiers, each with a dominant lower cut-off frequency of…

Q: Q1/ In the circuit of Fig.(1) R=10000, L=0.3H, C=2.2 uF and Vs=100v A. Calculate the characteristic…

A: Q/1

Q: Determine h and g parameters of Fig 3 as function of s . 2 H 3 H ll 4Ω ww- 2 F

Q: 3. Determine the node voltages V1 and V2 using node analysis. Present your solution similar to my…

Q: Q5) A source emits 7 messages with probabilities [1/2 1/4 1/8 1/16 1/32 1/64 and 1/64 ], find the…

Q: If module with 60 cell measures Voc = 39.3V. What is the open circuit voltage for a module with 72…

Q: Determine h and g parameters of Fig 3 as function of s. 2 H 3 H wll 2Ω 4Ω -ww- ll 2 F

Q: A moving iron voltmeter reads 250v when connected to 250v dc if connected to 250v 50 Hz .the…

Q: 270 k Ohrm 16V 2.7k Ohm

Q: 1 A resistance of 20ohms, an inductor of 0.2H and a capacitance of 100uF are connected in series…

Q: A magnetically coupled coil has mutual reactance of 5.655 ohms, inductive reactance in coil 1 of 15…

Q: Given the circuit below, please solve for the following: a. What is the configuration of the…

A: In this question we will write about given amplifier configuration related answer....

Q: 1. What types of connections are possible for three-phase generators and loads? 2. What is meant by…

Q: How would I find the thevenin equivalent rsistance using the Delta-Wye conversion?

Q: 11.15 An abc-phase-sequence three-phase balanced wye-connected 60-Hz source supplies a balanced…

A: In this question we need to find a line current of the given system

Q: Calculate a. Current in each resistor b. Voltage in each resistor c. Power in each resistor R1 R2 BM…

A: The electrical circuit is a closed-loop network that provides a means of restoring energy flow or a…

Question

i need the answer quickly

11.19 An abc-sequence set of voltages feeds a balanced
three-phase wye-wye system. The line and load
impedances are 1 + jl N and 10 + j1o n,
respectively. If the load voltage on the ca phase is
VAN = 110/30° V rms, determine the line voltages of
the input.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A three-phase line with an impedance of (0.2+j1.0)/ phase feeds three balanced three-phase loads connected in parallel. Load 1: Absorbs a total of 150 kW and 120 kvar. Load 2: Delta connected with an impedance of (150j48)/phase. Load 3: 120 kVA at 0.6 PF leading. If the line-to-neutral voltage at the load end of the line is 2000 v (rms), determine the magnitude of the line-to-line voltage at the source end of the line.
A balanced three-phase source with grounded neutral has line-to-line voltages of 208 volts with ab-bc-ca sequence. It supplies power to an unbalanced three-phase wye, neutral grounded, load with impedances: Zan = 18-j10; Zbn = 15+j25; Zcn = 20+j30 ohms. What is the magnitude of the overall total apparent power of the system in va?
An abc-phase-sequence three-phase balanced wye-connected source supplies a balanced delta-connected load. The impedance per phase of the delta load is 24+j6 Ω. If Vab=115/∠20° V rms, Find the phase current Iab and the line current Ia.
A 12,470V, three-phase, three wire source supplies a balanced wye load having an impedance of 50 angle -30° ohms per phase. Find the magnitude of the rms line current.
Three identical impedances of 10∠ − 15° Ω to a line voltage of 208 V in star connectedconnected to a balanced source. We accept all line and phase voltages and currents as Vca as reference.Calculate in the form (Assume positive order).
in a balanced, 3 phase, positive sequence, grounded neutral source, supplies power to a balanced wye connected load. with the following conditions: Ibc = 9.0 cis 237 degrees amps; and true power per phase is = 343 watts, with 0.55 power factor lagging What is the value of the reactance per phase of the delta load in ohms? (Place negative sign for capacitive reactance.)
A balanced delta connected load of "14+j19" 2- per phase is connected at the end of a three-phase line. The line impedance is "6+18j" 2- per phase. The line is supplied from a three-phase source with a line-to-line voltage of 207.85 Vrms. Taking phase "a" voltage Va as reference, determine the following: (a) Current in phase a. (b) Total complex power supplied from the source. (c) Magnitude of the line-to-line voltage at the load terminal.
in a balanced, 3 phase, positive sequence, grounded neutral source, supplies power to a balanced wye connected load. with the following conditions: Ibc = 9.0 cis 237 degrees amps; and true power per phase is = 343 watts, with 0.55 power factor lagging What is the value of the reactance per phase of the delta load in ohms? (Place negative sign for capacitive reactance.) ANSWER QUICKLY
1. A balanced 3-phase Y-connected source has using positive phase sequence, ?an = 390∠30˚ ?. Find the complex expression of voltage Eab.
A balanced delta connected load of 13+j16 ohm per phase is connected at the end of a three-phase line. The line impedance is 2+j11 ohm- per phase. The line is supplied from a three-phase source with a line-to-line voltage of 207.85 Vrms. Taking phase "a" voltage Va as reference, determine the following: (a) Current in phase a. (b) Total complex power supplied from the source. (c) Magnitude of the line-to-line voltage at the load terminal.
A balanced 3-phase, delta-connected load is connected across a 208 V, balanced 3-phase, ABC source. If it dissipates 10 KW at 60% p.f. lagging, its impedance (polar form) per phase is?
A balanced three-phase 60Hz abc systems feeds two delta connected loads in parallel. Load 1 draws 40 kVA (Apparent Power) at a lag pf of 0.8, while load 2 absorbs 24 kW (average power) at a lag pf of 0.9. The line-to-line voltage at the loads, between phase A and B, is VAB = 440 angle 30 V rms. Find: a) The phase current IAB1 for load 1. b) The power factor of the combined loads. Thank you for your assistance.