12 and 13?

Q: 3 If the difference equation is given by 3 - y(n − 1) 4 y (n) = 2y6 1 = y(n − 2) + x(n) + + x(n 8 3…

A:

Q: F(A,B,C,D) = Σ(1,3,4,11,12,13,14,15)

A:

Q: what is the realistic channel capacity of a communication channel of 25KHZ that has 20db signal to…

A: Given data,Signal-to-noise ratio (dB) SNR(dB)=20 dB Bandwidth BW=25×103 Hz

Q: give details process of measurement of insualtion resistance of various types of cables.

A: We have to give details process of measurement of insulation resistance of various types of cables.

Q: Q4/ Determine the Fourier series expansion of the waveform x(t) shown below: -2rt -10 3 -3 Good Luck…

A:

Q: What is Resistance and inductance.

A: Definition of Resistance and Inductance.

Q: value to steady-state level. E R₁ www 4.7 ΚΩ 36 V Fo IL 8 mA VL L voo 120 mH R₂3.9 kn ΚΩ

A:

Q: Find the expression for the v(t) and current i(t) of the capacitor as a function of time for the…

A:

Q: Briefly explain why it is important to consider the effects of temperature changes  when designing…

A: Various electronic components are designed to work for a specific range of temperature, when the…

Q: Two chemical tanks, each with a sensor Light an LED RED when any tank is < 25% full Sensor output:…

A: The required circuit can be designed using the truth table derived based the given condition and the…

Q: From the response below, determine the values of Mp, Tp and T§. Amplitude 1.8 1.6 1.4 1.2 0.8 0.6…

A:

Q: Find the expression for the voltage v(t) and current i(t) of both the capacitor and the inductor as…

A: The required parameters can be obtained by analysing the circuit at time t&lt;0 and after t=0 to get…

Q: The switch in the circuit in Figure 8 changes position from position b to position a at t=0 a) Find…

A: In this question We need to determine the voltage across the capacitor and current in the resistance…

Q: What is the closed-loop bandwidth of the amplifier shown in Fig. R₁ own Vin AOL = 150,000 fc(OL) =…

A:

Q: In the circuit shown find v(t) and current i (t) for t> 0 and the what percentage of the initial…

A: We need to find out the current for inductor and voltage for resistor for given circuit.

Q: A 60 Hz sinusoidal voltage is applied to an SCR full-wave rectifier. If the DC output voltage is 58…

A: The average dc output voltage of the full-wave SCR rectifier is given by the expression as shown…

Q: OO Which of the following material is not considered a semi-conductor? Silicon germanium carbon…

A:

Q: Ⓒ₁(s) + - Ks D Kp Process G(s) The process transfer function G(s) = - e(s) Calculate the values of…

A:

Q: • If a circuit has R= 1022, X₁ =1002 and Xc =1002, what will be the effective impedance (Z) for this…

A: .Given: R=10Ω XL=10Ω XC=10Ω Need to calculate total impedance.

Q: Required information Problem 09.001 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS Consider the…

A:

Q: Problem 6 Find the values for R, and X, that result in maximum power transfer if X, cannot exceed a…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: The ciren't below is in sheady state before the switch changer position at to 0 seconds. Find It (1)…

A:

Q: For Wheatstone bridge circuit, the following values are given. Vsupply=120V; R₁ = 15 №; R₂ =30Ω; R3…

A: When R1 will get disconnected then this will not work as balanced wheatstone bridge. So we will…

Q: Question One A dynamic system is represented by the following transfer function representation:…

A:

Q: Find the ratio V.(s)/V(s) for the electrical network shown in below

A: The required transfer function can be obtained by using the mesh analysis to the given electrical…

Q: .A 110-V dc motor draws a current of 30A and is located 500 ft from the power source. What is the…

A: Given data, Back EMF of motor Eb=110 V. Armature current Ia=20 A. Length l=500 ft = 15240 cm.…

Q: 2. Find 1₁, 12 and 13. 1522 M 30V + 52 SI₁ W 12 30 W 12.2 13 دل 18 302 M 2012 2012

A:

Q: u(t) v 10 - 4 : To - 1 -HA 2 حمل Volk ۱ t ye will u

A:

Q: Solve for the value of the capacitance (in nF unit) if R2-1017 ohms and Xc = 2316 ohms. Round your…

A: The question is about finding capacitance value.

Q: 125" ΖΩ 3Ω 1 I 49 (+) 452 4Ω (13 +1 |240

A:

Q: B C 0 0 0 1 1 0 1 1 0 0 0 1 1 1 0 1 1 1 TABLE 3. F = (C, AB) A 0 0 0 0 1 1 F 1 0 1 1 1 1 0 0

A: Note: Types of basic Gates AND Gate OR Gate NOT Gate NAND Gate NOR Gate

Q: Solve the circuit of Exercise 3 using the mesh current method. What advantage does the method of…

A: The required parameters can be calculated by using mesh analysis and the mesh equation can be…

Q: 22 ΚΩ R₁ Αλλά 150 ΚΩ (b) (c) Refer to Figure (c). The closed-loop gain, Act, is φα ww R 19 582 ΚΩ R₁…

A:

Q: Ferramenta de Graph the amplitude and phase spectra of the functions A(z) = 1 − z¯¹ and B (z) =…

A: Given: A(z)=1-z-1,B(z)=z-z-12, To find: Graph the amplitude and phase spectra of the functions.

Q: What is the minimized expression of f=xZ+yz+yz + xyz A Z+XY B с z + xy Z+XY D Z+xy

A: Given- Boolean expression, F=x.z+y.z+y.z+x.y.z   To find- Minimized expression.

Q: For R1=202, R2=430, R3-185, R4-480, R5=455, R6-170, V1-8 V & I1=2 A in the shown circuit, using the…

A:

Q: M₁ Vino M Rs VDD M₂ o Vout • Vo

A:

Q: A transmission line is being built to bring power to a remote community, which is 40 miles from the…

A:

Q: Q1/ After determine E to set the probabilities source vector, find: a) The Huffman codes of the set…

A: 1) Given, P(xi) =[0.1, 0.05,0.2,0.25,0.05,0.01,F] We need to find value of 'F' and then determine a)…

Q: Consider the RC circuit in the figure. Take R = 10. + V₁ 10 R 20 nF + V₂ Calculate the phase shift…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: • If an electrician changed the old gauge #8 wire to a new gauge #10 wire of the same length. What…

A: The resistance of the wire is based on the gauge size of the wire. To increase the current rating…

Q: A certain op-amp has three internal amplifier stages with midrange gains of 30 dB, 40 dB, and 20 dB.…

A: Operation Amplifier: We will see that operational amplifiers are linear devices with all the…

Q: Example: Find the Z.T of x(n) = 28(n − 3)+28(n-5) Example: Find the poles and zeros of the transfer…

A: The given problem is from z transform.  The detailed solution is given in the next step

Q: In high voltage engineering( brielfy explanation each ionization and parts)   What do you mean by…

A: Gases behave as near-perfect insulators at normal temperature and pressure. However, it is said to…

Q: The series circuit has Vsupply 12Volts, R₁ =1K2, R₂ =2 KQ R3 = 3 KQ; • What is the power dissipater…

A:

Q: The single-phase half-wave controlled rectifier supplies a resistive load drawsan average current of…

A: Given data, Average current i0=1.62 A. Supply voltage V = 240 V. Frequency f = 50 Hz. Average output…

Q: Problem 10.003 - Nodal analysis in circuits with voltage sources Calculate the output voltage vo(t)…

A:

Q: 1. Simplify the block diagram shown in Figure 1 and obtain the closed-loop transfer function…

A: The given problem is from block diagram reduction techniques.  The detailed solution is given in the…

Q: Consider the DC motor shown in Figure 2. Drive the transfer (s)/V(s). Assume that all initial…

A: Types of DC Machine control Armature controlled DC Machine Voltage controlled DC Machine Flux…

Q: For Wheatstone bridge circuit, the following values are given. Vsupply=120V; R₁= 15 №; R₂ =300; R3 =…

A:

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.