12. A circuit consists of a cell of 6.0V electromotive force (emf) 6.0 V and negligible internal resistance connected to two resistors of 4.0 Q. The voltmeter has a high enough resistance to be considered ideal. 4.00 4.02 V The ammeter has a low resistance but may not act ideally (it is not known if the ammeter is acting ideally or not). Which of the following are possible readings on the ammeter and voltmeter?

12. A circuit consists of a cell of 6.0V electromotive force (emf) 6.0 V and negligible internal resistance connected to two resistors of 4.0 Q. The voltmeter has a high enough resistance to be considered ideal. 4.00 4.02 V The ammeter has a low resistance but may not act ideally (it is not known if the ammeter is acting ideally or not). Which of the following are possible readings on the ammeter and voltmeter?

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter18: Direct-Current Circuits

Section: Chapter Questions

Problem 41P

See similar textbooks

Similar questions

. The lightbulb used in a computer projector has a resistance of What is the current through the bulb when it is operating on 120 V?
Assuming a constant temperature coefficient of resistivity, what is the maximum percent decrease in the resistance of a constantan wire starting at 20.0°C?
A copper wire has a resistance of 0.500at 20.0°C, and an iron wire has a resistance of 0.525at the same temperature. At what temperature are their resistances equal?
Consider the circuit below. The battery has an emf of = 30.00 V and an internal resistance of r = 1,00 . (a) Find the equivalent resistance of the circuit and the current out of the battery. (b) Find the current through each resistor, (c) Find die potential drop across each resistor, (d) Find the power dissipated by each resistor, (e) Find the total power supplied by the batteries.
(a) F ind the voltage drop in an extension cord having a 0.0600-O resistance and through which 5.00 A is flowing. (b) A cheaper cord utilizes thinner wire and has a resistance of 0.300 O. What is the voltage drop in it when 5.00 A flows? (c) Why is the voltage to whatever appliance is being used reduced by this amount? What is the effect on the appliance?
If the 0. 10.0-mm-diameter tungsten filament in a light bulb is to have a resistance of 0.200 at 20.0C , how long should it be?
Integrated Concepts (a) Assuming 95.0% efficiency for the conversion of electrical power by the motor, what current must the 12.0-V batteries of a 750-kg electric car be able to supply: (a) To accelerate from rest to 25.0 m/s in 1.00 min? (b) To climb a 2.00 102-m- high hill in 2.00 min at a constant 25.0-m/s speed while exerting 5.00 102 N of force to overcome air resistance and friction? (c) To travel at a constant 25.0-m/s speed, exerting a 5.00 102 N force to overcome air resistance and friction? See Figure 20.44.
What is the internal resistance of an automobile battery that has an emf of 12.0 V and a terminal voltage of 15.0 V while a current of 8.00 A is charging it?
When an unknown resistance Rxis placed in a Wheatstone bridge, it is possible to balance the bridge by adjusting to be 2500 . What is Rxif R2R1 = 0.625?
If a potentiometer is used to measure cell emfs on the order of a few volts, why is it most accurate for the standard emfs to be the same order of magnitude and the resistances to be in the range of a few ohms?
The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.
A cheaper cord utilizes thinner wire and has a resistance of 0.300Ω. What is the voltage drop in it when 5.00 A flows?