12.a. An electrical device would also fall into the classification of an electric(al) A. motor. B. load. C. component. D. fitting. 12.b. A short circuit describes the condition where there's contact between the A. hot wire and the neutral wire. B. grounded conductor and the grounding wire. C. hot wire and the grounding wire. D. neutral wire and the grounded conductor.

12.a. An electrical device would also fall into the classification of an electric(al) A. motor. B. load. C. component. D. fitting. 12.b. A short circuit describes the condition where there's contact between the A. hot wire and the neutral wire. B. grounded conductor and the grounding wire. C. hot wire and the grounding wire. D. neutral wire and the grounded conductor.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter34: Motor Installation

Section: Chapter Questions

Problem 9RQ

See similar textbooks

Similar questions

What is electrical earthing ans its type?
Define the term Conductors
A 25-HP, continuous-duty, three-phase squirrel-cage induction motor is connected to a 240-volt line. The conductors are run in conduit to the motor. The motor does not have a NEMA design code listed on the nameplate. The termination temperature rating of the devices is not known. Copper conductors with THWN insulation are to be used for the motor connection. What size conductors should be used?
What is a conductor
All answers should be written in complete sentences. Calculations should be shown in detail, and Codereferences should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC. 1. What is the minimum conductor ampacity, overload protection, and dual-element fuserating for a circuit supplying a 560-volt, 3-phase, code J, 40°C, 125-horsepower motorwith a nameplate full-load current of 115 amperes?
Classify and give a detailed discussion of each category of power conductor and cables.
Signals and systems course.
All answers should be written in complete sentences. Calculations should be shown in detail, and Codereferences should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC. 1. What are the minimum allowable ampacities of the phase conductors and the neutralconductor that are to supply a 2-phase, 3-wire, 230-volt, 30-horsepower motor?
26a)Select suitable material for sole electric plug and explain the selection procedure for selecting suitable material for sole electric plug?
Explain insulation coordination
Signals and system
#10 When selecting conductors, from where is the motor full - load ampere rating to be taken