Q.7 What are the minimum allowable ampacities of the phase conductors and the neutral conductor that are to supply a 2-phase, 3-wire, 230-volt, 30-horsepower motor? Select one: A. PHASE = 69 AMPERES; NEUTRAL = 97.29 B. PHASE = 69 AMPERES; NEUTRAL = 67.29 C. PHASE = 97.29 AMPERES; NEUTRAL = 69 D. PHASE = 99 AMPERES; NEUTRAL = 97.29

Q.7 What are the minimum allowable ampacities of the phase conductors and the neutral conductor that are to supply a 2-phase, 3-wire, 230-volt, 30-horsepower motor? Select one: A. PHASE = 69 AMPERES; NEUTRAL = 97.29 B. PHASE = 69 AMPERES; NEUTRAL = 67.29 C. PHASE = 97.29 AMPERES; NEUTRAL = 69 D. PHASE = 99 AMPERES; NEUTRAL = 97.29

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter15: Dryer Outlet, Lighting, And Receptacle Circuits For The Laundry, Powder Room, Rear Entry Hall,and Attic

Section: Chapter Questions

Problem 15R: a. Must the metal frame of an electric clothes dryer be grounded? ___________ b. Is it permitted to...

See similar textbooks

Similar questions

What are the minimum allowable ampacities of the phase conductors and the neutral conductor that are to supply a 2-phase, 3-wire, 230-volt, 30-horsepower motor
11.a. Which of the following is a point where a grounding electrode conductor connection must be made inthe communication system?A. The flexible nonmetallic power service racewayB. The grounding electrode conductor or metal enclosure for a grounding electrode conductorC. The space opposite the service equipment enclosureD. The grounded exterior metal water piping system within six feet of the point where it enters the building11.b. The equipment grounding conductor of a pump motor for a swimming pool must be grounded with asolid copper conductor that's no smaller thanA. AWG 8.B. AWG 12.C. AWG 10.D. AWG 6.
Considering the termination temperature ratings of the equipment used in residential wiring, discuss why electricians usually determine conductor ampacity based on the 60°C column of Table 310.15(B)(16
All answers should be written in complete sentences. Calculations should be shown in detail, and Codereferences should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC. 1. What is the minimum conductor ampacity, overload protection, and dual-element fuserating for a circuit supplying a 560-volt, 3-phase, code J, 40°C, 125-horsepower motorwith a nameplate full-load current of 115 amperes?
. A commercial Building, 60hz, Three Phase System, 230V with total highest Single PhaseAmpere Load of 1,088 Amperes, plus the three-phase load of 206Amperes including thehighest rated of a three-phase motor of 25HP, 230V, 3Phase, 68Amp Full Load Current.Determine the Following through showing your calculations. The Size of THHN Copper Conductor (must be conductors in parallel, either 2 to 5sets),TW Grounding Copper Conductor in EMT Conduit.b. The Instantaneous Trip Power Circuit Breaker Sizec. The Transformer Sized. Generator Size
Look at the photo and answer the following questions it Is a 6 pole, non-salient pole design, 3 phase ac generator, 10 volts induced in each coil. 1. What is the total voltage induced in each of the three phase belts? 2. What is the line voltage between L1&L2? 3. What is the line voltage between L2&L3? 4. What is the line voltage between L1&L3?
What precautions must be utilized and maintained when setting up or using a Delata 4 wire system that is to serve both 240 V and 120 V single phase loads?
All answers should be written in complete sentences. Calculations should be shown in detail, and Codereferences should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC. 1. What are the minimum allowable ampacities of the phase conductors and the neutralconductor that are to supply a 2-phase, 3-wire, 230-volt, 30-horsepower motor?
5. How many system bonding jumpers normally are there for a separately derived system that's grounded? A. ThreeB. TwoC. One D. Zero 6. How many grounded neutral conductors are in a 208Y/120 volt, 3-phase, 4-wire system? A. ThreeB. TwoC. One D. Four 7. Which of the following are sometimes installed as an emergency system, legally required standby system, or optional standby power system for a building or structure? A. GeneratorsB. Surge protection devices C. Surge arrestersD. Transformers 8. If the system bonding jumper in a DC system is a screw, what color must the screw be? A. WhiteB. RedC. Orange D. Green 9. If overcurrent protection is provided in the transformer of a separately derived system, which of the following statements is correct? A. An equipment grounding conductor must be run with the conductors between the transformer and the building's disconnect. B. There's no need for service equipment or a panelboard in the separate building.C. A ground electrode must…
Airframe Electrical System Question: Name two acceptable conductor types used in aircraft wiring? (Textbook : FAA AC 43.13-1B/2B
Why do multiple conductors in dc, 1-phase, and 3-phase power cables not disturb the magnetic compass needle on ships? Explain why the twisted pair of 1-ph wire is even better than multiple-conductor cables for the magnetic compass.
Determine the minimum current for conductors required to connect a motor that has a full-load current of 46 A.