12-109. The catapult is used to launch a ball such that itstrikes the wall of the building at the maximum height of itstrajectory. If it takes 1.5 s to travel from A to B, determinethe velocity va at which it was launched, the angle ofrelease 0, and the height h.B3.5 ft18 ft

Data given - t = 1.5 sec So = 3.5 m S = 18 m

Answered: 12-109. The catapult is used to launch…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

14-67. The assembly consists of two blocks A and B which have a mass of 20 kg and 30 kg, respectively. Determine the speed of each block when B descends 1.5 m. TI1c blocks are released from rest. Neglect the mass of the pulleys and cords
P13-2. The 10-kg block is subjected to the forces shown.In each case, determine its velocity at s=8m if v=3m/sat s=0. Motion occurs to the right.
If the rod of negligible mass is subjected to a couple moment of M = (30t^2) N⋅⋅m, and the engine of the car supplies a traction force of F = (15t) N to the wheels, where t is in seconds, determine the speed of the car at the instant t = 12.5 s. The car starts from rest. The total weight of the car and rider is 1.5 kN. Neglect the size of the car.
If the ball has a mass of 25 kg, determine the tension in the cord atthe lowest point θ = 0 °with an initial speed v = 4 m/s. Also,determine the angle θ to which the ball swings and momentarilystops. Neglect the size of the ball.
14-76. The 4-kg smooth collar has a speed of 3 m/ s when it is at s = 0. Determine the maximum distance s it travels before it stops momentarily. The spring has an unstretched length of l m
The 5-kg smooth collar has a speed of 3 m/sm/s when it is at s = 0. The spring has an unstretched length of 1 mm. Determine the maximum distance ss the collar travels before it stops momentarily.
Show that the girl at A can throw the ball to the boy at B by launching it at equal angles measured up or down from a 45° inclination. If VA = 10 m/s, determine the range R if this value is 15°, i.e., θ1 = 45° -15° = 30° and θ2 = 45° + 15° = 60°. Assume the ball is caught at the same elevation from which it is thrown.
The roller coaster car has a mass of 700 kg, including its passenger. If it starts from the top of the hill A with a speed v A = 3 m/s, determine the minimum height h of the hill crest so that the car travels around the inside loops without leaving the track. Neglect friction, the mass of the wheels, and the size of the car. What is the normal reaction on the car when the car is at Bfind the Max g-force on passenger, bank anglethe force required to slow down the motion and the time the force is applied must be determined to bring the coaster to rest.The maximum G-load experienced by a person should be no more than 5 g and fint the bank angle
If the contact surface between the 20-kg block and the ground is smooth, determine the velocity of the block when t = 4 s. Initially, the block is at rest.
Determine the required height h of the roller coaster so that when it is essentially at rest at the crest of the hill A it will reach a speed of 25 m/s when it comes to the bottom B.
14-59 The material hoist and the load have a total mass of 800 kg and the counterweight C has a mass of 150 kg. At a given instant, the hoist has an upward velocity of 2 m/s and an acceleration of 1.5 m/s2. Determine the power generated by the motor M at this instant if it operated with an efficiency of 0.8
15-42. A toboggan having a mass of 10 kg starts from rest at A and carries a girl and boy having a mass of 40 kg and 45 kg, respectively. When the toboggan reaches the bottom of the slope at B, the boy is pushed off from the back with a horizontal velocity of Vb/t = 2 m/s, measured relative to the toboggan. Determine the velocity of the toboggan afterwards. Neglect friction in the calculation

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

12-109. The catapult is used to launch a ball such that it strikes the wall of the building at the maximum height of its trajectory. If it takes 1.5 s to travel from A to B, determine the velocity va at which it was launched, the angle of release 0, and the height h. B 3.5 ft 18 ft