13)Consider the following systemГО О0 a31æ, y= [ 001] x.a20 1The system is observable forа1 3 аз # 0, ад + 0a2 = 0a1 = 0, a2 = a3 7 0||Observable for all a1, a2, a3

Answered: Image /qna-images/answer/3b7c03e0-01b1-474c-ad53-c75cc6df2f85.jpg

Answered: 13)Consider the following system ГО О 0…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

2. A parabolic antenna 6 ftindiameter hasan efficiency of 65%with a wavelength of 37.5 mm. Calculate its gainin dBand beamwidth. -SHOW THE COMPLETE SOLUTION -NO SHORTCUTS, USE LONG METHOD -BOX THE FINAL ANSWER
PLEASE SHOW STEP BY STEP WORKING A single core concentric cable is to be manufactured for a 100kV, 50Hz transmission system. The maximum permissible safe stress is to be 10,000,000V/m (rms) and the relative permittivity, 4 Calculate the most economical cable size. Take €°= 1/(36π×10^9)
What is a Nominal diameter , Power rating, X Max,f/pl(mm),coil (mm),Nominal impedance (O),Sensitivity (dB), Voice coil diameter, Surround Material Cloth - Sealed, Magnet type Ceramic, Magnet assembly flux (T) , Magnet weight (oz), Chassis type Pressed Steel, Cone material Kevlar loaded paper?
Determine the stability of the system whose characteristic equation is 25s^4 + 105s^3 +85s^2+42s + 10 = 0 according to the Routh Stability criterion with the following explanations: a) Create the routh table according to the given characteristic equation. b) Calculate the necessary coefficient in the table you created. c)State whether the system is stable and how you determined it.
A 169 KV Transmission Line has the following data: w = 2.6 kg/m Length of the Span = 320 m Ultimate Strength = 8400 kg Safety Factor = 2.6 Calculate the height above the ground at which the conductor should be supported. Ground clearance required is 20 m.
A (medium) single phase transmission line 100 km long has the following constants : Resistance/km = 0-25 N; Reactance/km = 0-8 2 Susceptance/km = 14 x 10-6 siemens ; Receiving end line voltage = 66,000 V Assuming that the total capacitance of the line is localised at the receiving end alone, determine the sending end current Select one: a. 240 A b. None of The above c. 320 A d. 50 A
Please explain. Also, do not use mesh analysis please
A 50 km communication line has the following parameters: series resistance (R) = 21.4 W/km series inductance (L) = 1.0 mH/km shunt capacitance (C) = 0.062 mF/km shunt conductance (G) = 0.868 mS/km The frequency is 796 Hz and the line is terminated to avoid reflection. If the power at the receiving end is to be –20 dB (6mW reference) and the sending end voltage is 362 V, determine the power at the sending end.
a) Calculate the unit ramp input steady state error (e_ss) for the following control system. b) Δ(s)=2s^3+2s^2+s+K calculate the range of K values over which the system is stable, given the characteristic polynomial.
An open–wire transmission line is made from two wires, each with a diameter of 2 mm, located 20 mm apart. Calculate the characteristic impedance of the line. No need for a solution. Just write your numeric answer in the space provided. Round off your answer to 2 decimal places.
Many have witnessed the use of an electrical megaphone for amplification of speech to a crowd. A model of a microphone and speaker and the circuit model are shown. Find v(t) for vs = 10sin(100t)u(t), which could represent a person whistling or singing a pure tone. Answer: (1.55 e−0.6t−1.55 cos100t + 0.279 sin100t)V
For the system given below, Rf=10000 ohm, Ki=0.0125 Nm/A, J=10-6 kg.m2, n=800, Kb=0.0125V/(rad/second), Ra=6.25 ohm, Ks=0.1 A/ rad, with B=0 Nm/(rad/second); Determine the K value for the 9.9% overshoot.Calculate the time of overshoot that will occur for this situation.

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS

13)Consider the following system ГО О 0 a3 1 a2 æ, y=[001]x. 0 1 a1 The system is observable for ai = a3 # 0, a2 # 0 %3D a2 = 0 %3D a1 = 0, a2 = az # 0 %3D Observable for all a1, a2, az