14-13 Some common parameters for several types of coaxialcable are a characteristic impedance of 50 2 and avelocity of propagation oqual to or the velocity offree space. Determine (a) inductance per unit length,(b) capacilance per unit lengih, and (C) diclectricconstant of the insulating malerial.

Answered: Image /qna-images/answer/3ba8c387-1d16-4fa4-a731-da5c40d6ca49.jpg

14-13 Some common parameters for several types of coarial cable are a characteristic impedance of 50 £2 and a velocity of propagalion equal to or the velocity of free space. Determine (a) inductance per unit length, (b) capacitance per unit length, and (c) dielectric constant of the insulating material.

14-13 Some common parameters for several types of coarial cable are a characteristic impedance of 50 £2 and a velocity of propagalion equal to or the velocity of free space. Determine (a) inductance per unit length, (b) capacitance per unit length, and (c) dielectric constant of the insulating material.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.1P: The Aluminum Electrical Conductor Handbook lists a dc resistance of 0.01558 ohm per 1000 ft at 20C...

See similar textbooks

Similar questions

Discuss “additive white Gaussian noise” in the conventional way andconvince your audience that Gaussian noise always white
Besides the number of turns and the legth of active conductor, whit of the following is?are a factor which affects the amount of emf(voltage) induced in a coil? A) how fast the conductor is moving through the field(rate of incidence), B) the strength of the magtnetic field(flux density), C) the angle at which the conductor is cutting the magnetic field( angle of incidence), D) all of the above What is mean by genarator regulation? A) it is the percentage rise in terminal voltage from no-load to full-load, B) it is the percentage rise in terminal voltage full-load to no-load, C) it is the amount of control one has over the terminal voltage by way of the field excitation, D) none How are transformer components indetified? The algebraic symboly for the number of kilovolt-amperes on the load side of the transformer is_____. A) KVAh, B) KVAx, C) KVA-primary, D) KVA-secondary
The Aluminum Electrical Conductor Handbook lists a dc resistance of 0.01558 ohm per 1000 ft at 20C and a 60-Hz resistance of 0.0956 ohm per mile at 50C for the all-aluminum Marigold conductor, which has 61 strands and whose size is 1113 kcmil. Assuming an increase in resistance of 2 for spiraling, calculate and verify the dc resistance. Then calculate the dc resistance at 50C, and determine the percentage increase due to skin effect.
Give complete explanation (State space control method)
1)Write the Gauss law integral and derivative expression. How is the Gaussian surface defined and what is its property?I need to explain the answers to these questions, please can you explain in detail. Thanks in advance.
3. As shown in the figure, a current of 3D204 flows through a long U-shaped (hairpin)-shaped conductor made by bending the conductor in a semicircle with a radius of R = 100mm. Point 6 is the middle of the straight part, very far in a semicircle, and the straight part can be approximated as an infinity line. Find the (a) magnitude and (b) direction of B at point a, respectively, and (c) magnitude and (d) | Find each direction.
HOW TO SOLVE THIS USING MAXWELL'S MESH METHOD?
What do you understand by impedance matching? Also write the formula of characteristic impedance for a loss less line? A piece of parallel wire line has a nominal capacitance of 30 Farad/mm, and 9 Henry inductance per meter. Assume the radius of the conductor is 0.005 meter then find the distance between the two parallel wire lines in millimeter.
A small current loop L, with magnetic moment 5a_ A - m” is located at the origin while another small loop current L, with magnetic moment 3a), A - m?is located at (4, —3, 10). Determine the torque on L,.
Determine the loop inductance, and the capacitance of a 1 km length of single-phase twin line having conductors of diameter 10 mm and spaced 800 mm apart in air.
How will you determine the stability using polar plots? What are the conditions?
What are the advantages of the equilateral spacing?