14 A coil with a large distributed capacitance has a low resistance low Q low resonant frequency high resonant frequency

Q: 220-0° rms V -1552 b 10 2 m B /1022 220-120⁰ rms V 220/120° rms V Figure 7 For Prob. 4. 4. Find the…

A: 4. The given figure is shown below:

Q: For the JFET amplifier circuit of Fig. 4-7, determine the lower- and higher-cutoff frequencies and…

A:

Q: Q3 Evaluate the integral 00 [8 (t-76 sin(t) dt

A: An impulse signal is a type of signal that is used to test a system. Because it is impossible to…

Q: What are the shortcomings of one dimensional parity error detection scheme? And discuss the…

A: Shortcomings of one dimensional parity error detection scheme : There are mainly two shortcomings of…

Q: Two identical 20 MW three-phase alternators operate in parallel. The governor of first machine is…

A: Given data : Rated load PL=20MW Frequencies on no-load and full load are 50Hz and 48Hz After drop…

Q: For the oscilloscope display of a pulse waveform shown the 'time/div' or H, switch is on 50 ms/div…

A:

Q: A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 30°, through a…

A:

Q: 4. By using trigonometric functions, find the resultant horizontal and vertical components,…

A: Given:

Q: e Armature Reaction.

A:

Q: For the system shown in figure below, find 'J' and 'D' to yield 20% overshoot and settling time of 2…

A: The rotational mechanical system can be written as-Tt=Jd2θtdt2+Ddθtdt+Kθt ......1Convert into the…

Q: What is the resolution of a analog to digital converter if the full scale voltage range is 8 volt…

A: Given: An ADC has Full scale voltage range, Range=8 V Number of bits, n=2

Q: Mason's rule

A:

Q: For distortion readings of D2=0.15, D3=0.01 and D4=0.05 with I 1 =3.3 Amps and  Rc=4Ώ. Find; i)…

A: Power: It is the time rate of change of energy. It may be absorbing or expanding in nature. The…

Q: Choose the correct answer of the following questions: 1. If the secondary power of a transformer is…

A: As per Bartleby policy we can answer only three questions(MCQ). So I am solving first three for you,…

Q: 1. To minimize the effect of the feedback circuit loading in oscillation frequency we we..........…

A: Since there are 4 different questions, as per the guidelines, in the following section, the first…

Q: Question 5: Minimize the following boolean function K map: F(A, B, C, D) = Em(0, 2, 8, 10, 14) +…

A:

Q: Solve for: a. V₁, V₂, V3, V4, and V5 b. VAG, VBG, VCG, and VDG V₂-36 V R-1 MO R₂-900 kn R₁ - 90 k с…

A:

Q: 4-The critical resistance is less than armature res 5-As the load is increased, the speed of a d.c.…

A: DC generator- It generates electricity and is need of hour.

Q: Given point P(—2, 6, 3) and vector A = yax + (x + z)ay, express P and A in cylindrical and spherical…

A: Given, point P(—2, 6, 3) and vector A = yax + (x + z)ay

Q: R(s) + G1 G2 + G8 G5 G3 G4 G6 G7 C(s)

A:

Q: 20.a. A 100-hp 460-volt three-phase induction motor has a power factor of 90% and an efficiency of…

A: 20(A)  Power output P0 = 100hp = 100×276W = 74600 WEfficiency η =  92%Power input , Pin= P0η  =…

Q: 9- Only one of the following interrupt numbers is available for the user: a. 1H X b. 255H c. 28H d.…

A: 9) which one of the following interrupt numbers is available for the user ?

Q: Design a voltage regulator that will maintain an output voltage of 20V across a 1 k load with an…

A: For the above given voltage regulator circuit we need to design the value of unknown resistance R…

Q: here are 6 × 10 small picture elements in a video each having 8 distinguishable 4 equiprobable…

A: The signal to noise ratio is a parameter used in transmission channels to mathematically calculate…

Q: Given the circuit below with VO = 20V, R1 = 6 ohms, R2 = 5 ohms, and R3 = 20 ohms, R1 VO R2 R3…

A:

Q: lectrical Engineering HVDC 4） A LCC HVDC project with capacity of 3000MW feeds into an AC system…

A: Given data: Capacity is given , Pdc=3000 MW Rated Voltage, V= 500 kV Short circuit current is given…

Q: 9. A 6-bit DAC has an input of 1001012 and uses a 10.0 V reference. i. Find the output voltage…

A: Given, DAC has  Number of bits (N) = 6 Input digital data => 1001012 Reference voltage (Vref) =…

Q: Q1) The impulse response of a linear time-invariant system is: h(n) [1 0 -1 3-2 4-2], Determine the…

A:

Q: Score 5. Figure 2 represents for three sets of sequence components. (a) Fill in the brackets in…

A: As per Bartleby policy we can answer only one question at a time, so I am solving first question for…

Q: Q4/ For the circuit in figure below, find i and in2 for the cases of supply voltage (VS) 20 V, 12 V,…

A: Given: VZ1=13VVZ2=7VAssume diode D3 is idealCondition for conduction od Zener diode is:VA>VZ1 ,…

Q: The voltage at the sending side (source) of a transmission line is 1 KV (Vs = 1 KV). The voltage at…

A:

Q: true false A casual nonlinear phase fir filter has the phase distortion ( ) A minimum phase filter…

A: The FIR filter are the Finite Impulse-Response Filters. The design of an FIR filter can be…

Q: A load of 240 +j 120 is connected to a source of 240 V with a phase angle of 300, through a…

A: Reactive power represents the stored power. An reactive power is a imaginary power whose load is…

Q: For the circuit shown in Figure 2, multiple choice:- v? 2K A. If (Vi₁ = Iv and Vi₂ = 0v), the Vo =…

A:

Q: Calculate in the given circuit. Assume R = 90. R lo 10 V 6Ω The value of lois www 3Ω A.

A: Given circuit: R=9 Ω

Q: For a given amount of power (S) to be transmitted, an increase in the transmission line voltage…

A: Real power transmitted in transmission line P = 3×VL×IL×cosθIL = P3×VL×cosθPLoss = 3 ×IL2×R =…

Q: 01/ What is the main disadvantage & advantage of the stack as temporary storage

A: Stack over register's drawbacks -The biggest disadvantage is that it is slower than registers due to…

Q: Problem to find the current I, I and the voltage V, v, in dhe given circuit using mesh analysis.…

A: Given circuit :

Q: Determine the current through the galvanometer using Thevenin's theorem. 30 Ω MN 20 Ω G 1940. Ω 100…

A:

Q: f. I= 3 mA, R = 100 22 (Express your answer in mV) g. I = 5 mA, R = 2002 (Express your answer in mV)…

A:

Q: ronous counter for sequence: 013-

A: Solution- Sequence : 0→1→3→4→5→7→0 State transition diagram, Present State…

Q: All antennas types radiate uniformly in all directions O True False O O

A: Antenna:- Antenna is a structure which transmits or captures waves which are radio electromagnetic.…

Q: 4. Op-Amp has (a)Single (b) Similar (c)Multiple (d)Differential 5. Write the formula for closed-loop…

A: (4) Answer is (a) Single An operational amplifier is an integrated circuit that can amplify weak…

Q: What is the difference between core i3, core i5 and core i

A: The difference between core i3, core i5 and core i7  processors are

Q: Z₁= 1.2 + j2.4 , Z₂= 2.3 + j6.5 N, R=100 ₪, X=500 2 and Z₁=23 +j20 №.

A: Given: Z1= 1.2 +j 2.4 Ω Z2= 2.3+j6.5Ω R0= 100 Ω  X0= 500Ω ZL = 23+j20Ω

Q: 1.a. Which one of the following pitches is the minimum recommended pitch for a 24-pole motor with…

A: 1 (a) Coil span = pole pitch for full pitch⇒ slotpole= 36024 = 15As all others are less than 15…

Q: Maximum flux density in the core of a 250 V/3000 V, 50 Hz single phase transformer is 0.6 Wb/m². RMS…

A:

Q: A) Determine the z-transform for (Choose one only) 1. x(n) = 6(0.6)" cos (0.2лn)u(n)

A: As per our guidelines we are supposed to be the first question only. Kindly repost the other…

Q: Consider the control system shown in Figure below. Design a D compensator Ge(s) such that the static…

A: An lag compensator is a electrical network producing an phase lag in the output waveform on the…

Q: what is the area of the receiver base station antenna

A: Given figure is shown below. Received gain at base station is =25dB…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.