14.a. Which test can be used to measure splice loss? A. Tensile measurement B. OTDR C. Bit error rate test D. Continuity test 14.b. Which type of fiber optic cable is usually supplied with an attached connector? A. Patch cord B. Tight-buffered cable C. Loose-tube armored cable D. Standard loose-tube cable 14.a. Which of the following features would usually be found in direct-burial cable but not in overhead cable? A. Steel armor B. Strength members C. Outer jacket D. Fiber housing

14.a. Which test can be used to measure splice loss? A. Tensile measurement B. OTDR C. Bit error rate test D. Continuity test 14.b. Which type of fiber optic cable is usually supplied with an attached connector? A. Patch cord B. Tight-buffered cable C. Loose-tube armored cable D. Standard loose-tube cable 14.a. Which of the following features would usually be found in direct-burial cable but not in overhead cable? A. Steel armor B. Strength members C. Outer jacket D. Fiber housing

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter4: Conductor Sizes And Types, Wiring Methods, Wire Connections, Voltage Drop, And Neutral Conductor Sizing For Services

Section: Chapter Questions

Problem 14R: a. What is the maximum distance permitted between straps on a cable installation?...

See similar textbooks

Similar questions

6.a. What type of cable installation is typically used in industrial facilities?A. Aerial onlyB. Buried onlyC. Buried and aerialD. Industrial facilities don't use cable installations.6.b. Which type of fiber is used in a standard FDDI network?A. OM3 or OM4 at 850 nmB. OM1 at 1,550 nmC. OM2 at 1,310 nmD. OM1 at 1,310 nm
a. What is the maximum distance permitted between straps on a cable installation? _____________________ b. What is the maximum distance permitted between a box and the first strap in a cable installation? _____________________ c. Does the NEC permit 2-wire Romex stapled on edge? _____________________ d. When Type NM cable is run through holes in studs and joists, must additional support be provided? _____________________
When running Type NM cable through a bored hole in a stud, the nearest edge of the bored hole shall not be less than ________ in. from the face of the stud unless the cable is protected by a 116 in. (1.6 mm) metal steel plate(s).
1. Identify and describe the step-by-step process used to pull cable and also describe the step-by-step process used to install cable in buildings? Note: Please do not handwritten.
Identify and describe the step-by-step process used to pull cable and also describe the step-by-step process used to install cable in buildings? Note: Please do not handwriting
In your own words and from your own understanding, avoid plagiarism or copying from the Course Material, explain or describe MOLDED CASE CIRCUIT BREAKER.
Identify and describe the step-by-step procedure that is used to draw cable, as well as the step-by-step approach that is used to install cable in structures.
XLPE insulated high voltage underground cable will be installed along a street. The cable will then continue on a street route that cuts the street perpendicularly. Since the cable diameter is 10 cm, what should be the minimum bend radius of the cable?
How to identify the short in a UTP cable using a cable tester, write the steps in your own words?
6. Which type of cable would you use to connect two buildings in an office installation?A. Buried loose-tube cableB. Aerial armored cableC. OFNP cableD. Tight-buffered cable
Briefly discuss the loaded and non-loaded telephone cables
Which is easier to use a bnc connector or sma connector?