14.a. While conducting an OTDR trace, you find that the signal strength drops by 0.091 dB over an 82 m  section of fiber. What's the attenuation in this fiber? A. 0.80 dB/km B. 7.46 dB/km C. 0.91 dB/km D. 1.11 dB/km 14.b. Which component converts an optical signal into an electrical signal in a transceiver? A. LED B. EDFA C. Optical modem D. Photodiod

Q: A band pass filter is to be constructed using RC components that will only allow a range of frequenc...

A:

Q: Question 1 Find the current, I which pass through 52 resistor by using Norton equivalent circuit. 2Ω...

A:

Q: Prob. 8: The current through the secondary of the 2.2 MVA 11/3.6 kV, Z = (1+j6.2)% transformer is gi...

A:

Q: 4. Use a JK flip-flop and logics to implement the following. x:T2: F+ z y T1: F +/F J >F

A:

Q: Vin 2 V 1 V 1 kHz 1 MHz Frequency domain representation is shown of an input vin(t) is shown above. ...

A:

Q: Explain anyone practical measurement system with all of its functional elements

A: The practical measurement system includes modern measuring instruments such as multimeter, oscillosc...

Q: IRL RL In the circuit using a Zener diode above, given that V, = 10 V, R 3.7 KQ, R = 6.8 KQ, and the...

A: Given circuit: Vi=10 VR=3.7 kΩRL=6.8 kΩVZ=5 V

Q: (а) [(5 + /2X-1 + J4)-5/60'] 10 + j5 + 3/40 (b) + 10/30° + j5 -3 + j4

A: a z =5+j2-1+j4-5∠60°         = -5 -j2+j20-8-5cos60°+j5sin60°         = -13 +j18-2.5-j4.33z  =     20...

Q: Example 4 Find the switch equivalent circuit of a diode with an AC source voltage Vs. as shown in Fi...

A: Consider the terminals of the diode are shown below. Here, the left side is the positive and the ri...

Q: 2. What is the process of converting a signal from a given rate to a different rate? a) Sampling b) ...

A:

Q: I'm having a difficulty in understanding this Design of Armature (Stator) of AC GENERATOR.     PL...

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Q: This code sorts the decimal places of a number consisting of ones, tens and hundreds, for example, w...

A: The code for sorting of decimal places of a number consisting of one's, tens and hundreds: X= hundre...

Q: 1. Find the current Is using Ohm's and Wye Delta Transformation. Is 12 kN 18 k). 6 kN 12 V 4 kN 9 kN...

A:

Q: A parallel circuit consists of a resistor having a conductance of 4 siemens, an inductive reactor ha...

A:

Q: 17. For the network of Fig. 12.74: a. Determine the mathematical expressions for the cur- rent iz an...

A:

Q: A generating station has a demand of 25 MW, a load factor of 60%, then the average demand will be:

A: Given: A generating station has, Maximum demand = 25 MW Load factor = 60 % Average demand =?

Q: How many parallel paths are there in the following armature windings: (a) six pole duplex-wave? (b) ...

A:

Q: ) Consider He following system %3D a) find the equili brium points of Hhe nonhincar syskem b) plot p...

A: In this section multipart question i have done only one part. Nonlinear systems are frequently appro...

Q: Q1/ A piece of resistance wire, 15.6 m long and of cross-sectional area 12 mm² at temperature of 0 °...

A:

Q: : Mention and explain any 4 the differences between conducting and Non-conducting wires

A: Conducting and Non-conducting wires:

Q: For the circuit shown below, find the (i) Circuit Resistance, (ii) Total Current, (iii) Power Dissip...

A: Given:

Q: 2. What is the process of converting a signal from a given rate to a different rate? a) Sampling b) ...

A:

Q: Čalculate the THD for a repetitive wave with fundamental frequency amplitude of 10VRMS, second harmo...

A:

Q: xplain the essential features of Indicating Instruments Please do not write the answer on a ...

A: Indicating Instruments - An indicating instrument is simply a movable mechanism pivoting on jewel r...

Q: Q7. Explain what happen to a power supply if there is no smoothing capacitor connected across the ou...

A: If the capacitor are connected across the output then capacitor increase the DC voltage and there is...

Q: In a communications system, trhe ideal value of noise figure is a.0 b.1 c. 1 dB d.infinity

A: Consider the noise figure define the performance of the radio frequency system. The noise figure als...

Q: Explainanyonepracticalmeasurementsystemwithallofitsfunctionalelements

A: Pressure measurement system:

Q: ЧА Cz

A:

Q: OR gate with a small circle on the output gives the symbol of a O a. EX-NOR O b. NOT O c. EX-OR O d....

A: output of OR gate is equal to sum of the inputs  Let input be X and Y then output of OR gate is X+Y ...

Q: If admittance Y = 0.06 – j0.08 siemens, the conductance G equals

A:

Q: The following data were obtained when a 25 kVA, 2300/460 V, 50 Hz transformer was subjected to open-...

A:

Q: 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical powe...

A:

Q: A 440 V, 3-phase a.c. motor has a power output of 11.25 kW and operates at a power facror of 0.8 lag...

A:

Q: 1. A relay coil is connected to a 210-V, 50-Hz supply. If it has a resistance of 30 2 and an inducta...

A:

Q: Obtain c(1.4) and c(2.4) under the unit step input using the modifiedz-transform. (T-0.5) R(2) ZOH T...

A:

Q: The Boolean expression AC+BC is equivalent to ĀC+BC+AC O BC+AC+BC+ACBO AC+BC+BC+ABC O ABC+ABC+ABC+AB...

A: Given a Boolean expression, AC+BC¯

Q: R1 R2 R3 V1 12 R4 12 11 RL 6.

A:

Q: A resistor R is connected in parallel with a 10 ohm inductive reactance. The combina then connected ...

A: Solve the problem

Q: E3.7 Use nodal analysis to find the current I, in the network in Fig. E3.7.

A: The node voltage can be obtained by using kirchhoff's current law at the node. 

Q: Use nodal analysis to determine the node voltages in the circuit shown. 4 S 3i. 1s V2 1s V3 2 A 2S 4...

A: The solution is given below 

Q: 1. Two point charges are located in x-y coordinate system. A charge 2.00 x 10-9C is located at (0,4....

A:

Q: 1)-What happens if different voltage and different current ratings of solar panels are connected tog...

A: (i) Panels of the different voltage and different current ratings are connected in series.  The out...

Q: When comparing through-hole and surface mount IC package types, surface mount have the following adv...

A: Surface mount IC package technology advantages over through-hole technology:  

Q: What is the characteristic time constant for a 6 mH inductor in series with a 3 Q resistor?

A: Given a series RL circuit having,  Resistance, R=3 Ω Inductance, L=6 mH

Q: Given the Bernoulli differential equation: xy'+y=xy^3. Find the integratir O x*2 O x^-2 -2ln(x) Cle

A: Givenxy'+y=xy3

Q: 5. How do you measure the current using a multimeter? 6. How do you measure the voltage using a mult...

A: 5. How do you measure the current using a multimeter ? Ans : connect the multimeter in series to mea...

Q: SCR is a three layered three junction power electronic switch? a.True b. False

A:

Q: 6/0° A j2 N 6Ω I, j4 Q 30/30° V 8Ω Find I, in Fig. using mesh analysis. Answer: 3.582/65.45° A. ll

A:

Q: Problem 26: Use mesh analysis to find the current through the resistor. R5 3 0 R3 R2. 10 Ω Ri 4 0 R6...

A:

Q: Find lo.

A:

Amplitude modulation

A radio signal can carry information in the form of sound or image for broadcasting or communication. For it to be sent to a greater distance, the signal must be changed or modulated in some way. One of the easiest way is to change the amplitude of the signal with variations of the video or the audio signal. This is called Amplitude Modulaton. In this modulation information of message is carried in amplitude of carrier signal.