1612Extension(cm)8.4.6.Force (N)For the above graph shown, Please Answer the questions.1. For a value of Ax = 4N, the value of Ay =%3D2. For a straight line graph, the slope is a constant. This statement is3. The formula to find the slope of a graph is4. The slope of the above graph is• cm/N =+m/N%3D

The given graph form the problem.

Answered: 16 12 Extension (cm) 0. 4 6 8.

Science

Physics

16 12 Extension (cm) 0. 4 6 8.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Two uniform 66.1-gg marbles 2.16 cmcm in diameter are stacked as shown in the figure (Figure 1) in a container that is 3.00 cmcm wide. Find the force that the container exerts on the marble at the point of contact A. What force does each marble exert on the other?
Hi. Please solve this. Thank you 9. If an object weighs 130N at 4000m elevation, how much it weighs in N at 1159m elevation?
Compute for the surface tension of a force of 3.65 x 10⁷ dyne acting on 7 m². Determine all of your answers in the MKS unit. 1. What is the force exerted? Your answer here will be used for the next item(s) 2. What is the surface tension? Your answer here will be used for the next item(s). 3. What is the radius of the capillary tube? Your answer here will be used for the next item(s). 4. What is the diameter of the capillary tube?
A 1,380-N crate is being pushed across a level floor at a constant speed by a force F of 200 N at an angle of 20.0° below the horizontal, as shown in the figure a below. (a) What is the coefficient of kinetic friction between the crate and the floor? (Enter your answer to at least three decimal places.) (b) If the 200-N force is instead pulling the block at an angle of 20.0° above the horizontal, as shown in the figure b, what will be the acceleration of the crate? Assume that the coefficient of friction is the same as that found in part (a). ____ m/s2
1. A mass of 20lbf of mass is hanging on a spring that is fixed on the ceiling. The spring used is Aluminum with a spring constant of 810 N/m. -For Problem above, which of the materials would give the minimum total deformation for the spring setup? Show your solution and compare the deformation for each material. Rank from material with least deformation to material with most deformation.a. Gold, 920 N/mb. Aluminum 8,10 N/mc. Titanium 1,450 N/md. Platinum, 2,060 N/m
Two identical 20.0-kg balls, each 25.3 cm in diameter, are suspended by two 35.0-cm wires as shown in the figure (Figure 1). The entire apparatus is supported by a single 18.0-cm wire, and the surfaces of the balls are perfectly smooth. Find the tension in the top wire. Find the tension in each of two bottom wires.
Please answer the question and its subquestions entirely! This is one question with two subquestions. According to the official Bartleby guidelines, I am alowed to have up to two subquestion! 1) A 50 N crate is pulled up a 5.0 m inclined plane by a worker at constant velocity. If the plane is incline at an angle of 37 o to the horizontal and there exists a frictional force of 10 N between the crate and the surface, what is the force applied by the worker? 0 N 20 N 30 N 40 N a) A girl and a boy pull in opposite directions on strings attached to each end of a spring balance. Each child exerts a force of 20 N. What will the reading on the spring balance be? 0 N 10 N 20 N 40 N b) A horizontal force of 25 N is exerted on a box with a mass of 10 kg. The box accelerates at 2.0 m/s 2. What is the magnitude of the frictional force acting between the box and the floor? 0.0 N 2.5 N 5.0 N…
What do you mean by equilibrium of a body? State the types of equilibrium?
Given 3 kinds of objects with their corresponding specific gravity. a.) sp. g. < 1 b.) sp. g. > 1 c.) sp. g. = 1 Write your observation for each object when placed freely in water.
Show your complete solution and round-off your final answer in the nearest thousandths (3 decimals). 1. How much pressure will be measure at the bottom of the water tank with a height of 2m and a cross sectional area of 785.398mm²? 2.How much pressure will be measure at the middle of the water tank with a height of 2m and a cross sectional area of 785.398mm²? 3.Ifthe diameter of the tank in the previous questions were increased twice but it height remain the same, what will happen to pressure (a) at the middle of the tank and (b) at the bottom of the tank?
Step by step work starting with the formula. Q1. Calculate the centrifugal force acting on a parcel of air of mass 10.0 kg having a radius of 200 cm moving at a velocity of 5.0 m/sec2. Centrifugal acceleration is v2 divided by r, F = m x a , where v is the wind speed and r is the radius of curvature. Q2. How much pressure is exerted on a tree by a wind blowing at velocity v = 90.0 m/sec? The mean density of air at sea level is 1.225 kg/m3. Hint: Rate of change of momentum = Applied force; mass x velocity = Force.
Pls skip if unsure or not willing to answer the subitems (these are all connected for one item). Thank you. 1. Wall-a-stick One end of a 2.00 [m] long uniform stick is placed against a vertical wall. The other end is held by a lightweight cord that makes an angle ? with the stick. The coefficient of static friction between the end of the stick and the wall is ?s = 0.530. A. What is the maximum value the ? can have if the stick is to remain in equilibrium? B. A block of the same weight as the stick is suspended on it at a distance ? from the wall as shown. Assume that ? = 16.5° in this problem. What is the minimum value of ? for which the stick will remain in equilibrium? C. When ? = 16.5°, how large must the coefficient of static friction be so that the block can be attached 0.800 [m] from the left end of the stick without causing it to slip?