Answered: 17) For an LRC series circuit…

17) For an LRC series circuit containing a resistance of 11.0-22, a capacitance of 2.0-µF, and an inductance of 24.0 H, what frequency is needed to minimize the impedance? ANS = 23 Hz

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter32: Alternating-current Circuits

Section: Chapter Questions

Problem 28P: A 10.0- resistor, 10.0-mH inductor, and 100-F capacitor are connected in series to a 50.0-V (rms)...

See similar textbooks

Related questions

Q: An electrical bulb draws a current of 5A when connected to al 400 resistor. Keeping the voltage…

Q: [Q] Position equation from x-t graph: The graph shows the displacement of a mass undergoing simple…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: nt on an int

Q: Find the magnitude of vector from A(-2,-5) to B(-26,5).

Q: Approximately one billion years ago, the Moon orbited the Earth much closer that it does today. The…

A: The equation to calculate linear velocity in a circular orbit is given by: v=2πRT Here, v is the…

Q: The boom in the figure is 2m long and weighs 100 N. If the 800N load is suspended 50cm from the end,…

Q: Monatomic Engine -- What is the efficiency of this engine (see figure 4.9) if it were run with a…

A: 5) The work done from the engine = Area of traingle W = 1/2*(P3-P2)*(V1-V2) W = 1/2*(8-2)(15-10) W…

Q: A.)By pulling a on rope attached to a crate of mass 73.0 kg, the crate is dragged across a floor.…

A: Draw the free-body diagram of the crate.

Q: rmine the final

Q: 3. Determine the direction and magnitude of the electric field at point P. The charges are separated…

A: Given two charges Q and -Q separated

Q: What is the equilibrant vector if you add all the vectors A, B, and C? A = 2i - 3j + 3k B = 4j +2i…

Q: An electrical bulb draws a current of 5A when connected to a 400 resistor. Keeping the voltage…

A: Intialliy Current =5A Restitance = 40ohm using ohms law V =IR =5A*40ohm = 200v Now finally…

Q: Why do most, if not all, electrical corporations in the world issue AC (alternating current) instead…

A: The main factor that went into the choice of AC over DC was that AC is more efficient. Its ability…

Q: A cyclist travels a distance of 1 km in the first hour, 0.5 km in the second hour and 0.3 km in the…

A: Average speed is the ratio of total distance covered in the total time given. S = x1 + x2 + x3 /(t1…

Q: Example: A 5 kg block is placed next to a spring that has been compressed a distance of 30 cm. The…

Q: the instant of engine height, and falls back.

Q: For each case below draw a ray diagram. Draw the image as an arrow and give a description of the…

A: "Since you have posted a question with multiple sub-parts, as per strict guidelines to us we will…

Q: What is the electric potential 2.5 x 10-15 m away from a proton (+e)?

Q: Consider a 60 cm rod which has both ends held at 0 degrees. Suppose that the initial temperature in…

A: Equation for the conduction of heat be ∂T∂t=α2∂2T∂x2.............................(1)

Q: Particle Decay: A º pion decays via the process → y + y, emit- по ting one photon in the forward…

Q: A particle starts from rest and travels along a straight line with a velocity of v = (t2 − 4t + 3)…

Q: Solve the following problem. Show your solution. 1. How much work is needed to lift a 5.0 kg…

Q: quirement in the following processes that involve the launching of object(s) into the air: 1. winged…

A: solution of above problem is below:

Q: People buying food in sealed bags at high elevation often notice that the bags are puffed up because…

A: Using P1V1T1=P2V2T2

Q: car is parked on a hill. The gravitational force on the car is 9.31 x 103 N straight downward, and…

Q: 3. Two point charges, q1 = +5.00 nC and q2 = -3.00 nC, are separated by 35.0 cm. (a) What is the…

A: The electric potential at a pint midway between the chargesis V = [KQ1/r ]+[KQ2/r] where K =…

Q: In the figure, a solid cylinder of radius 10 cm and mass 12 kg starts from rest and rolls without…

Q: Properties of Light 1. Light with a frequency of 5.8 x10¹4 Hz travels in a block of glass that has…

Q: A 1.2-kg spring-activated toy bomb slides on a smooth surface along the x-axis with a speed of 0.50…

A: Given:- The mass of the spring-activated toy bomb m = 1.2 kg The speed along the x-axis is u =…

Q: Two identical springs, both of force constant k=200 N/m, are fixed at opposite ends of a level…

Q: The half-spherical shell in the figure below has a radius R. Suppose that the magnitude of the…

A: Magnetic flux is given as ϕ =B→.A→ = BAcosθWhere, B=Magnetic fieldA = cross section areaθ = Angle…

Q: What is the heat in calories required to raise the temperature of 0.05 kg of water from 0 degrees C…

A: Given data: Mass (m) = 0.05 kg Initial temperature (Ti) = 0°C Final temperature (Tf) = 100°C…

Q: 7. Tammy is golfing. She wants to drive her ball from the tee to the hole that lies due east.…

A: The ball travels a distance of d=200 m in a time period of t=3.25 s making an angle of θ=18o South…

Q: 2The difference of potential between the terminals of an electric heat is 120 V when there is a…

A: Given: The initial potential difference is 120 V. The initial current is 8 A. The final potential…

Q: A wire with a resistance of 6.0 is drawn out through a die so that its new length is three times its…

Q: A cyclist travels a distance of 1 km in the first hour, 0.5 km in the second hour and 0.3 km in the…

Q: a Gas Laws An ideal gas is contained in a cylinder by means of a movable frictionless piston, as…

Q: Find voltage Current=2 A Resistance=2 Ohms

A: Given : Current (I) = 2 A Resistance (R) = 2 Ohms

Q: Weight of a body mass 6.0 kg is 60 N. What will be the weight of a boy of mass 65 kg. (a) kgf (b) N

Q: The sun produces 3.8 x 10^26 joules of energy every second. How much mass (kg) is being converted to…

Q: Determine the resistance and tolerance of the following metal film using the color-coded resistors…

Q: The lights on a car is inadvertently left on. They dissipate 95.0 W. About how long will it take to…

Q: Given two metal strips with the same initial length, steel and aluminum. When heated in the same…

Q: A motor powered by a 9.0 V battery has a square coil with 30 turns with sides 5.0 cm long and a…

A: voltage of the battery (V) = 9 volts number of turns (N) = 30 turns side of square coil (s) = 5 cm =…

Q: Activity 1: Don't Resist! 1) Using Ohms Law, calculate equivalent series the resistance, the series…

Q: Car 1 has half the mass of car 2, but they both have the same kinetic energy. If the speed of car 1…

A: Given data: Mass of car 1 (m1) = m2/2 KE1 = KE2 The speed of car 1 (V1) = 10.0 m/s Required: The…

Q: Mike is cutting the grass using a human powered lawn mower. He pushes the mower with a force of 45 N…

Q: football match, a player kicked 400 grams of football with a speed of 70 miles per hour at an angle…

A: Given:- The mass of the football m = 400 g = 0.4 kg The speed of the mass is v = 70 miles/ hour =…

Q: A projectile is launched on an elevated target with an initial velocity of V = 200 m/s in a…

Q: A bodybuilder lifted a 1000 N weight 20 cm above his head as shown in the figure below. The athlete…

A: Given, weight, mg = 1000 Ndistance above his head, h = 20 cmheight of the bodybuilder, L =180 cmg =…

Question

17) For an LRC series circuit containing a resistance of 11.0-2, a capacitance of 2.0-µF, and an
inductance of 24.0 H, what frequency is needed to minimize the impedance?
ANS = 23 Hz

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A series RLC circuit consists of an 8.00- resistor, 5.00-F capacitor, and a 50.0-mH inductor. A variable frequency source applies an emf of 400 V (rms) across the combination. Assuming the frequency is equal to one-half the resonance frequency, determine the power delivered to the circuit.
To receive AM radio, you want an RLC circuit that can be made to resonate at any frequency between 500 and 1650 kHz. This is accomplished with a fixed 1.00 (H inductor connected to a variable capacitor. What range of capacitance is needed?
A 10.0- resistor, 10.0-mH inductor, and 100-F capacitor are connected in series to a 50.0-V (rms) source having variable frequency. If the operating frequency is twice the resonance frequency, find the energy delivered to the circuit during one period.
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
What is the peak power consumption of a 12G-V AC microwave over that draws 10.0A?
A multimeter in an RL circuit records an rms current of 0.500 A and a 60.0-Hz rms generator voltage of 104 V. A wattmeter shows that the average power delivered to the resistor is 10.0 W. Determine (a) the impedance in the circuit, (b) the resistance R, and (c) the inductance L.
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.