17. . A student doing an experiment pours 0.150 kg of heated copper shot into a 0.375-kg aluminum calo- lo ste rimeter cup containing 0.200 kg of water. The cup and water are both initially at 25 °C. The system comes to thermal equilibrium at 28 °C. What was the initial nhud temperature of the shot?

17. . A student doing an experiment pours 0.150 kg of heated copper shot into a 0.375-kg aluminum calo- lo ste rimeter cup containing 0.200 kg of water. The cup and water are both initially at 25 °C. The system comes to thermal equilibrium at 28 °C. What was the initial nhud temperature of the shot?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter14: Heat And Heat Transfer Methods

Section: Chapter Questions

Problem 27PE: What would be the final temperature of the pan and water in Calculating the Final Temperature When...

See similar textbooks

Similar questions

A high-end gas stove usually has at least one burner rated at 14 000 Btu/h. (a) If you place a 0.25-kg aluminum pot containing 2.0 liters of water at 20.C on this burner, how long will it take to bring the water to a boil, assuming all the heat from the burner goes into the pot? (b) Once boiling begins how much time is required to boil all the water out of the pot?
What mass of water at 25.0C must be allowed to conic to thermal equilibrium with a 1.85-kg cube of aluminum initially at 1.50 102C to lower the temperature of the aluminum to 65.0C? Assume any water turned to steam subsequently recondenses.
A 100-g piece of copper, initially at 95.0C, is dropped into 200 g of water contained in a 280-g aluminum can; the water and can are initially at 15.0C. What is the final temperature of the system? (Specific heats of copper and aluminum are 0.092 and 0.215 cal/g C. respectively.) (a) 16C (b) 18C (c) 24C (d) 26C (e) none of those answers
A gas follows on an isothermal curve, where p is the pressure, V is the volume, b is a constant, and c is a function of temperature. Show that a temperature scale under an isochoric process can be established with this gas and is identical to that of an ideal gas.
What is me Fahrenheit temperature of a person with at 39.0°C fever?
A construction worker uses a steel tape to measure the length of an aluminum support column. If the measured length is 18.700 m when the temperature is 21.2C, what is the measured length when the temperature rises to 29.4C? Note: Dont neglect the expansion of the tape.
What would be the final temperature of the pan and water in Calculating the Final Temperature When Heat Is Transferred Between Two Bodies: Pouring Cold Water in a Hat Pan if 0.260 kg of water was placed in the pan and 0.0100 kg of the water evaporated immediately, leaving the remainder to come to a common temperature with the pan?
An astronaut performing an extra-vehicular activity (space walk) shaded from the Sun is wearing a spacesuit that can be approximated as perfectly white ( e=0 ) except for a 5 cm × 8 cm patch in the form of the astronaut's national flag. The patch has emissivity 0.300. The spacesuit under the patch is 0.500 cm thick, with a thermal conductivity k 0.0600 W/m , and its inner surface is at a temperature of 20.0 . What is the temperature of the patch, and what is the rate of heat loss through it? Assume the patch is so thin that its outer surface is at the same temperature as the outer surface of the spacesuit under it. Also assume the temperature of outer space is 0 K. You will get an equation that is very hand to solve in closed form, so can solve it numerically with a graphing calculator, with software, or even by trial and error with a calculator.
You need to pick up a very hot cooking pot in your kitchen. You have a pair of cotton oven mitts. To pick up the pot most comfortably, should von soak them in cold water or keep them dry?
Most automobiles have a coolant reservoir to catch radiator fluid than may overflow when 1he engine is hot. A radiator is made of copper and is filled to its 16.0L capacity when at 10.0C. What volume of radiator fluid will overflow when the radiator and fluid reach their 95.0C operating temperature, given that the fluid’s volume coefficient of expansion is =400106/C ? Note that this coefficient is approximate, because most car radiators have operating temperatures of greater than 95.0C.
In a production facility, 1.2-in-thick, 2-ft *2-ft square brass plates (r = 532.5 lbm/ft3 and cp =0.091 Btu/lbmF) that are initially at a uniform temperatureof 75F are heated by passing them through an ovenat 1300F at a rate of 450 per minute. If the plates remain in the oven until their average temperature rises to 1000F,determine (a) the rate of heat transfer to the plates in thefurnace and (b) the rate of entropy generation associatedwith this heat transfer process.
You construct two wire-frame cubes, oneusing copper wire, the other using aluminum wire. At 23 °C thecubes enclose equal volumes of 0.016 m3. (a) If the temperatureof the cubes is increased, which cube encloses the greater volume?(b) Find the difference in volume between the cubes when theirtemperature is 97 °C