Please show solution clearly 17. In the power triangle shown, the reactive power is60500w1000 VAR LAGGING1000 VAR LEADINGO 866 VAR LAGGINGO 866 VAR LEADING

One can use a power triangle to represent the relation between reactive power, real power and…

Answered: 17. In the power triangle shown, the…

17. In the power triangle shown, the reactive power is 60 500w O 1000 VAR LAGGING O 1000 VAR LEADING O 866 VAR LAGGING O 866 VAR LEADING

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.12MCQ: The power factor for a capacitive circuit (R-C load), in which the current leads the voltage, is...

See similar textbooks

Related questions

Q: Calculate D in rectangular coordinates at point PA(2, –3, 6)produced by a uniform line charge 20тC…

Q: How to find the temperature coefficient of resistance of a given

A: In this question we will write how to find temperature coefficient of resistance ...

Q: 2. Obtain the current that will pass through the 50 resistor by superposition theorem. Note: The 10V…

Q: Referring to the Figure 3 below, ω = 4 rad/s The value of A is 59. Norton’s theorem is one of the…

A: Any set of batteries with resistance to two terminals equals electricity with a positive current…

Q: Calculate the value of i in the circuit ANSWER:Blank 1 -3 V 20 9 V

A: The solution is given below

Q: Find i, in the circuit ANSWER:Blank 1 5 A IA IA

Q: For the fixed-bias configuration a. Sketch the transfer characteristics of the device. b.…

A: The required parameters can be calculated by using DC analysis of the amplifier circuit

Q: Q1: For the circuit shown in Figure below. Draw the s-domain equivalent, then use the mesh-current…

Q: Homework 3 The switch in Fig. Below is closed at t = 0. Find i(t) and v(t) for all time. Note that…

Q: What is the temperature coefficient of resistance, and what are its units?

Q: Explain how the built-in potential is formed in the PN junction

A: In the following section, the formation of built-in potential in the PN junction has been described.…

Q: Ex: Find VA U Sing The ve nin theorem. 6A iB + VA - 20 V (+ 2 S2 2VA 26 iB

Q: Set up a midpoint bias for a JFET with IDSS = 14 mA and VGS(off) = -10 V. Use a 24 V dc source as…

A: For the midpoint bias JFET, the drain current is calculated as: ID=IDSS2IDSS=14 mAID=142 mAID=7 mA…

Q: 3V av t. of b

Q: 4. The simplest way to reverse the rotation direction of a three phase AC motor is Use stator CEMF…

A: In this question we will write about the simplest way to reverse the rotation direction of three…

Q: Which of the following statements is one of the properties of capacitors connected in series?…

A: Which of the following statements is one of the properties of capacitors connected in series?

Q: 3 V 40 20 9 V

Q: Q2. 2. Calculate the dot product of the vectors F = -i + 3j - 6k G 7i - 5j + k. Select one: O a. 30…

A: Brief description : Here they have mentioned two vectors and they want to know the value of dot…

Q: (a) Consider the circuit shown here. Let Im and Lout be the phasors of the input current Iin and the…

A: Brief description : In the above given question they want to know the value of current Iout in…

Q: UTM Figure B.1 shows a diode cireuit and its DC load line analysis. Based on the UT information…

Q: (i) Illustrate the assumption of an ideal transformer before formulatioi (ii) Formulate Voltage…

Q: 10. Which of the following statements about ground faults is true? A. They usually occur between any…

A: Ground faults: It happens when an energised conductor develops an accidental contact with ground.…

Q: 4- What does the Black Box contain. 5- Can (KCL) be applied to Fig.(7b)? why. 6- What does in this…

A: Solve the problem

Q: In the stairwell of a 10-storey building, there are two continuously used 75watt safety lamps in one…

Q: 6. What characteristics of the thermistor make it a flexible temperature transducer?

A: Thermistor: It is derived from two words i.e. thermal and resistor which means its resistance…

Q: The efficiency of a power amplifier is defined as the ratio of the power output to the power input.…

Q: If a 0.5H inductance rated 110v is to be operated at a source of 230v. At what value of resistance…

A: It is given that: L=0.5HVL=110VVs=230 VAssuming,f=50 Hz

Q: wireless communication For a satellite with an uplink Eb/N0 of 14 dB and a downlink Eb/N0 of 18 dB,…

A: The solution is given below

Q: (a) Semiconductor materials can be classified into intrinsic and extrinsic semiconductors. Elaborate…

A: The answer of the following questions are

Q: For V1 =6V, find Vo y ww

Q: Three charges, ,-Q1, -Q2, +Q3, are positioned on three corners of a square. The side length of the…

A: Two opposite charges attract each other Two same charges repel each other Forces between charges are…

Q: a) Find the current through each resistor. b) Redraw the circuit to include the ammeters necessary…

Q: An ac circuit represented in the time domain and in the frequency domain is shown in the circuit.…

Q: In the figure, determine the forced response for the capacitor voltage v when vs = 0.2t V and when…

A: It is given that: ∙Vs=0.2t V∙Vs=e-30t V

Q: the axle power of a tractor was measured to be 42 hp, what is its net engine power?

A: It is given that: P=42 hp

Q: Solve for the value of the dependent source and the voltage drop across 10-N resistor using Nodal…

Q: Solve iy due to the voltage source ANSWER:Blank 1 4 A 22 10 V 10Ω (3Ω

Q: 1. Knowing that a motor has a power P of 300 W, calculate the torque T that the motor must produce…

A: The solution is given below

Q: Homework 1 The switch in the circuit in below has been closed for a long time, and it is opened at…

Q: The figure shows a single-phase power system with three loads. The source voltage is V = 240 20° V…

A: The detailed solution is provided below.

Q: A. Phase-to-neutral voltage at source. B. Line-to-line voltage. C. Phase-to-neutral voltage at load.…

Q: 1. What is the mathematical expression for the given signal? 2. Determine the Fourier transform…

A: In this question, We need to the mathematical expression for the given signal? In the second…

Q: What is the force experienced by an electron placed in a 4000 N/C electric field? (qe. = 1.602 x 10…

Q: The harmonic which would be totally elimanated from the alternator emf using fractional pitch of 4/5…

A: The solution is given below

Q: Calculate the time constants for both RC and RL circuit using the nominal values for R, C, and L.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Find vs, if v2= 10002 and iz = 5mA (express your answer in milli (103)) ANSWER:Blank 1

Q: What characteristics of the thermistor make it a flexible temperature transducer?

A: Thermistor : Thermistor is a type of resistor which is temperature dependent which resistance…

Q: A periodic signal r(t) is given below: x(1) -4 -3 -2 -1 0 1 14444 2.1. Determine the fundamental…

Q: 3. Circuit in Figure B.3 is designed to provide a DC voltage of 20 V to a load resistance, RL. UTM…

A: We need to select zener diode for given specifications .

Q: 1.You are given four (4) identical capacitors, each C = 2 x 106 F. Find and draw the proper…

A: As per Bartley guidelines I have to solve first three sub quotation, though I have try to solve…

Question

Please show solution clearly

17. In the power triangle shown, the reactive power is
60
500w
1000 VAR LAGGING
1000 VAR LEADING
O 866 VAR LAGGING
O 866 VAR LEADING

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider the series RLC circuit of Problem 2.7 and calculate the complex power absorbed by each of the R, L, and C elements, as well as the complex power absorbed by the total load. Draw the resultant power tna ngle. Check whether the complex power delivered by the source equals the total complex power absorbed by the load.
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
The power factor for a capacitive circuit (R-C load), in which the current leads the voltage, is said to be (a) Lagging (b) Leading (c) One
A source supplies power to the following three loads connected in parallel: (1) a lighting load drawing 10kW. (2) an induction motor drawing 10kVA at 0.90 power factor lagging, and (3) a synchronous motor operating at 10hp,85 effIciency and 0.95 power factor leading (1hp=0.746kW). Determine the real, reactive, and apparent power delivered by the source. Also, draw the source power triangle.
Given the complex numbers A1=630 and A2=4+j5, (a) convert A1 to rectangular form: (b) convert A2 to polar and exponential form: (c) calculate A3=(A1+A2), giving your answer in polar form: (d) calculate A4=A1A2, giving your answer in rectangular form: (e) calculate A5=A1/(A2*) giving your answer in exponential form.
The power factor for an inductive circuit (R-L load), in which the current lags the voltage, is said to be (a) Lagging (b) Leading (c) Zero
Find the Value of I/PT if I=63 P=840 and t =219/365
Find the admittance YabYab in the circuit seen in the figure. Take that R1 = 5 Ω , 2R = 2Ω , R3 = 7 Ω and R4 = 15 Ω. Pt A. Express Yab in rectangular form.
Using Kirchhoff's Laws, find i0 and i1 and verify the total power generated is equal to the total power dissipated. Answers: i0= -3A, i2 = 3A.
Given that: v(t) = 205cos(377t-39degrees)V i(t)=2sin(377t+94degrees)A a) Find the complex and apparent powers b)Find the real and reactive powers c) Find the power factor
What is the real power, reactive power and complex power delivered by the source in the given circuit? Current source is 10, angle 30 degrees A.
For the circuit in as shown υI = sin 2000π t, RE = 82 kΩ, RB = 200 kΩ, and VCC = VEE = 9 V. What value of n is required to deliver maximum power to RL if RL = 10Ω? What is the power? Assume C1 = C2 =∞.