What is the real power, reactive power and complex power delivered by the source in the given circuit? Current source is 10, angle 30 degrees A. What is the real power, reactive power and complex power delivered by the source inthe given circuit? Current source is 10, angle 30 degrees A.3Ω j4Ω5Ω+-j2 2

The solution can be achieved as follows.

Answered: What is the real power, reactive power…

What is the real power, reactive power and complex power delivered by the source in the given circuit? Current source is 10, angle 30 degrees A.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 2PP: The circuit is connected to a 400-Hz line with an applied voltage of 35.678 V. The resistor has a...

See similar textbooks

Related questions

Q: Given a parallel impedance and resistor with a source emf of 220V, ZR =10Z0º 2, Z =4+j3, and Zc=6-…

Q: sinco so l0d) ideal transformer M:05 Vi amplitnate is Sovi icoHz. Li=0.4H Lo=o.5H tind VR, in time…

A: The ideal transformer in the above figure is converted into the T- circuit model

Q: 8. A series circuit with a resistor of 100 2 capacitor of 25 µF and inductance or 0.15 H is…

Q: A given load takes 40 KVA at 50% lagging power factor, while another load connected in parallel…

A: In this question we need to find the apparent power of the combined load.

Q: Q4 For the series R-L-C circuit of Figure Q4: (i) Calculate the total impedance Zr for the…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: 13. What is the value of reactive power, if the angle between star connected three phase 415 V a.c…

A: Given, Star connected three phase ac supply has, Line voltage, VL=415 V. Line current, IL=5.2 A.…

Q: The total power absorbed by a certain 3-phase load is 60 kW, the reactive power being 100 kVAR. Find…

A: Given,For a 3-phase load,Absorbed power, Pab=60kWandReactive power, Pre=100 kVAR

Q: A single phase lagging power factor load takes 300 W and 5 A at 120 V. Find the reactance of a pure…

Q: . The following information is given in connection with the circuit shown below: Za = 6 - j7.5 N; Zb…

Q: In the circuit in the figure; L1 load draws 15 kVA with lagging power factor 0.6. The L2 load draws…

Q: Question 6 Vs 20020°V L L S. rms In the circuit in the figure; Lload draws 15 kVA with lagging power…

Q: 62 Find power factor of given circuit ww- 30/0° V rms

Q: An R-L series circuit has a power factor of 73%. If the apparent power is 560 kVA, what is the…

A: There are 3 types of power in electrical - 1) Active power or true power - P=VI Cos∅ Unit is Watts…

Q: 2. For the circuit given in figure 6, find V_ rms and Lms on R3. R, R3 ww 10 20 R2 R4 5 Vp Figure 6

Q: In three phase power measurement, current coil is connected in series and potential coil is…

A: In three phase power measurement (wattmeter) consists of a current coil connected in series with…

Q: 4. In the single power system to the right, find the complex power S supplied by the Zc = - j0.2 Z =…

A: To find the complex power S supplied by the source

Q: A given load takes 40 kVA at 50 % lagging power factor while another load connected in parallel…

Q: e phase angle of the complex power is negative, then the circuit is said to be resistive. elect one:…

A: In this question we will find circuit nature if complex power phase angle is negative...

Q: S. 20020°V L ms In the circuit in the figure; • L1 load draws 15 kVA with lagging power factor 0.6.…

A: From the complex power

Q: Complete Solution: A 250 - kVA, 0.5 lagging power factor load is connected in parallel to a 180 - W,…

Q: Two impedances consist of resistance of (15 ohms and series connected inductance of 0.04 henry) and…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: The following conditions apply to the circuit in the figure. Find the complex power delivered to the…

Q: Two loads are connected to your standard AC power outlet (110v, 60H2). The first load has a 60%…

Q: Examole II. 9 Vm

A: To find real reactive and Apparent power supplied by source

Q: The three loads in the circuit can be described as follows: Load 1 is a…

A: According to question:…

Q: Two loads are connected in parallel to in e-c source and tako currents of 10 and 40 cunp,…

Q: Two impedances are fed by a source with V = 100Vrms 160 °, as shown below. The total current is I =…

A: In this question we will find currents, impedances ,power factor....

Q: 2. Three impedances (2 + j4), (3 - j5) and (1 – j3) are connected in paralel. The combination is…

Q: For the ac network of Figure Q5, calculate the following; L The total impedance; i. The inductance…

Q: 12. A resistance, inductance and a capacitance of 120uF are connected in series. When the voltage…

Q: In the circuit shown in figure beside, (i=5+20sin1000t+ 10sin2000t+5sin3000t) Amp. Wnte the…

Q: Determine the total impedance, total current and the power factor of the circuit shown in figure 2.…

Q: Two impedances Z1 = 2+j4 & Z2 =R are connected in parallel. Find value of R so that power factor of…

A: Given impedances and power factor are - Z1=2+j4Z2=Rcosϕ=0.9Lagging Given that impedances are in…

Q: The voltage across and current through the load in the figure are v(t) = 150cos(@t -45°) V i(t) =…

Q: In the circuit in the figure; L1 load draws 15 kVA with lagging power factor 0.6. The L2 load…

Q: circuit in the figure: A) the impedance seen when viewed from the source B) Flow C) Phase angle…

Q: Power factor adjustment minimizes. power in the circuit, allowing the large percentage of the power…

Q: Consider a sinusoidal emf source, v(t) = Vm sin (@t) results of current of i(t) = Im sin (@t+0) is…

Q: (e) Figure Q1(e) shows a two-branch parallel circuit. I 10 L-50° A Vs - 100 L-30° V z, 4 + j5 N w -…

A: Obtain the total current taken from the source then find the power using following relation Power S…

Q: What is the type of its power factor?

Q: A source delivers 50-kVA to a load with a power factor of 65percent lagging. Find the load’s average…

A: The fraction of complicated power that belongs to energy storage and retrieval rather than…

Q: A resistance of 20 ohm and a coil of inductance 31.8 mH and negligible resistance are connected in…

A: A) The inductive reactance of the circuit is, XL=jωLXL=j×2π×50×31.8×10-3 ΩXL=j10 Ω The impedance of…

Q: A given circuit has a resistor (R=20 ohms) and an inductor (L=0.3 henrys) connected in series…

Q: 9. Find the total power in a delta connected load with 6+j8 ohms per phase and supplied from a 220V,…

A: Note :- As per guidelines we are supposed to answer only one question. So I request you to post…

Q: In three phase power measurement, current coil is connected in series and potential coil is…

A: We know that Electrical power is measured with a wattmeter. A wattmeter consists of a current coil…

Q: Q: For the network in the figure bellow: a. Find the total impedance of the circuit. b. Compute the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: When connecting the circuit in the figure to an AC voltage generator, it is possible to say that L O…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: 100 A 220 V 50 Hz 0.138 H f(x) = 0 90 ohm Solver Configuration Electrical Reference

Q: (b) An inductive load consisting of resistor, R and inductor, L in series feeding from a 240230°…

Q: Two impedance Z, = 2+j3 and Z, = 3 +j6, are connected in parallel. The apparent power of the second…

Question

What is the real power, reactive power and complex power delivered by the source in the given circuit? Current source is 10, angle 30 degrees A.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider the series RLC circuit of Problem 2.7 and calculate the complex power absorbed by each of the R, L, and C elements, as well as the complex power absorbed by the total load. Draw the resultant power tna ngle. Check whether the complex power delivered by the source equals the total complex power absorbed by the load.
The circuit is connected to a 400-Hz line with an applied voltage of 35.678 V. The resistor has a true power of 14.4 W. and there are 12.96 inductive VARs and 28.8 capacitive VARs. ET35.678VITZVAPFERIRRP14.4WELILXLVARsL12.96LECICXCVARsC28.8C
Reactive power supplied to improve the powerfactor of a 100W load from 0.7 to 0.9 is ____________ a. unity b. 34.9 VAR c. zero d. 53.58 VAR
4- In the circuit in the figure, R=8 Ohm, Rb=2 Ohm, XL=J1 Ohm, XC=J5 Ohm, V=16 < 0° V/50 Hz. (To be solved using Complex Numbers) a) IR, IXC and Ib currents b) Circuit current c) Impedance of the Circuit d) Calculate the Power Coefficient of the Circuit.
If a load is leading, which statement is NOT true? a. The load is capacitive. b. It’s reactive power is positive. c. Current ahead of the voltage. d. Its power factor is positive.
Determine the total power information for three parallel-connected loads: Load A: 250 VA, pf = 0.50 lagging; Load B: 180 W, pf = 0.80 leading; Load C: 300 VA, 100 var (inductive). Also, obtain the total power triangle.
The admittance of a network is (0.05– j0.08) S. Determine the values of resistance andreactance in the circuit if they are connected (a) in series, (b) in parallel.
L = 40 uH C = 1 uF R1 = 10 ohms R2 = 5 ohms R3 = 6 ohms 1) Admittance each branch 2) Equivalent admittance 3) What is the equivalent impedance to the right of the current source? 4) Source voltage and phasor
The actual impedance of a system is 300 Ω. The base kVA is 300 kVA, and the base voltage is 11 kV. What is the actual impedance with 400 kVA and 38 kV as base values? a. 300 b. 33.52 c. 0.744 d. 0.083
The power taken by an inductive circuit when connected to a 120V, 50Hz supply is 400W and the current is 8A The Impedance of the circuit is: a) 13.6Ω b) 1592 c) 150Ω d) 6.259 24. 25. The power factor is: a) 0.9 b) 0.75 c) 0.417 d) 0.5
Consider an LC circuit with L = 0.2 henry and C = 5x10^(-4) farad. At time t = 0, when both i (0) and q (0) are zero, the circuit is connected to a 120 cos (200t) volt alternating current generator. Find the current in the circuit at any time.
I getting incomplete answers please give me full answer i will give like else dislike Two impedances Z{1}= 10 - j15 Ω and Z{2} = 4 + j8 Ω are connected in parallel. The supply voltage is 100 V, 25 Hz. So find the admittance, conductance,susceptance, total current and power factor of the combiner circuit