18. For the network of Fig. 6.82, determine: (a) Ipo and VGso (b) VDs and Vs. 18 V 2.2 ka Dss -6 mA =-1V Ipss 8 mA Vy =-8 V Vesa 0.39 kn Figure 6.82 Problem 18

Q: T QF D Q A B CLK

A: Given the circuit, as shown below: We need to construct the complete state diagram for the Finite S...

Q: (c) A 230 V, 50 Hz power source is connected to the some loads, the source is supply current with po...

A: The solution is given below 

Q: A 8 pole lap wound armature rotated at 350brpm is required to generate 260V. The useful flux per pol...

A: A DC machine is classified in two types. DC motors DC generators Above question is based on DC gen...

Q: culate the real power P, reactive power Q and apparent power S, inclu Xc R A .07S XC = 35, R= 150N; ...

A:

Q: Question 28 Current division is used when a current source is in parallel with resistors in: paralle...

A:

Q: A two-pole ac generator is running at 1500 rpm. Find the frequency and angular velocity.

A: Consider the formula for the frequency is, f=NP120 Here, N is the speed and P is the number of pole.

Q: 1.5 A 10 2 40 2 ->

A:

Q: Equation1: 4(VD – 20) + 11VD + 6(VD -Vb) = 0 Equation2: 6Vb - 21VD = -80 Slove equation 1 and 2 us...

A: 4 (VD - 20) + 11 VD + 6 (VD - Vb) = 0 or 21 VD - 6 Vb = 80   ... (1)    6 Vb - 21 VD = - 80   ... (2...

Q: Fill in the bianks / Tdentim volts Given the circuit below, calculate the voltage drop across R1 whe...

A:

Q: R2 4 Ohm DI D2 Iş R1 5 A 2 Ohm 4i2 211

A:

Q: Two equal-valued resistors dissipate a power of 10 W. The resistors are connected in: Parallel Eithe...

A:

Q: omplete solution and Draw the waveform of the given clamper circuit. Determine:  1. At +20V, what i...

A: At Vin=20VVo=? At Vin=20V diode is in forward bias and becoming short-circuit. Vo=-8V2)20=Vc-8Vc=2...

Q: A DC shunt motor runs at a speed of 1000 RPM on no load taking a current of 6 A from the supply, whe...

A: DC shunt motor A shunt motor has a field winding parallel to the armature winding. It is a self-exci...

Q: When 10100 is input to a 5-bit digital-to-analog converter, the output current is 10 mA. What will b...

A: Note- “Since you have asked multiple questions, we will solve the first question for you. If you wan...

Q: A shunt DC generator has no load terminal voltage of 140V. Armature resistance is 1ohm and shunt fie...

A:

Q: Answer Five Questions only. QI) Obtain the transfer function for the system shown in figure (1). V R...

A: The transfer function is defined as the ratio of output to input at zero initial condition. Convert ...

Q: Determine the gain of a radiator with a transmitted power of 240 Watts. The field intensity at 42m i...

A: Determine the gain of the radiator with a transmitted power of 240 watts. The field intensity at 42 ...

Q: Q1 (a) Based on the circuit in Figure Q1(a); (i) Calculate the total appearance power, real, reactiv...

A:

Q: (c) Two (2) ideal voltage sources, V1 and V2 are connected together by a line impedance, Z. (i) Draw...

A: C)(I) To draw the circuit  Ii)to find the Real and reactive power supplied by each source  iii) Dete...

Q: 1. If the input voltage 32VP.P and f=50HZ, sketch the output of the circuit shown below. 10kn TD ZD ...

A:

Q: Three 8 µF capacitors connected in series will result in ( JuF capacitor.

A:

Q: 4. Find the transfer function Vo(s)/V(t), for each network shown in figure 4. 2/ Vo(s)

A:

Q: i. Suggest suitable instrument and the function used for item 1, 2, 3 and 4 labeled in Figure Q.4b. ...

A: Boiler drum System- Boiler drum system basically a container which reserve water and steam at the si...

Q: (b) The primary and secondary windings of a 250 kVA, 132/66 kV, 50 Hz power transformer have resista...

A:

Q: A 4 pole wave wound shunt generator delivers 195A at a terminal voltage of 205V. Ra and Rsh are 0.05...

A: It is given that: Vt=205 VIL=195 ARa=0.05 ΩRsh=70 ΩP=4     

Q: Find v(t) and i(t) in the circuit shown. i 4Ω + v,= 20 sin(10t + 30°) V 0.2 H - (+ I

A:

Q: Draw the waveform of the given clipper circuit and determine the following:  a.) At 0V, what is the ...

A: In this question we will find output voltage of given clipper....

Q: A 25 hp 240 V shunt motor draws 88.5 A when delivering rated load. The armature resistance of the mo...

A: The solution is given below 

Q: Electroscope Chart Object Electroscope's Reaction Balloon Probable Charge = Pen Probable Charge =

A: Electroscope is an early stage device which is used to detect the electrostatic charge and its magni...

Q: define fuel core

A: solve 

Q: (Ъ) An ammeter shown in Figure Q.1b(i) with full scale current of PMMC is 100 µA and internal resist...

A: The solution is given below 

Q: Even after the huge technological advancements in power electronics, why direct current  is not acti...

A: Direct-current transmission A constant electric voltage is applied, from which devices will draw a c...

Q: For the circuit below, assume the load was connected between nodes a and b and it has been removed. ...

A: The thevenin equivalent and the current through the load resistor can be obtained by using the basic...

Q: 8. A 15.9-µF capacitor and a 15.1-mH inductor are connected in parallel. In series with these units ...

A:

Q: 5 mH 60 is = 50 Cos (314 t+30) A 1 mF 40

A:

Q: A 225 / 430 V, 8 KVA, 50HZ single phase transformer has a copper loss of 105 W at full load, unity p...

A: Single Phase Transformer The device operates on single-phase power. It works on the principle of Far...

Q: Q1- For the circuit of Figure below: a) Determine Thevenin equivalent circuit at the output terminal...

A: We need to find out Thevenin equivalent theorem, and R value for maximum power transfer and value of...

Q: The resistors in series are (select all that apply): 12 N 9Ω 10 V

A: In this question we will find series connected resistors in circuit....

Q: Ask user to enter vector x to evaluate and plot the following two functions in two different figures...

A: clc;clear all;format compactx=input('Enter a vector x to evaluate and plot f1(x) and f2(x): '); %Ask...

Q: (c) A 230 V, 50 Hz power source is connected to the some loads, the source is supply current with po...

A: Total power supplied by the source is sum of the individual load powers. From total source power and...

Q: 10 1F 1Q i1(t) IF 12(t) 2H

A:

Q: (ii) Sketch the output versus input graph for a 4-bit digital-to-analog UTN converter (DAC) which ha...

A:

Q: For the circuit below, z, = 2 + j2 N, Z, = 4 – j3 N, Z, j10 N, and z, , and (b) the current in Z3 an...

A: The solution is given below 

Q: Make sketches showing how 18 1.5 dry cells n

A:

Q: Calculate the power density at 420watts transmitted through an antenna with a gain of 45 if the surf...

A:

Q: Find the capacitance (nF ) of a 20 cm diameter sensor immersed in oil if the plates are separated by...

A: Capacitance, C = ε Ad Where ε = Permittivity              A = Area of the plates             d = Dis...

Q: A 60-hp 230 V shunt motor has a shunt field resistance of 38.3 ohms and an armatureresistance of 0.0...

A: A DC motor is a machine which takes DC electrical energy as an input and produces mechanical output ...

Q: 1)A schematic of an absorption curve is shown to the right for an indirect band-gap semiconductor. F...

A: Because direct band-gap semiconductors do not involve lattice vibration in electron band-to-band tra...

Q: ) Referring to the waveforms shown in Figure Q1(b), 60 A 60 -20 V Figure Q1(b) (i) Sketch the phasor...

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: (c) Find the total power consumed in the circuit of Figure QI(c) by using mesh/loop analysis. 230 V ...

A: This question belongs to circuit theory . It is based on power calculation in the circuit . It is ab...