Answered: 18. With 2.56 x 10°) of heat transfer…

18. With 2.56 x 10°) of heat transfer into this engine, a given cyclical heat engine can do only 1.50 x 10J of work. What is the engine's efficiency?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter15: Thermodynamics

Section: Chapter Questions

Problem 2PE: How much heat transfer occurs from a system, if its internal energy decreased by 150 J while it was...

See similar textbooks

Related questions

Q: 3. A heat engine operating between a geothermal steam source at 205°C and a riv- er at 18°C achieves…

A: Given: 1.Room temperature: T=70 [F] 2.Temperture of hot reservoir (source): Temperature of cold…

Q: 10. A car diesel engine is able to take 15000 J of heat as it does 4000 J mechanical work in a…

A: Heat supplied to diesel engine: Q = 15000 J Work done by diesel engine: W = 4000 J

Q: A heat engine operating between 80.0°C and 200°C achieves 20.0% of the maximum possible efficiency.…

A: Given, Heat engine operating between 80.0∘C and 200∘C Efficiency = 20.0 % work = 10.0 kJ

Q: 2- A heat engine absorbs 4500 J of heat energy from a hot reservoir and discards 2500 J into the…

Q: In a refrigerator, one removes heat from a lower temperature and deposits to the surroundings at a…

A: Given data- Power of the motor P=1 kW Temperature of source- T1=27°C or T1=27+273…

Q: In a certain thermodynamic process, 20 cal of heat are removed from a system and 30 cal of work are…

Q: You perform maintenance on an engine, increasing its efficiency by 6.84 %. How much more work is…

Q: 4)) An engine is found to have 0.73 efficiency. If it does 218 J of work per cycle, what is the heat…

A: Write the expression for the efficiency of the engine. Here, W is the work done and Qin is the heat…

Q: Your kitchen is at a temperature of 301.5 K. Using 2771 J of work, how much heat can a Carnot…

A: solution as

Q: 4- An ideal gas initially at 300 K undergoes an isobaric expansion at 2.50 kPa. If the volume…

A: The initial temperature T1=300 K The isobaric expansion P = 2.50 k Pa = 2.50×103 Pa Initial volume…

Q: 3. How much work is necessary to compress air in an insulated cylinder from 0.20 to 0.01 m . Use T1=…

Q: obtain an expression for work done during an adiabatic process?

A: Consider the following adiabatic process.

Q: 15. Discuss the zeroth law of thermodynamics and why it is necessary.

A: As per our guidelines, we are supposed to answer only first one question in case of multiple…

Q: 46. GO Engine 1 has an efficiency of 0.18 and requires 5500 J of input heat to perform a certain…

Q: 9. Which process will cause the entropy of the universe to increase? A. melting of ice B. burning…

A: 9. The entropy of the universe increases if the process is irreversible. Now let's check each option…

Q: 6. In which thermodynamic process, with an ideal gas, the entire amount of heat exchanged is spent…

A: (A) in isothermal

Q: 5. An aviation fuel used by a piston engine aircraft transforms 100,042 J of energy through the…

A: Energy produced by aviation fuel ( Input energy) = 100042 JHeat produced by vapourization = 46721…

Q: You perform maintenance on an engine, increasing its efficiency by 5 %. How much more work is…

A: Given data : Efficiency, Input heat,

Q: 4) The electric motor of a heat pump transfers energy as heat from the outdoors, which is at…

A: Given data: The outdoor temperature is TL=-7.5°C+273 K=265.5 K. The outdoor temperature is…

Q: 23.13 A system containing 0.3 mol of an ideal gas undergoes a quasistatic isother- mal process at…

Q: 1. Find the change in entropy when 1.25 kg of steam at 100°C condenses and cools to 50°C.

A: Given : Mass, m = 1.25 kg Initial temperature, T1 =100°C = 373 K Final temperature, T2…

Q: 19. (I) What is the maximum efficiency of a heat engine whose operating temperatures are 560°C and…

A: Given data, Source Temperature (TH)=5600C Sink Temperature (TL)=3450C

Q: Unreasonable Results - What is wrong with the claim that a cyclical heat engine does 4.00 kJ of work…

A: The net transfer of heat to the environment is, ∆Q=Qin+Qout=24.0 kJ-16.0 kJ=8.0 kJ

Q: 2. How much work is done by a gasoline engine that is 20 % efficient and loses 750 J to the cooling…

A: The efficiency is defined as: η=WQi 0.2 =…

Q: 8. Calculate the efficiency of a fossil-fuel power plant that consumes 382 metric tons of coal each…

Q: Your kitchen is at a temperature of 303.44 K. Using 2362 J of work, how much heat can a Carnot…

A: solution as

Q: 3. How long must a 400 W electrical engine work in order to produce 300 kJ of work?

A: GivenPower of electrical engine, P=400 WWork done , W=300 kJ

Q: 3. A heat engine does not convert all of the heat that flows through it into mechanical energy.…

A: According conservation of energy, energy can not be created not be destroyed.

Q: 15) The work done by an ideal gas during on full cycle is 400 J. What is the change in internal…

A: The change in property of the system during a cyclic process is zero because both initial and final…

Q: 21. A heat engine would violate the second law of thermodynamics if it * O A. changed all the heat…

A: For a heat engine , it must reject some of the heat it receives from the high-temperature source to…

Q: 58.'A gas cylinder system similar to that described in this sectio has a volume of 1.80 X 10-3 m³ at…

A: Given: The intial volume and pressure is 1.8x10-3 m3 and 1.01x105 Pa. The final volume and pressure…

Q: 23. No system can absorb heat from a single reservoir and convert it entirely into work without…

A: According to the second law of thermodynamics, there is no device which converts all the energy into…

Q: 49. Consider the process for steam in a cylinder shown below. Suppose the change in the internal…

A: Work done= Area under the curve

Q: a heat engine operates between 210°C and 35°C. the minimum amount of heat that must be withdrawn…

A: The problem is based on thermodynamics. The ratio of the amount of work done output with the amount…

Q: heat engine uses boiling water at 100°C which is then lowered to 25°C upon leaving the engine. What…

Q: How much work is necessary to compress air in an insulated cylinder from 0.20 to 0.01 m ³ Use T1=…

Q: 11. A Carnot heat engine is 20% efficient. If the temperature of hot reservoir is 227 °C then what…

A: Dear student, According to the guidelines I am allowed to answer only one…

Q: 74) A lawn mower has a 6-horsepower engine. (1 hp : 750W) If the engine has an efficiency of 20% and…

Q: A closed system undergoes a process in which there is no internal energy change. During this…

Q: 10.-What is the heat of the isothermal process (from point B to point C)?

Q: 6. A heat engine that uses steam has a work output of 300 J. If 1000 J is input into the engine, how…

A: Here, Heat input = 1000J Work Out = 300J We know that Heat input = work out + heat rejected…

Q: 3. How much energy is transferred from a diesel engine to the exhaust and cooling system by heat if…

Q: 3. In each case, find the change in internal energy of the system. a. A system absorbs 2000 J of…

A: According to Bartleby guidelines we can only solve the first question at a time. Kindly post the…

Q: An engine releases 0.350 kJ of heat for every 0.910 kJ of work it does. What is the efficiency of…

A: Efficiency can be defined as the ratio of workdone to the amount of energy used. Efficiency, η=WQ

Q: Determine the COP of a refrigerator that removes heat from the food compartment at a rate of 5040…

Q: Question 20 A certain heat engine draws 500 cal/s from a water bath at 27 °C and transfers 400 cal/s…

A: Given: The heat rate drawn by the engine is 500 cal/s. The temperature is 27oC. The transferred heat…

Q: 4. A heat engine does 78,000 J of work during 20 minutes. Find the power supplied by the engine

Question

18. With 2.56 x 10°J of heat transfer into this engine, a given cyclical heat engine can do only 1.50 x 10°J of work.
What is the engine's efficiency?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Can improved engineering and materials be employed in heat engines to reduce heat transfer into the environment? Can they eliminate heat transfer into the environment entirely?
Explain why heat pumps do not work as well in very cold climates as they do in milder ones. Is the same true of refrigerators?
This problem compares the energy output and heat transfer to the environment by two different types of nuclear power stationsone with the normal efficiency of 34.0%, and another with an improved efficiency of 40.0%. Suppose both have the same heat transfer into the engine in one day. 2.501014J. (a) How much more electrical energy is produced by the more efficient power station? (b) How much less heat transfer occurs to the environment by the more efficient power station? (One type of more ef?cient nuclear power station, the gas—cooled reactor, has not been reliable enough to be economically feasible in spite of its greater eficiency.)
In performing 100.0 J of work, an engine discharges 50.0 J of heat. What is the efficiency of the engine?
An ideal heat pump is being considered for use in heating an environment with a temperature of 22.0C. What is the cold reservoir temperature if the pump is to have a coefficient of performance of 12.0 ?
Calculate the increase in entropy of the Universe when you add 20.0 g of 5.00C cream to 200 g of 60.0C coffee. Assume that the specific heats of cream and coffee are both 4.20J/g C.
How much work is required, using an ideal Carnot refrigerator, to change 0.500 kg of tap water at 10.0C into ice at -20.0C? Assume that the freezer compartment is held at -20.0C and that the refrigerator exhausts energy into a room at 20.0C.
Does a gas do any work when it expands adiabatically? If so, what is the source of the energy needed to do this work?
Explain how water’s entropy can decrease when it freezes without violating the second law of thermodynamics. Specifically, explain what happens to the entropy of its surroundings.
How much heat transfer occurs from a system, if its internal energy decreased by 150 J while it was doing 30.0 J of work?
Give an example of a spontaneous process in which a system becomes less ordered and energy becomes less available to do work. What happens to the system's entropy in this process?
An electric generating station is designed to have an electric output power of 1.40 MW using a turbine with two-thirds the efficiency of a Carnot engine. The exhaust energy is transferred by heat into a cooling tower at 110C. (a) Find the rate at which the station exhausts energy by heat as a function of the fuel combustion temperature Th. (b) If the firebox is modified to run hotter by using more advanced combustion technology, how does the amount of energy exhaust change? (c) Find the exhaust power for Th = 800C. (d) Find the value of Th for which the exhaust power would be only half as large as in part (c). (e) Find the value of Th for which the exhaust power would be one-fourth as large as in part (c).