19–15. A 4-kg disk A is mounted on arm BC, which has anegligible mass. If a torque of M = (5e05") N-m, where t isin seconds, is applied to the arm at C, determine the angularvelocity of BC in 2 s starting from rest. Solve the problemassuming that (a) the disk is set in a smooth bearing at B sothat it moves with curvilinear translation, (b) the disk isfixed to the shaft BC, and (c) the disk is given an initialfreely spinning angular velocity of w, = {-80k} rad/s priorto application of the torque.250 mm60 mmM = (5e5) N - m

Given: M = 5e0.5t Nm Required : The angular velocity of BC in 2s starting from rest assuming: The…

Answered: 19–15. A 4-kg disk A is mounted on arm…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

19-26 The double pulley consists of two wheels which are attached to one another and turn at the same rate. The pulley has a mass of 15 kg and a radius of gyration of = 110 mm. if the block at A has a mass of 40 kg and the container at B has a mass of 85 kg, including its contents, determine the speed of the container when t = 3s after it is released from rest.
18-37 The spool has a mass of 20 kg and a radius of gyration of = 160 mm. if the 15 kg block A is released from rest, determine the velocity of the block when it descends 600 mm.
18-54 The slender 6 kg bar AB is horizontal and at rest and the spring is unstretched. Determine the stiffness K of the spring so that the motion of the bar is momentarily stopped when it has rotated clock wise after being released.
The wheel has a mass of 100 kg and a radius of gyration of kO = 0.2 m. A motor supplies a torque M = (40u + 900) N #m, where u is in radians, about the drive shaft at O. Determine the speed of the loading car, which has a mass of 300 kg, after it travels s = 4 m. Initially the car is at rest when s = 0 and u = 0°. Neglect the mass of the attached cable and the mass of the car’s wheels
17-35. The sports car has a mass of 1.5 Mg and a center of mass at G. Determine the shortest time it takes for it to reach a speed of 80 km/h, starting from rest, if the engine only drives the rear wheels, whereas the front wheels are free rolling. The coefficient of static friction between the wheels and the road is u, = 0.2. Neglect the mass of the wheels for the calculation. If driving power could be supplied to all four wheels, what would be the shortest time for the car to reach a speed of 80 km/h? G 0.35 m A -1.25 m-- -0.75 m
The spool has a mass of 200 kg and a radius of gyration of kG = 0.2 m. If the coefficients of static and kinetic friction at A are μs = 0.3 and μk = 0.2, respectively, determine the angularacceleration of the spool if P = 400 N.
17-59 The uniform slender rod has a mass m. If it is released from rest when = 0, determine the magnitude of the reactive force exerted on it by pin B when = 90.
While the system shown is in equilibrium, a counter-clockwise torque T =T0sin(ωt) N-m(with T0 = 226.6 and ω=7) is applied to teh disk. What is the disk angular speed ω0 = ? in rad/s at time t = 4.2 sec? ( I = 0.2 kg.m2, b = 7.8 N-m-s/r, k = 1,504 N/m, r = 0.52m )
The 75 kg wheel has a radius of gyration about its mass centreof kG=400mm. If it is subjected to a torque of M=150 N.m,determine:a. The angular acceleration of the wheel,b. The linear acceleration of the mass centrec. The created frictional force at the point of contact.The coefficient of static friction between the wheel and theground is S=0.3.Hint: Assume no slipping occurs at star, and verify I at the end.
If the cord is subjected to a horizontal force of P = 150 N, and gear is supported by a fixed pin at O,determine the angular velocity of the gear and the velocity of the 20-kg gear rack in 4 s, starting from rest. The mass of the gear is 50 kg and it has a radius of gyration of k0 = 125 mm. Assume that the contact surface between the gear rack and the horizontal plane is smooth.
19-31 The 75 kg gymnast lets go of the horizontal bar in a fully stretched position A, rotating with an angular velocity of = 3 rad/s. estimate his angular velocity when he assumes a tucked position B. assume the gymnast at position A and B as a uniform slender rod and a uniform circular disk, respectively.
The system is at rest with the sprng unstretched when theta = 0. The 5.3 kg uniform slender bar is then given a slight clockwise nudge. The value of b is 0.45 m. If the bar comes to momentary rest when theta = 58, determine the spring constat k. For the value k = 65N/m, find the magnitude of the angular velocity of the bar when theta = 38

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS