2 ohm ww 1 ohm 3 ohm ? Calculate the total current in the circuit 4 ohm ww 5 ohm 120 V

Q: A 45.0-m length of coaxial cable has an inner conductor that has a diameter of 2.58 mm and carries a…

A: Given for a coaxial cable, Length L=45.0 mInner conductor diameter D1=2.58 mmso, Inner conductor…

Q: explain the maintenance of transformer oil and what is the average life of transformer oil ?

A: Transformer oil, Transformer oil is a type of insulation used to protect high-voltage electrical…

Q: A temperature sensor has sensitivity of 6.3 mV/0C, has no offset, and is designed to measure…

A:

Q: PROBLEM #b FOR THE CIRCUIT BELOW, (a) DETERMINE THE THEVENIN EQUNAVENT CONNECTED TO hout. (b) CHOOSE…

A:

Q: a 3 For the circuit shown above, what is the equivalent capacitance as seen by the a-b terminals?…

A:

Q: Use mesh analysis to find Vo

A:

Q: The platinum RTD has been connected to the wheatstone bridge circuit represented by R3 with Vin =…

A:

Q: Q1. For the system shown in Figure Q1, draw an impedance diagram in per unit, by choosing 100 kVA to…

A:

Q: Q7. A three phase Y-connected unbalanced load having the following phase impedances: Za = 20 +j1022,…

A: It is given that:- Za=20+j10 ohmZb=10+j10 ohmZc= 30-j15 ohm Zn = 20 ohm VL = 415 V

Q: angle. O a. 30 degrees O b. 0.866 O c.0.6 O d. 60 degrees ee wire system, the two Wattmeter read…

A: It is given that:- W1=4000 WW2= 2000 W ϕ = ?

Q: How are the RGB color beams produced in a cathode ray tube (CRT) display?

A:

Q: do comparing between dielectric properties of oil insulators and liquid insulators

A: Dielectric Properties:- Dielectric properties include the dielectric constant and dissipation…

Q: a single-stage impluse generator has a 0.01 micro farad capacitor. the wave front and wave tail…

A: Given: Single phase generator, Capacitor, C1=0.01 μF C2=1200 pF Resistor, R1=800Ω R2=3000Ω

Q: A water drain pump can be activated depending on the status of three switches, one main switch and…

A: The required design can be obtained by using the truth table derived based on the given condition…

Q: Q3. For the power system in Problem of Q2, the synchronous motor absorbs 1500 MW at 0.8 power factor…

A: Given data: Synchronous motor Real Power absorbed by the synchronous machine, P3=1500 MW Power…

Q: A transformer is rated at 3kVA. It has a primary voltage of 184V and a secondary voltage of 600V. If…

A:

Q: Consider the circuit shown where VCE(Sat) = 0.1V, VBECon) = 0.7 and B = 40. @ Determine IB, IC, IS…

A: When BE and CB junction is reverse biased= Cut off Region When BE forward and CB junction is reverse…

Q: TRUE OR FALSE 1. Under no external bias, electrons and holes inside the semiconductor are…

A: Semiconductor consists of two types of mobile carriers: one is an electron, and the other is a hole.…

Q: For a series RC circuit with Vin= 100 V. What is the value of l(s) when R = 10 ohms and c = 0.25 F?

A:

Q: For a series inductance and capacitance with value of L=2H and C=0.25 F. Solve for X(s) when Vo is…

A:

Q: stablish and analyze Ohm's Law applied for a coil in sinusoidal alternating current.

A: According to the ohm's law current flowing across any conductor is directly proportional to the…

Q: What is the relationship between the voltage in the coil and the current in the coil, what is the…

A:

Q: 2) For the circuit below, find Ix and Vy using mesh analysis: 24 V 6 Ω ww Ix ww 12 Q2 TA 20 ww www ·…

A:

Q: Given the minterm expansion F(A, B,C,D) = Σ( 1, 3, 5, 7, 8, 9, 11, 12,13,15 ). d. Create a logic…

A:

Q: 2. A counter is meant to count in the sequence show below. 110 000 W 0 0 0 0 1 1 1 1 010 W 0 0 0 0 1…

A:

Q: Loov Vi -100v 3.6 wor S₁ Ši Compute for V2.2 k

A: Given: Input voltage waveform, Circuit diagram,

Q: A traditional light bulb has an electrical power of 40 W (round, d = 50 mm). The surface of an…

A: Given D =50 mm =0.050 m Lamp surface temperature =Ts=127 °C surrounding air temperature =T∞ =27 0 C…

Q: Question 17 A circuit element has an impedance of 26 Z-25° m2 when the frequency is 180 Hz. What is…

A:

Q: 500 Ω 6V -fi 600 Ω] 100 Ω Figure 1. Schematic Diagram

A:

Q: Draw the circuit including the multimeter which you will use to measure the current through R2.…

A: Given that, R1=1kΩ,R2=5.1kΩ,R3=5.1kΩ,Vs=10 V. Here we have to find out current through resistors R1…

Q: Determine the current lett for ty 22 جدعانا 6 ↑ 4.5 22 2 F + ✓ LEE) tiss 22

A:

Q: At room temperature, the intrinsic carrier density in a semiconductor is 10¹1 cm³. If 3x10¹² cm-3 of…

A: Given: ni=1011 cm-3, Nd=3×1012 cm-3 and Na=2.9××1012 cm-3. Required: Electron and hole…

Q: Find i, in the circuit of Fig. 4.19 using source transformation. 6Ω 5Α 3 Ω Μ 5 V +-+) 7Ω 3Α ΤΩ www…

A:

Q: a) What will happen to speed, current and induced voltage of a DC separately excited motor, if it…

A:

Q: 1.) Find I and Vo in the circuit shown 15V I SN 602 12.12 m 652 152 + Vo 3 20.12 80

A:

Q: Ill- a) A steady voltage of -1.25V is applied to an op amp integrator having component Values of…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The electron density in a silicon sample decreases linearly from 1016 cm-3 to 1015 cm-³ over a…

A: Current density is J = I/A Here I is current  A is Area

Q: 17 If i(t) = 0.5 cos 2000t A, find the average power absorbed b each element in the circuit in Fig.…

A:

Q: wheatstone bridge circuit represented by R3 with Vin = 5V, R1=R2=R4 = 100 ohms. Find the temperature…

A:

Q: Solve for C(s)/R(s) with solution

A: Given, The block diagram,

Q: The electric current in a microprocessor circuit is 0.230 µA How many coulombs pass a given point in…

A: Given data, Current I=0.23 μA Time t=2.2 ms

Q: = P5.25. Suppose that v₁(t) = 100 cos(wt + 45°) and v₂(t) = 100 sin(wt + 60°). Use phasors to reduce…

A:

Q: QUESTION 4 If the maximum energy sto 270 210 850

A: Given data, Maximum energy stored E = 3 mJ.

Q: A three-phase 1MW AC-DC converter is to be connected to a 2.4kVLL/60Hz AC bus that presents a 200uH…

A: It is given that:- P3ϕ = 1 MW VLL = 2.4 KV L =  200 μH/phase f = 60 Hz

Q: What are the electrical systems used in banks for lighting purposes?

A: Types of lighting Intra-cloud lightning cloud-ground lightning Lightning leads to Very high…

Q: Determine the resolution for the device with the following parameters: Range = 0 to 5V ,gain=3 and…

A: Given- Range of the meter, Range=0 to 5 V. Gain=3 Code width=50 mV   To find- Resolution for the…

Q: 1. An aluminium wire with a square cross-section 4 mm on a side is carrying a current of 4.5 amps.…

A:

Q: Answer the following questions for the circuit given below. Given v 1 sin(50K (). (+2) 100mH 1000pl…

A: It is given that: V=1sin50kt

Q: The switch is open for a long time, then at t = 0 it was closed. Determine the equation for the…

A:

Q: A 252 B 202 HH 2F Em Pm C D 192 202 56V

A:

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.