2) Read the section in the book on Kirchoff's Voltage Law. Use the picture below to answer the following questions.3 2- 30 V1Ω+ 20 V4 S24 2+ 40 VI31Ω2Ω10 VI42 Ωa) Set up a system of equations for the loop currents.b) Use that system to write the matrix equation that determines the loop currents.c) Find each of the loop currents.

Applying Junction rule at junctions J1, J2, J3, J4, J5 and J6 ;

Answered: 2) Read the section in the book on…

Science

Physics

2) Read the section in the book on Kirchoff's Voltage Law. Use the picture below to answer the following questions.

An Introduction to Physical Science

14th Edition

ISBN:9781305079137

Author:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar Torres

Publisher:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar Torres

Chapter8: Electricity And Magnetism

Section: Chapter Questions

Problem 1VC

See similar textbooks

Similar questions

Integrated Concepts Derive an expression for the current in a system like that in Figure 23.11, under the following conditions. The resistance between the rails is R, the rails and the moving red are identical in cross section A and have the same resistivity . The distance between the rails is l, and the rod moves at constant speed v perpendicular to the uniform field B. At time zero, the moving red is next to the resistance R.
Body injury from electricity depends on the magnitude of the current and its path (see the 8.2 Highlight: Electrical Effects on Humans, section 8.3). However, signs warning Danger. High Voltage are commonly seen ( Fig. 8.35). Shouldnt the signs refer to high current? Explain. Figure 8.35 High Voltage or High Current?
Integrated Concepts (a) What is the average power output of a heart defibrillator that dissipates 400 J of energy in 10.0 ms? (b) Considering the high-power output, why doesn’t the defibrillator produce serious burns?
A particle accelerator sends highvelocity charged particles down an evacuated pipe. Explain how a coil of wire wrapped around the pipe could detect the passage of individual panicles. Sketch a graph of the voltage output of the coil as a single particle passes through it.
A student in a physics lab mistakenly wired a light bulb, battery, and switch as shown in Figure 21.44. Explain why the bulb is on when the switch is open, and off when the switch is closed. (Do not try this-it is hard on the battery!)
Would your headlights dim when you start your car's engine if the wires in your automobile were superconductors? (Do not neglect the battery’s internal resistance.) Explain.
Name two applications for superconductivity listed in this section and explain how superconductivity is used in the application. Can you think of a use for superconductivity that is not listed?
Consider the circuit shown in Figure P18.10. (a) Calculate the equivalent resistance of the 10.0- and 5.00- resistors connected in parallel. (b) Using the result of part (a), calculate the combined resistance of the 10.0-, 5.00-, and 4.00- resistors. (c) Calculate the equivalent resistance of the combined resistance found in part (b) and the parallel 3.00- resistor. (d) Combine the equivalent resistance found in part (c) with the 2.00- resistor. (e) Calculate the total current in the circuit. (f) What is the voltage drop across the 2.00- resistor? (g) Subtracting the result of part (f) from the battery voltage, find the voltage across the 3.00- resistor. (h) Calculate the current in the 3.00- resistor. Figure P18.10
Integrated Concepts Cold vaporizers pass a current through water, evaporating it with only a small increase in temperature. One such home device is rated at 3.50 A and utilizes 120 V AC with 95.0% efficiency. (a) What is the vaporization rate in grams per minute? (b) How much water must you put into the vaporizer for 8.00 h of overnight operation? (See Figure 20.42.)*******
For the circuit shown in Figure P27.22, we wish to find the currents I1, I2, and I3. Use Kirchhoffs rules to obtain equations for (a) the upper loop, (b) the lower loop, and (c) the junction on the left side. In each case, suppress units for clarity and simplify, combining the terms. (d) Solve the junction equation for I3. (e) Using the equation found in part (d), eliminate I3 from the equation found in part (b). (f) Solve the equations found in parts (a) and (e) simultaneously for the two unknowns I1 and I2. (g) Substitute the answers found in part (f) into the junction equation found in part (d), solving for I3. (h) What is the significance of the negative answer for I2? Figure P27.22
Integrated Concepts (a) What is the direction of the force on a wire carrying a current due east in a location where the Earth’s field is due north? Both are parallel to the ground. (b) Calculate the force per meter if the wire carries 20.0 A and the field strength is 3.00105T. (c) What diameter copper wire would have its weight supported by this force? (d) Calculate the resistance per meter and the voltage per meter needed.
Integrated Concepts (a) An aluminum power transmission line has a resistance of 0.0580/km. What is its mass per kilometer? (b) What is the mass per kilometer of a copper line having the same resistance? A lower resistance would shorten the heating time. Discuss the practical limits to speeding the heating by lowering the resistance.