2-Set two coils, 600 (primary) and 200 turns (secondary) onto the iron core. Connect the primary to the AC power supply (6.0 Volt) and the secondary to the multmeter. With the same primary and the same voltage change the secondary to 400 and 3200 turns and IF measure the voltage in the secondary. WHICH ARE THE VALUES OF THE VOLTAGE THAT ARE MEASURED IN THE SECONDARY.

2-Set two coils, 600 (primary) and 200 turns (secondary) onto the iron core. Connect the primary to the AC power supply (6.0 Volt) and the secondary to the multmeter. With the same primary and the same voltage change the secondary to 400 and 3200 turns and IF measure the voltage in the secondary. WHICH ARE THE VALUES OF THE VOLTAGE THAT ARE MEASURED IN THE SECONDARY.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 48PE: (a) The plug-in transformer for a laptop computer puts out 7.50 V and can supply a maximum current...

See similar textbooks

Similar questions

Calculate the peak voltage of a generator that rotates its 200-turn, 0.100 m diameter coil at 3600 rpm in a 0.800 T field.
What is the peak power consumption of a 12G-V AC microwave over that draws 10.0A?
Show that if a coil rotates at an angular velocity (, the period of its AC output is 2(/(.
How would you place two identical flat coils in contact so that they had the greatest mutual inductance? The least?
Integrated Concepts Approximately how does the emf induced in the loop in Figure 23.57(b) depend on the distance of the center of the loop from the wire?
Integrated Concepts Derive an expression for the current in a system like that in Figure 23.11, under the following conditions. The resistance between the rails is R, the rails and the moving red are identical in cross section A and have the same resistivity . The distance between the rails is l, and the rod moves at constant speed v perpendicular to the uniform field B. At time zero, the moving red is next to the resistance R.
When the current through a large inductor is interrupted with a switch, an are appears across the open terminals of the switch. Explain.
Using RHR-l, show that the emfs in the sides of the generator loop in Figure 23.23 are in the same sense and thus add.
Why do voltage, current, and power go through zero 120 times per second for 60-Hz AC electricity?
Review. A novel method of storing energy has been proposed. A huge underground superconducting coil, 1.00 kin in diameter, would be fabricated. It would carry a maximum current of 50.0 kA through each winding of a 150-turn Nb3Sn solenoid. (a) If the inductance of this huge coil were 50.0 H. what would be the total energy stored? (b) What would be the compressive force per unit length acting between two adjacent windings 0.250 in apart?
Why is the power dissipated by a closed switch, such as in Figure 21.43, small?
An induction slave heats a pot with a coil carrying an alternating current located beneath the pot (and without a hot surface). Can me stove surface be a conductor? Why won’t a coil carrying a direct current work?