2 - The front and top views of an object are shown below. Freehand sketch the offset section view of the front view. Hatch the full sections view by hand. Indicate the location and the direction of the cutting plane and label the section view. Place the section view below the front view. a) The offset cutting plane should pass through the center of the slot and center of one of the holes. b) The offset cutting plane should pass through the center of the large and small holes. 00

2 - The front and top views of an object are shown below. Freehand sketch the offset section view of the front view. Hatch the full sections view by hand. Indicate the location and the direction of the cutting plane and label the section view. Place the section view below the front view. a) The offset cutting plane should pass through the center of the slot and center of one of the holes. b) The offset cutting plane should pass through the center of the large and small holes. 00

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Give the following: a) Top view b) Front view c) Right side view d) Draw the appropriate cutting plane line Note: No required dimensions, you can just use the photo as the basis of dimensions.
PLS HELP ME FIND THE OBLIQUE SECTION VIEW AND THE OFF SET SECTION VIEW THANK YOU!
Given the top view and right side view, draw the sectional view of the figure. Please include the hatched lines or section lines (you may use softwares such as autocad and solidworks in creating the sectional view)
Give the following: a) Isometric view b) Right side view c) Draw the appropriate cutting plane line if there is... Note: No required dimensions, you can use the photo as the basis of dimensions.
Draw the top view, side view, and front view of the figure below.
Note : Use creao parametric 4.0 , no hand drawing if not have skip ,don't reject Please assist me with the orthographic view and auxiliary view .Draw the necessary and partial views, including auxiliary and sectional views. (can replace by cropped views too).
Please draw the right side view. Don't copy from anywhere else. Please write the dimensions as well.
Hello. Can you draw the OFF SET SECTION VIEW and the OBLIQUE SECTION VIEW of this figure? I don't need a very very good drawing. A sketch would be okay. Just indicate the proper section lines, and center lines. Thank you!
Look at the images for infomation about the question.
Draw a perspective,isometric(with 30 angle), & oblique(with 45 amgle) view of a cube.
For the following figure assume the box as 10 mm and sketch the following view using CREO PARAMETRIC SKETCH , Top view Side view Front view No hand drawing and no other only CREO .
prepare and submit an oblique drawing based on the 2D Multiview object drawing.