25 When the three identical Star connected Coils ae supp lied with410v, 50 Hz , 3-phas supply, the 1-o wattmeter whoseCurent Coil is connected inthe phase R and neutral veads 8kw and the ammeterConnected in R-phase reads 38 Amp. Assuming6.acro SSlin R and pressure coilRYB phaseSequence find:) power factor of the load2) Reactance3) Resis tance4) Reachive powe5) Apperent power

Given, Supply voltage VL=410 V Frequency f=50 Hz 1-phase wattmeter reading R phase PR=8 kW The…

2 when the three identical Star Connected Coils are supplic 4lov, 50H2 , 3-phas Supply, the 1-o current Coil is connected in the phase R and neutral reads 8kw and the ammeter wattmeter whose acro SS lin R and pressure coil Connected in R-phase reads 38 Amp. Assuming RYB Phase Sequence find: ) power factor of the load

2 when the three identical Star Connected Coils are supplic 4lov, 50H2 , 3-phas Supply, the 1-o current Coil is connected in the phase R and neutral reads 8kw and the ammeter wattmeter whose acro SS lin R and pressure coil Connected in R-phase reads 38 Amp. Assuming RYB Phase Sequence find: ) power factor of the load

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.53P

See similar textbooks

Similar questions

When the three identical star-connected coils are supplied with 415 V, 50 Hz, 3- p supply, the 1- p wattmeter whose current coil is connected in line R and pressure coil across the phase R and neutral reads 12 kW and the ammeter connected in R-phase reads 26 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load , (ii) resistance and reactance of the coil (iii) reactive power of 3- p load and (iv) Apparent Power
A single-phase circuit is placed across a 120-Vrms, 60-Hz source, with an ammeter, a voltmeter, and awattmeter connected. The instruments indicate 12 A,120 V, and 800W, respectively. Finda. The power factor.b. The phase angle.c. The impedance.d. The resistance.
A 100KVA, 220V, a star-connected alternator is loaded at full load and at 60% pf lagging.The effective AC resistance per phase is 0.01411Ω. If the synchronous reactance is 4.5times the effect of the armature leakage reactance wherein the later is 0.046 Ω perphase, find(a) the phase voltage that would be generated at the load if the circuit were operating normally(b) What no-load open-circuit phase voltage must be present in order to circulate full-load current in short-circuit state while maintaining the same speed and field current?(c) What is the terminal phase voltage of the alternator when it is under a shorted load condition? Give an explanation in support of your response using just one sentence. The IA phasor should be used as the reference one.
When the three identical star-connected coils are supplied with 435 V, 50 Hz, 3- φ supply, the 1- φ wattmeter whose current coil is connected in line R and pressure coil across the phase R and neutral reads 4 kW and the ammeter connected in R-phase reads 24 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load , (ii) resistance and reactance of the coil (iii) reactive power of 3- φ load and (iv) Apparent Power 1-Power Factor, of the Load? 2- Reactance? 3- Resistance? 4- Reactive Power? 5- Apparent Power? A 405 volts, 3phase AC motor has a power output of 12 HP and operates at a power factor of 0.9 lagging and with an efficiency of 91 %. If the motor is star connected, determine the reading on each of the two wattmeter connected to measure the input.? a? b? Three identical capacitors of 20 micro farad are connected in star across a 435 volts, 50Hz, 3-phase supply. What value of capacitance must be connected in delta to take the same line current and line…
2. A 3Ø, 2000KW, 480V ∆-connected alternator is short-circuited and is operated at ratedspeed to produce rated current at 4A excitation. With the short-circuit remove andwith the excitation adjusted to 5A, the voltage between stator terminal is 330V. Theeffective resistance between terminal as measured with dc is 2Ω. Determine the %V.R.of the alternator at half-load and pf of 0.8 leading without changing any given values.
An industrial load of200KW has a powerfactor of 0.5 lagging. Agroup of synchronousmotors operating at apower factor of 0.8leading is installed andthe over-all power factorimproves to 0.75 lagging.Determine the KVArating of the synchronousmotors installed.Answer = 130.2354 KVA
A 25 kVA, 240 V single phase source supply the rated power at the rated voltage to a motor at 0.8 power factor lagging. Find the capacitor bank in order to improve the power factor to 0.9 lagging connected to a motor.a. Calculate the real power, reactive power and current before capacitor bank is connected? b. Calculate the power and reactive power after capacitor bank is connected? c.What is kVA rating of capacitor bank QC?
2. Solve the following problem: A THREE-PHASE PLANT CONSUMES 600 KVA, WITH A VOLTAGE OF 2400 VOLTS AND A POWER FACTOR OF 0.8 BEHIND. a) DETERMINE THE EQUIVALENT DELTA IMPEDANCE OF THE PLANT. b) IF THE PLANT WERE A STAR, CALCULATE THE RESISTANCE, REACTANCE AND THE CORRESPONDING PASSIVE ELEMENT.
An impedance (inductive) ZL = (11.5 + j10) ohms is connected in parallel with an impedance (capacitive) ZC = (8 – j20) ohms. Calculate (a) the conductance and susceptance of each branch; (b) the total conductance, susceptance, andadmittance of the circuit; (c) the current in each branch, and the total current and power factor, if the impressed emf is 120 volts. draw the circuit diagram
Consider the microgrid of Figure 3.66. A three-phase transformer, T1, israted at 500 kVA, 220 VY grounded/440 V delta, a transformerwith a reactance of 3.5%.Themicrogridis supplied from anAC bus of a PV generating station.The DC bus rated at 540 V.The distributionlineis 10mileslong and has a series impedance of 0.1 + j1.0 Ω per mile and local load of 100 kVA at 440 V. The microgrid is connected to the local power grid using a three-phase transformer T2, rated at 440 V Y grounded/13.2 kV delta,500 kVA with a reactance of 8%. Compute the per unitimpedance diagram of the microgrid system. Assume the voltage base of 13.2 kV on the local power grid side and kVA base of 500
A resistor R and an impedance coil Z are connected in series. The combination is supplied bya 120-volt, 60 Hz AC source. The voltage across R and Z are 70 volts and 80 volts,respectively. The entire circuit consumes 1,153.12 inductive vars. Determine the following: a. Power factor of the impedance coilb. Total currentc. Impedance of the coild. Resistance of the impedance coil
A 15kVA, 440V, single-phase alternator draws a field current of 5A at rated load. With the same field current, the open circuit emf and short-circuit current are 100V and 80A respectively. The ohmic resistance of the armature between terminals is 0.12 ohm. The ratio of effective to ohmic resistance maybe taken as 1.1. Determine the voltage regulation (in %) when the load is purely resistive.