When the three identical star-connected coils are supplied with 415 V, 50 Hz, 3- p supply, the 1- p wattmeter whose current coil is connected in line R and pressure coil across the phase R and neutral reads 6 kW and the ammeter connected in R-phase reads 20 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load, (ii) resistance and reactance of the coil (ii) reactive power of 3- p load and (iv) Apparent Power

When the three identical star-connected coils are supplied with 415 V, 50 Hz, 3- p supply, the 1- p wattmeter whose current coil is connected in line R and pressure coil across the phase R and neutral reads 6 kW and the ammeter connected in R-phase reads 20 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load, (ii) resistance and reactance of the coil (ii) reactive power of 3- p load and (iv) Apparent Power

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

When the three identical star-connected coils are supplied with 415 V, 50 Hz, 3- p supply, the 1- p wattmeter whose current coil is connected in line R and pressure coil across the phase R and neutral reads 12 kW and the ammeter connected in R-phase reads 26 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load , (ii) resistance and reactance of the coil (iii) reactive power of 3- p load and (iv) Apparent Power
A single-phase circuit is placed across a 120-Vrms, 60-Hz source, with an ammeter, a voltmeter, and awattmeter connected. The instruments indicate 12 A,120 V, and 800W, respectively. Finda. The power factor.b. The phase angle.c. The impedance.d. The resistance.
When the three identical star-connected coils are supplied with 435 V, 50 Hz, 3- φ supply, the 1- φ wattmeter whose current coil is connected in line R and pressure coil across the phase R and neutral reads 4 kW and the ammeter connected in R-phase reads 24 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load , (ii) resistance and reactance of the coil (iii) reactive power of 3- φ load and (iv) Apparent Power 1-Power Factor, of the Load? 2- Reactance? 3- Resistance? 4- Reactive Power? 5- Apparent Power? A 405 volts, 3phase AC motor has a power output of 12 HP and operates at a power factor of 0.9 lagging and with an efficiency of 91 %. If the motor is star connected, determine the reading on each of the two wattmeter connected to measure the input.? a? b? Three identical capacitors of 20 micro farad are connected in star across a 435 volts, 50Hz, 3-phase supply. What value of capacitance must be connected in delta to take the same line current and line…
A 100KVA, 220V, a star-connected alternator is loaded at full load and at 60% pf lagging.The effective AC resistance per phase is 0.01411Ω. If the synchronous reactance is 4.5times the effect of the armature leakage reactance wherein the later is 0.046 Ω perphase, find(a) the phase voltage that would be generated at the load if the circuit were operating normally(b) What no-load open-circuit phase voltage must be present in order to circulate full-load current in short-circuit state while maintaining the same speed and field current?(c) What is the terminal phase voltage of the alternator when it is under a shorted load condition? Give an explanation in support of your response using just one sentence. The IA phasor should be used as the reference one.
A three-phase system includes a 346.4 V line-to-line supplying a three-phase motor rated 15KVA 0.8pf lag plus additional balanced constant impedance loads. The single-phase representation of the system is shown below. Assume that sources and loads are Y-connected. 1. What is the RMS value of the line current, I in A? 2. If this set of loads will be supplied through a service transformer. What should the minimum size of the transformer in kVA? 3. What should be the size of three-phase capacitor(that will be added to the load mix) to improve power factor to almost 0.95 lag?
In a balanced star connected system, three coils each having resistance 6Ω and inductance 12.58 mH are connected from a 415V, 50Hz, 3-phase supply. What is the inductive reactance of the coil which is connected between R phase and Neutral?
2. A 3Ø, 2000KW, 480V ∆-connected alternator is short-circuited and is operated at ratedspeed to produce rated current at 4A excitation. With the short-circuit remove andwith the excitation adjusted to 5A, the voltage between stator terminal is 330V. Theeffective resistance between terminal as measured with dc is 2Ω. Determine the %V.R.of the alternator at half-load and pf of 0.8 leading without changing any given values.
A Δ-connected, 60−Hz, balanced, 3ϕ, positive-sequence voltage source is connected to a Δ-connected, symmetric 3ϕ load via a non-ideal transmission line. The line-line voltage magnitude of the source is 480VRMS. The series impedance of each phase of the transmission line is 0.1+j1.5Ω. The impedance of each leg of the load is 3+j6Ω. a. What is the total, 3ϕ complex power consumed by the load. b. What are the total active power losses (all three phases) in the transmission line?
115 volts 60 cycle source is connected to series CKT, consisting of a fixed resistor and an impedance coil if the resistors and coil voltage drops are 55.4 and 80 volts, respectively under which conditions the current is 1.69 AMP, calculate the resistance and inductance of the impedance coil. solve for power factor solve for L coil Solve for R coil
Two star connected induction motor are fed by 4160 V, line to line, 3-phase 60 Hzmotor control 20 ft away. Motor A drives a 600 HP compressor. The efficiency of themotor is 90 %, and its power factor is 0.5. Instruments of motor B indicate 1730 kW,277 Amps (a) Determine the capacity in microfarads of a wye connected capacitor bankthat is required to correct the power factor of the load to 0.966. (b) If asynchronous motor is installed in place of motor B and used instead of the capacitorbank to achieve tha same overall power factor (0.966), what must its power factorbe?
An electrical motor is supplied from a three-phase ,50 Hz, 410 V system on-board a LNG carrier .When connected in star , it takes a line current of 35 A at a power factor of 0.66 leading. The LNG carrier arrives at port and the motor is subsequently used for powering a container crane It is now connected in delta and is supplied on-shore .Determine for this motor when it takes 64 A at 310 V, from the on-shore supply: 2.1 The power factor of the motor 2.2 the frequency of the supply The motor is returned back to its initial supply and now connected with a new motor in parallel . The new motor is connected in delta and it takes 48.216 kVA at a power factor of 0.77597 lagging with a supply of 50 Hz, 410 V system. Determine for this new arrangement : 2.3 The power factor 2.4 Apparent power taken 2.5 True power taken 2.6 Reactive power taken
Design a power factor correction circuit with the value of parallel capacitance needed tocorrect a load of 179 kVAR at 0.85 lagging pf to unity pf. Assume that the load issupplied by a 110-V (rms), 60-Hz line.